Abstract
This paper proposes a thermal energy harvester of MHD system using a temperature sensitive magnetic fluid (TSMF) which is magnetized by the temperature changes. Heat transport systems using TSMF have already been proposed by several studies, but both heat transport system and thermal energy harvester of MHD system have not been yet developed. The device is a 244 mm length rectangular closed channel of 4 × 5 mm. The operation of this device is carried out by two permanent magnets between the cooling and heating sections. The maximum voltage was about 0.055 mV in this experiment. It was about 80 % of the voltage obtained theoretically. Furthermore, parameters of the thermal characteristics were calculated.
Introduction
As global energy demands increase, harvesting "waste heat" from industrial processes or high-power electronics has become a critical research frontier. One promising technology involves Temperature Sensitive Magnetic Fluids (TSMF)—colloidal solutions containing magnetite nanoparticles whose magnetic properties vary significantly with temperature. While previous research has utilized TSMF to create "thermomagnetic pumps" for passive heat transport, the dual-purpose goal of simultaneously transporting heat and harvesting electricity from that motion remains largely unexplored. This study investigates the integration of a magnetohydrodynamic (MHD) generator into a self-circulating TSMF loop to achieve simultaneous thermal management and energy harvesting.
Experimental Methodology
The experimental apparatus consists of a rectangular closed-loop channel (244 mm total length, 4x5 mm cross-section) milled into an acrylic plate. The system operates on two synergistic physical principles:
- Thermomagnetic Driving Force: When a magnetic field is applied to a TSMF subject to a temperature gradient, the colder fluid (possessing higher magnetization) is pulled toward the magnet more forcefully than the warmer fluid. This creates a pressure differential that drives the fluid around the loop without mechanical intervention.
- MHD Power Generation: According to Faraday’s Law of Induction, as the conductive magnetic fluid flows through a magnetic field, an electromotive force is generated perpendicular to both the flow direction and the magnetic field.
The setup utilized a water-based TSMF (TS-32W) and neodymium magnets providing a magnetic flux density of 370 mT. Thermal gradients were maintained by heating one section (25–75°C) and cooling another (15°C) using aluminum heat sinks. Parallel plate electrodes (3.5 x 15 mm) were positioned in the flow path to capture the generated voltage across a 220 Ω load resistor.
Results and Discussion
The system demonstrated a successful proof-of-concept for simultaneous heat transport and power generation. Once the temperature gradient was established, the thermomagnetic drive initiated a steady flow, reaching an estimated velocity of approximately 30 mm/s.
Electrical Performance
The maximum voltage achieved was approximately 0.055 mV, corresponding to a power output of 14 pW. As shown in the voltage-time data, the output stabilized after approximately 1,200 seconds, coinciding with the stabilization of the temperature gradient across the loop.
The experimental voltage reached roughly 80% of the theoretical value. This discrepancy is likely attributable to the difference between the measured surface temperature of the heat sinks and the actual bulk temperature of the fluid within the channel.
Thermal Characteristics
The device successfully moved 39 W of heat. The heat transfer performance was characterized by a heat transfer coefficient of 4.7 kW/(m²·K) and a Nusselt number of 44, indicating efficient convective transport driven solely by the thermomagnetic effect.
Conclusion
This research successfully demonstrates a passive thermal energy harvester using a TSMF-based MHD system. While the current power output is in the picowatt range, the system proves that waste heat can be simultaneously managed and harvested without moving parts. Future work will focus on scaling the device through optimized channel geometries, higher-sensitivity fluids, and multi-electrode configurations to increase the voltage output for practical sensor applications.
Summary updated