Transmission Capacity Of D2D Communication Under Cellular Networks

Xianghai Xu, Jun Sun, Shixiang Shao2013 · DOI

Abstract

Device-to-Device (D2D) communication is introduced in cellular systems to make full use of spectrum resources. This paper investigates D2D transmission capacity under both orthogonal and non-orthogonal resource sharing modes within LTE cellular networks. Due to the vulnerability of cellular edge users, non-orthogonal resource reuse can lead to high outage probabilities. We propose a strategy where D2D pairs reuse resources from cellular users near the base station, significantly improving outage performance. Theoretical calculations for outage probability and transmission capacity are validated through simulations, showing close alignment when regional priority is applied.

Introduction

As mobile data demand continues to grow, LTE networks face significant spectrum scarcity. Device-to-Device (D2D) communication offers a solution by allowing nearby devices to communicate directly, bypassing the base station (eNB). This approach reduces power consumption and improves spectral efficiency. However, the primary challenge is managing interference between D2D pairs and standard cellular users (CUs) sharing the same frequency resources.

System model illustrating cellular links, D2D links, and the resulting interference paths.

Methodology

The study employs stochastic geometry to model the network. D2D nodes are distributed according to a stationary Poisson Point Process (PPP). The channel model incorporates both path loss and Rayleigh fading.

A key contribution of this work is the "Priority Radius" strategy. Recognizing that cellular users at the cell edge are highly susceptible to interference, the authors propose limiting D2D resource reuse to cellular users located within a specific distance ($D$) from the base station. Users near the eNB have stronger signals and can better tolerate the additional noise introduced by D2D transmissions.

Transmission Capacity and Results

Transmission capacity is defined as the maximum density of active D2D nodes a system can support while maintaining a target outage probability (where the Signal-to-Interference Ratio falls below a threshold).

D2D transmission capacity as a function of node density, showing the peak capacity before interference becomes dominant.

The results indicate that transmission capacity is not monotonic. As D2D node density increases, total capacity rises until it reaches a "tipping point"—approximately $10^{-3}$ nodes per unit area in the simulated environment. Beyond this point, mutual interference between D2D pairs becomes the limiting factor, causing a sharp decline in overall throughput.

Furthermore, the "Priority Radius" strategy proved effective. Simulations showed that for a fixed D2D density, the outage probability for a cellular user increases significantly with their distance from the base station. By prioritizing resource reuse for users at distances like 20m versus 100m, the network reliability is preserved.

Conclusion

This paper provides a robust mathematical framework for evaluating D2D capacity in LTE networks. By strategically selecting which cellular resources to reuse based on proximity to the base station, operators can maximize D2D throughput without compromising the quality of service for standard cellular users. Future work may extend this model to dynamic mobility scenarios and multi-cell interference environments.

Summary updated

Abstract

Device-to-Device communication is introduced in cellular system to make full use of the spectrum resources. In order to study the D2D transmission capacity when the D2D multiplexing orthogonal and non-orthogonal of the resource sharing mode, the paper studies D2D system interference in LTE cellular networks. Due from cellular edge user vulnerability, D2D reuse non-orthogonal resources will bring a larger outage probability. In this paper, The D2D reuse resources of cellular users near the base station, which bring greater improvements in the outage probability of cellular users, and then calculated the outage probability and the transmission capacity of D2D in cell system. Found through simulation comparison, It is proximate between theoretical calculations and simulation values when multiplexed the preferred regional cellular user resources.
BibTeX
@misc{xu2013transmission,
  author = {Xianghai Xu and Jun Sun and Shixiang Shao},
  title = {{Transmission Capacity Of D2D Communication Under Cellular Networks}},
  year = {2013},
  doi = {10.2991/iccnce.2013.94},
}
Figure