Ultrahigh- Q Sr 1+ x Y 2O 4+ x <em/>( x= 0.01&amp;ndash;0.04) microwave dielectric ceramics for temperature-stable millimeter-wave dielectric resonator antennas

Guoqiang He, Yu Jiang, Kaixin Song, Yanjun Liu, Yuan Nie, Wenjie Zhang, Ziqi Zhao, Yinghan He, Xinyue Ma, Xiuli Chen, Xu Li, Huanfu ZhouJournal of Advanced Ceramics 2023 · DOI

Abstract

Microwave dielectric ceramics should be improved to advance mobile communication technologies further. In this study, we prepared Sr<sub>1+<em>x</em></sub>Y<sub>2</sub>O<sub>4+<em>x</em></sub><em> </em>(<em>x </em>= 0–0.04) ceramics with nonstoichiometric Sr<sup>2+ </sup>ratios based on our previously reported SrY<sub>2</sub>O<sub>4</sub> microwave dielectric ceramic, which has a low dielectric constant and an ultrahigh quality factor (<em>Q</em> value). The ceramic exhibited a 33.6% higher <em>Q</em>-by-frequency (<em>Q×f</em>) value (<em>Q </em>~12,500) at <em>x</em> = 0.02 than SrY<sub>2</sub>O<sub>4</sub>. All Sr<sub>1+<em>x</em></sub>Y<sub>2</sub>O<sub>4+<em>x</em></sub><em> </em>(<em>x </em>= 0–0.04) ceramics exhibited pure phase structures, although variations in crystal-plane spacings were observed. The ceramics are mainly composed of Sr-O, Y1-O, and Y2-O octahedra, with the temperature coefficient of the resonant frequency (<em>τ<sub>f</sub></em>) of the ceramic increasing with Y2-O octahedral distortion. The ceramic comprises uniform grains with a homogeneous elemental distribution, clear grain boundaries, and no obvious cavities at <em>x </em>= 0.02. The Sr<sub>1+<em>x</em></sub>Y<sub>2</sub>O<sub>4+<em>x</em></sub><em> </em>(<em>x </em>= 0–0.04) ceramics exhibited good microwave dielectric properties, with optimal performance observed at <em>x</em> = 0.02 (dielectric constant (<em>ε<sub>r</sub></em>) = 15.41, <em>Q</em>×<em>f</em> = 112,375 GHz, and <em>τ<sub>ƒ</sub></em> = −17.44 ppm/℃). The <em>τ<sub>f</sub></em> value was reduced to meet the temperature-stability requirements of 5G/6G communication systems by adding CaTiO<sub>3</sub>, with Sr<sub>1.02</sub>Y<sub>2</sub>O<sub>4.02</sub>+2wt%CaTiO<sub>3</sub> exhibiting <em>ε</em><em><sub>r</sub></em> = 16.14, <em>Q</em>×<em>f</em> = 51,004 GHz, and <em>τ<sub>f</sub> </em>= 0 ppm/℃. A dielectric resonator antenna prepared using Sr<sub>1.02</sub>Y<sub>2</sub>O<sub>4.02</sub>+2wt%CaTiO<sub>3</sub> exhibited a central frequency of 26.6 GHz, with a corresponding gain and efficiency of 3.66 dBi and 83.14%, respectively. Consequently, Sr<sub>1.02</sub>Y<sub>2</sub>O<sub>4.02</sub>-based dielectric resonator antennas are suitable for use in 5G millimeter-wave band (24.5–27.5 GHz) applications.
BibTeX
@article{he2023ultrahigh,
  author = {Guoqiang He and Yu Jiang and Kaixin Song and Yanjun Liu and Yuan Nie and Wenjie Zhang and Ziqi Zhao and Yinghan He and Xinyue Ma and Xiuli Chen and Xu Li and Huanfu Zhou},
  title = {{Ultrahigh- <em>Q</em> Sr <sub>1+ <em>x</em> </sub>Y <sub>2</sub>O <sub>4+ <em>x</em> </sub> <em/>( <em>x</em>= 0.01\&amp;ndash;0.04) microwave dielectric ceramics for temperature-stable millimeter-wave dielectric resonator antennas}},
  journal = {Journal of Advanced Ceramics},
  year = {2023},
  doi = {10.26599/jac.2024.9220828},
}

Loading related content...

Figure