Abstract
Weyl semimetals represent a unique state of matter characterized by three-dimensional Dirac cones that appear in pairs due to the breaking of spatial inversion or time-reversal symmetry. Integrating superconductivity—the quantum condensation of paired electrons—into a Weyl semimetal is a significant frontier in condensed matter physics, potentially leading to the discovery of Majorana fermions and other exotic phenomena. In this study, researchers performed resistive measurements on the Weyl semimetal Tantalum Phosphide (TaP) under extreme pressures up to 100 GPa. The investigation revealed the onset of superconductivity at approximately 70 GPa. Notably, this superconducting state persists even after the pressure is released to ambient levels. Systematic evolutions of resistivity and magnetoresistance are explained by the relative shift between the chemical potential and Weyl points, while Density Functional Theory (DFT) calculations identify a structural phase transition at 70 GPa that hosts the superconducting state.
Introduction
Weyl semimetals (WSMs) have emerged as a focal point of modern physics because they host Weyl fermions—massless quasiparticles arising from unique electronic band crossings. These materials are known for anomalous transport properties, such as giant magnetoresistance and surface Fermi arcs. A primary objective in the field is the realization of a "topological superconductor" by inducing superconductivity in a WSM. Such a state could support Majorana fermions, which are their own antiparticles and hold immense promise for fault-tolerant quantum computing. However, most known WSMs do not naturally exhibit superconductivity. This research explores the use of high pressure to tune the electronic and structural properties of TaP to induce this elusive state.
Experimental and Computational Methods
To investigate the behavior of TaP under extreme conditions, the research team employed a combination of high-pressure experiments and theoretical modeling:
- Sample Preparation: High-quality TaP single crystals were synthesized using the Chemical Vapor Transport (CVT) method.
- High-Pressure Environment: A Diamond Anvil Cell (DAC) was utilized to generate pressures reaching 100 GPa. Resistance was monitored using a standard four-probe method.
- Pressure Calibration: Pressures were calibrated using ruby fluorescence for the lower range and the Raman shift of the diamond anvil for pressures exceeding 70 GPa.
- Theoretical Analysis: The team used Density Functional Theory (DFT) and Ab Initio Random Structure Searching (AIRSS) via the VASP code to predict structural transitions and electronic band evolutions. Transport properties were modeled using BoltzTraP.
Electronic Evolution and the Resistance "Ridge"
Before reaching the superconducting regime, the researchers identified a significant electronic anomaly. At approximately 19.2 GPa, a distinct peak in resistivity was observed. Unlike structural transitions, this "ridge" was determined to be purely electronic in origin. DFT calculations indicated that as pressure increases, the Fermi level (the highest occupied energy state) shifts. At 19.2 GPa, the Fermi level crosses the W2 Weyl nodes, resulting in a minimum in the density of states and a corresponding maximum in resistance. This demonstrates the high sensitivity of Weyl physics to lattice compression.
The Emergence of Superconductivity
As pressure was increased further to approximately 70 GPa, a dramatic change occurred. The material underwent a structural phase transition from its original tetragonal structure ($I4_1md$) to an orthorhombic structure ($Pmmn$). Coincident with this structural collapse, the material entered a superconducting state.
- Transition Temperature ($T_c$): Superconductivity was initially observed with an onset $T_c$ of approximately 2.3 K at 70 GPa.
- Upper Critical Field: The upper critical field $\mu_0 H_{c2}(0)$—the magnetic field strength required to destroy the superconducting state—was measured at approximately 4–5 Tesla.
- Fermi Surface Nesting: Theoretical models suggest that the superconductivity in the new $Pmmn$ phase is driven by Fermi surface nesting, which enhances electron-phonon coupling and facilitates the formation of Cooper pairs.
Persistence at Ambient Pressure
One of the most remarkable findings of this study is that the superconductivity in TaP is "quenchable." When the pressure was fully released from 100 GPa back to ambient conditions, the superconducting state remained. In fact, the $T_c$ increased slightly upon release, reaching approximately 3.25 K. This suggests that the high-pressure $Pmmn$ phase is metastable at room pressure, providing a unique opportunity to study this new phase without the constraints of a diamond anvil cell.
Discussion and Future Outlook
While the discovery of superconductivity in TaP is a major milestone, several questions remain. Due to the cooling limits of the high-pressure apparatus (1.7 K), the full transition to zero resistance was only clearly observable after the sample was moved to a $He^3$ cryostat following pressure release. Furthermore, while DFT calculations strongly support the $Pmmn$ structural transition, direct experimental verification via high-pressure X-ray diffraction (XRD) remains a challenge for future studies.
The most critical remaining question is whether the superconductivity in the $Pmmn$ phase inherits the topological properties of the original Weyl semimetal. If TaP is confirmed to be a topological superconductor, it would represent a breakthrough in the search for Majorana fermions and the development of topological quantum technologies. This work provides a clear roadmap for using pressure as a tuning parameter to discover new superconducting phases in topological materials.
Summary updated