Abstract
Superconducting Quantum Computing (SQC) requires highly precise and stable DC biasing to maintain qubits at their optimal operating points. As quantum processors scale, traditional commercial DC sources become impractical due to their large physical footprint. This paper presents a custom-designed, ultra-precision 12-channel DC source housed in a compact 1U 19-inch rack. The system achieves a noise floor of 3 μVpp and a temperature coefficient of less than 1 ppm/°C. Experimental results demonstrate a total output drift of approximately 40 μV (2.9 ppm) over 48 hours in a standard air-conditioned environment, significantly outperforming commercial alternatives in both density and stability.
Introduction: The Scaling Challenge in Quantum Computing
Superconducting Quantum Computing (SQC) is currently one of the most promising avenues for realizing practical quantum computers. However, operating superconducting qubits requires extremely precise control and acquisition electronics. Specifically, ultra-precision DC sources are needed to provide the bias that keeps qubits at their specific operational points.
As the field moves toward multi-qubit processors (such as the 72-qubit Bristlecone), the use of commercial precision DC sources has become a bottleneck. These commercial units often occupy 3U of rack space for a single channel. Scaling to dozens or hundreds of qubits would require entire rooms of electronics, leading to long signal lines that introduce noise and degrade performance. There is a critical need for high-density, high-precision electronics that can scale alongside the quantum processor.
System Design and Implementation
To address the density and precision requirements, we developed a 12-channel DC source integrated into a standard 1U 19-inch crate. This design provides a channel density 30 times higher than commercial units on the front panel and 100 times higher in terms of total volume.
Technical Architecture
- High-Resolution DACs: The system utilizes the AD5791 20-bit DAC to achieve 2 ppm precision across a -7V to +7V output range.
- Parallel Voltage References: To overcome the "random jump" instabilities inherent in the LM399 voltage reference, we implemented a parallel architecture using three chips for a single reference point. This averaging technique significantly improves the baseline stability for the DACs.
- Passive Thermal Management: High precision usually requires active temperature control, which adds complexity and noise. Instead, we employed a multi-layered passive approach using thermal windshields for references and foamed plastic insulation for the entire PCB. This creates a "soft" thermal environment that buffers the electronics against external room temperature fluctuations.
- Integrated Control: Communication is handled by an "All-in-One" ethernet solution (W7500P with an ARM Cortex-M0 core), ensuring low-noise data transfer over a standard LAN.
Performance and Stability Results
The system was benchmarked using a Keysight 34470A 7.5-digit Digital Multimeter. The output noise floor was measured at a peak-to-peak voltage ($V_{pp}$) of 3 μV, with a standard deviation of 0.497 μV. The temperature coefficient remains below 1 ppm/°C across the full 14V range.
Long-term stability tests conducted over 48 hours in a standard air-conditioned laboratory environment showed a total drift of only 40 μV, which corresponds to approximately 2.9 ppm. This level of stability is essential for long-duration quantum experiments where bias points must remain fixed to avoid qubit decoherence or gate errors.
Conclusion and Future Directions
Our custom 12-channel DC source successfully demonstrates that high-density integration does not have to come at the cost of precision. By utilizing parallelized references and passive thermal management, we achieved performance that exceeds bulky commercial alternatives while occupying a fraction of the space.
Future work will focus on evaluating long-term drift over periods exceeding one year and implementing software-side calibration to improve consistency across all 12 channels. We are also exploring expanding the output range to ±10V and integrating on-board filtering to further lower the noise floor for general-purpose laboratory use.
Summary updated