Abstract
Based on the empirical particulate emission model, we studied Particulate Matter (PM) emission of some typical cellular automata VDR model and TT model with slow-to-start rules under periodic condition and open boundary condition. By simulations, it is found that the emission of the slow-to-start rule model reaches the maximum emission at metastable state under periodic boundary condition. Under open boundary condition, the phase diagram to reflect traffic congestion is obtained. The injection probability and removal probability have a great impact on PM emissions. Moreover, the effects of motion status on emissions in the VDR model and TT model are studied under two different boundary conditions. Numerical simulation shows that the PM emission of decelerating traffic flow reaches the maximum in the congestion state under periodic boundary condition.
Introduction
Traffic congestion is a well-known urban nightmare, but its environmental impact is often modeled using oversimplified averages. Traditional models like the Nagel-Schreckenberg (NaSch) model often fail to capture "metastable" phenomena—real-world scenarios where traffic remains high-speed and high-flow until a tiny disturbance triggers a massive, self-sustaining jam. This paper explores the intersection of traffic physics and environmental science, specifically how the "slow-to-start" behavior of drivers—the delay in accelerating after being stopped—influences Particulate Matter (PM) emissions.
Methodology
The researchers utilized Cellular Automata (CA), a discrete computational model where "cells" on a grid are either empty or occupied by a vehicle. They primarily used the VDR (Velocity-Dependent Randomization) model, which incorporates a "slow-to-start" rule: vehicles at a standstill have a higher probability of delayed acceleration compared to vehicles already in motion. To calculate PM, they integrated an empirical formula from Panis et al. (2006) which is highly sensitive to instantaneous velocity and acceleration, making it ideal for capturing the "stop-and-go" nature of congested traffic.
Key Insights: The Metastable Peak
In a closed system, PM emissions don't just climb steadily with density. They reach a sharp maximum at the metastable state ($\rho \approx 0.14$). This is the point where the road is at its highest capacity but is most vulnerable to collapsing into a jam. The "slow-to-start" effect allows for higher flow at these densities, but the resulting instability leads to significant emission spikes before the system enters a full jammed state.
Key Results: The Impact of Motion States
Perhaps the most striking finding is that decelerating vehicles emit the most PM in congested states. While high acceleration is often blamed for emissions, the constant, jerky braking required to navigate a jam creates significant emission spikes. In congested traffic, the PM emission rate for decelerating vehicles was found to be approximately 0.08 g/s, which is orders of magnitude higher than that of uniform-speed vehicles (approx. 0.0008 g/s).
In open systems, the "removal probability" ($\beta$)—how easily cars can leave the road—is a dominant factor. If the exit is restricted, emissions skyrocket even if the entry rate of new cars is relatively low. The authors successfully mapped a phase diagram for open boundary conditions, showing that the system reaches maximum current and high emissions when the injection probability $\alpha > 0.45$ and exit probability $\beta > 0.85$.
Conclusion
The study demonstrates that PM emissions are deeply tied to traffic phases and driver behavior. The identification of the metastable state as a peak emission point and deceleration as a primary pollutant source provides a more nuanced understanding of traffic-related air quality issues. Future work could expand this to multi-lane systems and heterogeneous vehicle fleets, providing even more accurate models for urban environmental planning.
Summary updated