Transient analysis of arm locking controller

Yi Zhang, Mingzhe Li, Tong Wang, Xinyi Zhao, Long Ma, Shaobo Fang, Ming XinarXiv 2023 · DOI · arXiv

TL;DR

This paper reveals that the standard engineering "phase margin" rule is insufficient for stabilizing arm locking controllers in space-based gravitational wave observatories. By performing a rigorous transient analysis, the authors establish new analytical stability criteria and demonstrate that a simple high-gain PI controller can outperform complex high-order designs, suppressing laser phase noise by up to eight orders of magnitude.

What Problem Does This Paper Address?

Space-based gravitational wave (GW) observatories like LISA or Taiji are essentially giant laser interferometers with arms millions of kilometers long. To detect the tiny ripples in spacetime caused by gravitational waves, these missions require lasers with incredibly low phase noise.

One of the primary tools for this is arm locking, where the stable distance between spacecraft (the "arm") is used as a frequency reference to stabilize the laser. However, because the light takes several seconds to travel between spacecraft, there is a significant time delay in the feedback loop. Historically, engineers have designed these controllers using the "phase margin" criterion—a standard rule of thumb. The authors of this paper discovered that this empirical method fails to account for transient peaks that can "re-inject" into the system due to the delay, potentially leading to hidden instabilities that frequency-domain analysis misses.

Methods

The authors moved beyond steady-state frequency analysis to perform a comprehensive transient analysis in the time domain.

  1. Analytical Derivation: They modeled the closed-loop transfer function as a series of transient responses. By using Laplace transforms and mathematical induction, they derived the evolution of transient peaks over time.
  2. Stability Criteria: They proposed two strict analytical conditions for stability:
  3. Criterion I: All poles of the system must have negative real parts (standard stability).
  4. Criterion II: The amplitude response of the open-loop transfer function $|H(j\omega)|$ must never exceed 1 across all frequencies.
  5. Generalization: They applied these criteria to various architectures: Single Arm Locking (SAL), Dual Arm Locking (DAL), Modified-Dual Arm Locking (M-DAL), and Common Arm Locking (CAL).
  6. Simulation: The team used MATLAB/Simulink to verify their analytical results, simulating laser phase noise suppression over $10^5$ seconds.

Datasets

The paper does not use external experimental datasets. Instead, it utilizes simulated laser phase noise based on the technical requirements of the Taiji mission (e.g., arm lengths of 3 Gm and round-trip times of approximately 20 seconds). The performance is evaluated against theoretical noise floors required for GW detection ($10^{-6} \text{ Hz}/\sqrt{\text{Hz}}$).

Key Insights and Ideas

  • The Phase Margin Trap: The most significant "aha moment" is that a controller can look perfectly stable on a Bode plot (good phase margin) but still be "transient instable." If $|H(j\omega)| > 1$ at any frequency, transient peaks will be amplified every time they cycle through the delay loop, eventually breaking the lock.
  • Simplicity Wins: While researchers have proposed increasingly complex high-order controllers to deal with noise, the authors found that a simple Proportional-Integral (PI) controller naturally satisfies their new stability criteria.
  • The "Re-injection" Effect: Because of the arm delay, the system "remembers" its previous errors. If the controller isn't designed to damp these specific periodic peaks, they accumulate rather than dissipate.
  • Literature Check: The authors tested two advanced controllers from previously published high-profile papers and found that both actually failed their new stability criteria, explaining why some experimental setups might have faced unexplained locking issues.

Key Results

  • Noise Suppression: A high-gain PI controller achieved a laser phase noise suppression of 5 orders of magnitude in the science band for single arm locking and over 8 orders of magnitude for dual arm locking.
  • Stability Verification: The proposed criteria (specifically Criterion II) were shown to be the "missing link" in guaranteeing that a controller will maintain its lock over long mission durations (years).
  • M-DAL Performance: For modified-dual arm locking (designed to handle Doppler shifts), they successfully designed a 4th-order high-pass filter that satisfies the new stability rules while maintaining high performance.

Limitations and Future Work

The authors acknowledge that designing filters for Modified-Dual Arm Locking that satisfy both stability criteria simultaneously is "quite challenging." While they provided a working example, a generalized design framework for high-order M-DAL filters remains an open area.

They also suggest that to keep the system robust, it might be better to move secondary tasks—like filtering out Doppler pulling—out-of-loop rather than making the main arm-locking controller more complex. This would allow the primary controller to focus solely on the extreme phase noise suppression required for the science band.

Summary updated

Abstract

Arm locking is one of the key technologies to suppress the laser phase noise in spaced-based gravitational waves observatories. Since arm locking was proposed, phase margin criterion was always used as the fundamental design strategy for the controller development. In this paper, we find that this empirical method from engineering actually cannot guarantee the arm locking stability. Therefore, most of the advanced arm locking controllers reported so far may have instable problems. After comprehensive analysis of the single arm locking's transient responses, strict analytical stability criterions are summarized for the first time. These criterions are then generalized to dual arm locking, modified-dual arm locking and common arm locking, and special considerations for the design of arm locking controllers in different architectures are also discussed. It is found that PI controllers can easily meet our stability criterions in most of the arm locking systems. Using a simple high gain PI controller, it is possible to suppress the laser phase noise by 5 orders of magnitude within the science band. Our stability criterions can also be used in other feedback systems, where several modules with different delays are connected in parallel.
BibTeX
@misc{zhang2023transient,
  author = {Yi Zhang and Mingzhe Li and Tong Wang and Xinyi Zhao and Long Ma and Shaobo Fang and Ming Xin},
  title = {{Transient analysis of arm locking controller}},
  year = {2023},
  eprint = {2309.05588},
  archivePrefix = {arXiv},
  url = {https://arxiv.org/abs/2309.05588},
}
Figure