Tuning the electronic properties of J_eff=1/2 correlated semimetal in epitaxial perovskite SrIrO3

Jian Liu, J.-h. Chu, Claudy Rayan Serrao, Di Yi, J. D. Koralek, Christofer Nelson, Carlos Frontera, Dominik Kriegner, Lukáš Horák, Elke Arenholz, J. Orenstein, Ashvin Vishwanath, X. Martí, R. RamesharXiv 2013 · DOI · arXiv

Abstract

We investigated the electronic properties of epitaxially stabilized perovskite $SrIrO_3$ and demonstrated the effective strain-control on its electronic structure. Comprehensive transport measurements showed that the strong spin-orbit coupling renders a novel semimetallic phase for the $J_{eff}=1/2$ electrons rather than an ordinary correlated metal, elucidating the nontrivial mechanism underlying the dimensionality-controlled metal-insulator transition in iridates. The electron-hole symmetry of this correlated semimetal was found to exhibit drastic variation when subject to bi-axial strain. Under compressive strain, substantial electron-hole asymmetry is observed in contrast to the tensile side, where the electron and hole effective masses are comparable, illustrating the susceptivity of the $J_{eff}=1/2$ to structural distortion. Tensile strain also shrinks the Fermi surface, indicative of an increasing degree of correlation which is consistent with optical measurements. These results pave a pathway to investigate and manipulate the electronic states in spin-orbit-coupled correlated oxides, and lay the foundation for constructing 5d transition metal heterostructures.

Introduction

In the physics of 5d transition metal oxides, iridates serve as a primary platform for studying the interplay between strong Spin-Orbit Coupling (SOC) and electron correlations. Perovskite $SrIrO_3$ is of particular interest as it resides at the boundary of a metal-insulator transition. While its layered relative $Sr_2IrO_4$ is a Mott insulator, $SrIrO_3$ exhibits a semimetallic phase. This study explores how the $J_{eff} = 1/2$ electronic state in $SrIrO_3$ can be manipulated through structural distortions induced by epitaxial strain.

Crystal structure of $SrIrO_3$ and the energy level splitting of the $J_{eff}=1/2$ state under crystal field distortion and spin-orbit coupling.

Methods

High-quality, single-crystal thin films of $SrIrO_3$ (approximately 20 nm thick) were grown using Pulsed Laser Deposition (PLD). To apply varying degrees of strain, the films were deposited on four different perovskite substrates:

  • Compressive Strain: $SrTiO_3$ (STO) and $DyScO_3$ (DSO)
  • Tensile Strain: $GdScO_3$ (GSO) and $NdScO_3$ (NSO)

Structural characterization was performed using high-resolution X-ray diffraction (XRD) and reciprocal space mapping. The electronic properties were evaluated through temperature-dependent resistivity, Hall effect, and magnetoresistance measurements.

Key Results and Discussion

Transport data confirms that $SrIrO_3$ is a correlated semimetal with a low carrier density ($\sim 10^{19} \text{ cm}^{-3}$), roughly 1,000 times lower than typical metals.

Electronic transport characterization: (a) Temperature-dependent resistivity, (b) Hall coefficient with mobility ratio inset, and (c) magnetoresistance vs $B^2$.

Strain-Induced Asymmetry Switch

A critical finding is the dramatic variation in electron-hole symmetry under strain. Under compressive strain (STO substrate), the material shows massive electron-hole asymmetry, with a mobility ratio factor $\beta$ of approximately 14.5%. Conversely, under tensile strain (NSO substrate), this asymmetry nearly vanishes, with $\beta$ dropping to 0.4%, indicating nearly symmetric behavior between electrons and holes.

Tuning Correlation Strength

Strain also acts as a "knob" for tuning electronic correlations. Tensile strain was found to increase the degree of correlation, pushing the material closer to a Mott insulating state. Optical measurements (FTIR) supported this by showing a 50 meV blue-shift in interband transitions under tensile strain, signifying a shrinking Fermi surface.

Conclusion

This research demonstrates that the electronic properties of the $J_{eff} = 1/2$ state in $SrIrO_3$ are highly susceptible to structural distortions. By utilizing epitaxial strain, the electron-hole symmetry and correlation strength can be precisely tuned. These results provide a roadmap for the design of exotic quantum states in 5d transition metal heterostructures.

Summary updated

Abstract

We investigated the electronic properties of epitaxially stabilized perovskite SrIrO3 and demonstrated the effective strain-control on its electronic structure. Comprehensive transport measurements showed that the strong spin-orbit coupling renders a novel semimetallic phase for the J_eff=1/2 electrons rather than an ordinary correlated metal, elucidating the nontrivial mechanism underlying the dimensionality-controlled metal-insulator transition in iridates. The electron-hole symmetry of this correlated semimetal was found to exhibit drastic variation when subject to bi-axial strain. Under compressive strain, substantial electron-hole asymmetry is observed in contrast to the tensile side, where the electron and hole effective masses are comparable, illustrating the susceptivity of the J_eff=1/2 to structural distortion. Tensile strain also shrinks the Fermi surface, indicative of an increasing degree of correlation which is consistent with optical measurements. These results pave a pathway to investigate and manipulate the electronic states in spin-orbit-coupled correlated oxides, and lay the foundation for constructing 5d transition metal heterostructures.
BibTeX
@misc{liu2013tuning,
  author = {Jian Liu and J.-H. Chu and Claudy Rayan Serrao and Di Yi and J. D. Koralek and Christofer Nelson and Carlos Frontera and Dominik Kriegner and Lukáš Horák and Elke Arenholz and J. Orenstein and Ashvin Vishwanath and X. Martí and R. Ramesh},
  title = {{Tuning the electronic properties of J\_eff=1/2 correlated semimetal in epitaxial perovskite SrIrO3}},
  year = {2013},
  eprint = {1305.1732},
  archivePrefix = {arXiv},
  url = {https://arxiv.org/abs/1305.1732},
}
Figure