Abstract
Ad-hoc growth of single-phase-connected distributed energy resources, such as solar generation and electric vehicles, can lead to network unbalance with negative consequences on the quality and efficiency of electricity supply. Case-studies are presented for a substation in Madeira, Portugal and an EV charging facility in Pasadena, California. These case studies show that phase imbalance can happen due to a large amount of distributed generation (DG) and electric vehicle (EV) integration. We conducted stylized load-flow analysis on a radial distribution network using an openDSS-based simulator to understand such negative effects of phase imbalance on neutral and phase conductor losses, and in voltage drop/rise. We evaluate the integration of storage in the distribution network as a possible solution for mitigating effects caused by imbalance. We present control architectures of storage operation for phase balancing. Numerically we show that relatively small-sized storage (compared to unbalance magnitude) can significantly reduce network imbalance. We identify the end node of the feeder as the best location to install storage.
Introduction
Modern power distribution systems are typically designed as three-phase networks. Ideally, electrical loads are balanced across these phases to ensure efficiency. However, the rapid adoption of single-phase distributed energy resources (DERs), such as rooftop solar (Distributed Generation or DG) and electric vehicle (EV) chargers, often occurs in an ad-hoc manner. This leads to significant phase imbalance, which manifests as increased neutral wire currents, energy losses, equipment strain (e.g., transformer overheating), and voltage instability. This paper explores how strategically placed energy storage systems can mitigate these imbalances.
Methodology
The research employs a dual approach:
- Empirical Analysis: Real-world data from two distinct sites—a substation in Madeira, Portugal, and an EV charging facility in Pasadena, California—are analyzed to characterize existing imbalances.
- Simulation: Using OpenDSS, a radial distribution network is modeled to simulate the impact of varying DG and EV penetration levels.
- Storage Architectures: Three control architectures for battery integration are evaluated, ranging from a single battery with a phase selector switch to three batteries with independent phase selection capabilities.
Empirical Case Studies
The study leverages two primary datasets to ground its simulations:
- Madeira Substation: Data from a 250 kVA transformer in Portugal reveals that solar generation during the day can actually improve balance if the network is designed for it, while evening load spikes exacerbate imbalance.
- Caltech ACN-Data: Data from a Pasadena EV facility highlights how uncontrolled charging can create current differentials as high as 280 Amps between phases.
Simulation Results and Insights
Simulations highlight several critical findings regarding network stability and the role of storage:
- The "End-of-Line" Advantage: Storage systems are most effective at balancing phases when placed at the end node of the feeder. Since voltage drops accumulate along the line, end-of-line storage provides maximum leverage for correcting the entire feeder's voltage profile.
- Impact of Small Storage: A battery sized at just one-third of the imbalance magnitude can significantly reduce neutral currents and keep the Voltage Unbalance Factor (VUF) within safe utility limits (typically 1-3%). In one scenario, storage reduced the VUF from 1.30% to 0.87%.
- Voltage Sensitivity: The integration of DG and EVs affects phases differently. As shown in the simulation results, the voltage drop is highly sensitive to the location of the resource (e.g., node N1 vs. N5) and the specific phase it is connected to.
Conclusion
Strategically placed energy storage offers a viable solution for phase balancing in modern distribution grids. While this study demonstrates technical feasibility and identifies optimal placement at the feeder's end, future work must address economic viability, battery degradation under frequent balancing cycles, and the development of autonomous control algorithms for complex multi-battery architectures.
Summary updated