Study of silicon photomultiplier performance in external electric fields

X. Sun, T. Tolba, Guangtao Cao, Peng Lv, Liangjian Wen, A. Odian, F. Vachon, Amal Alamre, J. B. Albert, G. Anton, I. J. Arnquist, I. Badhrees, P. S. Barbeau, D. Beck, V. Belov, Trilochan Bhatta, F. Bourque, J. Brodsky, A. Brown, T. Brunner, A. Burenkov, Liqiang Cao, W. R. Cen, C. Chambers, Serge A. Charlebois, M. Chiu, B. T. Cleveland, Minor J. Coon, M. Côté, A. Craycraft, W. Cree, J. Dalmasson, T. Daniels, L. Darroch, S. J. Daugherty, J. Daughhetee, S. Delaquis, A. Der Mesrobian-Kabakian, R. DeVoe, J. Dilling, Ying Ding, M. J. Dolinski, A. Dragone, J. Echevers, L. Fabris, D. Fairbank, W. M. Fairbank, J. Farine, Soheyla Feyzbakhsh, P. Fierlinger, Réjean Fontaine, D. Fudenberg, G. Gallina, G. Giacomini, R. Gornea, G. Gratta, E. V. Hansen, Devin K. Harris, M. Heffner, E. W. Hoppe, J. Hößl, A. House, P. Hufschmidt, M. Hughes, Y. Ito, A. Iverson, A. Jamil, C. E. Jessiman, M. J. Jewell, X. S. Jiang, A. Karelin, L. J. Kaufman, D. Kodroff, T. Koffas, S. Kravitz, R. Krücken, A. Kuchenkov, K.s. Kumar, Y. Lan, A. C. Larson, D. S. Leonard, Gordon Li, S. Li, Z. Li, C. Licciardi, Y. H. Lin, R. MacLellan, Thilo Michel, M. K. Moe, B. Mong, David C. Moore, K. Murray, J. Newby, Zhe Ning, O. Njoya, F. Nolet, O. Nusair, K. Odgers, M. Oriunno, J. L. OrrellJournal of Instrumentation 2018 · DOI · arXiv

Abstract

In this paper, we report on the performance of silicon photomultiplier (SiPM) light sensors operating in electric field strength up to 30 kV/cm and at a temperature of 149 K, relative to their performance in the absence of an external electric field. The SiPM devices used in this study show stable gain, photon detection efficiency, and rates of correlated pulses, when exposed to external fields, within the estimated uncertainties. No visible damage to the surface of the devices was caused by the exposure.

Introduction

The nEXO experiment is designed to search for neutrinoless double beta decay ($0\nu\beta\beta$) using a 5-tonne liquid xenon (LXe) Time Projection Chamber (TPC). A critical component of this detector is a 4 $m^2$ array of Silicon Photomultipliers (SiPMs) used to detect VUV scintillation light. Due to the high voltages required to drift electrons within the TPC, these SiPMs are exposed to external electric fields reaching approximately 20 kV/cm. This study addresses concerns regarding whether such intense fields could penetrate the device surface, altering the avalanche process, increasing noise, or causing physical damage through surface discharges.

Experimental Methodology

To evaluate SiPM performance under high-field conditions, a specialized cryogenic test facility was established at the Institute of High Energy Physics (IHEP) in Beijing.

Schematic of the cryogenic test station used for SiPM performance evaluation.

Test Environment and Hardware

Liquefied $CF_4$ ($LCF_4$) at 149 K was employed as a proxy for liquid xenon, providing a similar dielectric and thermal environment. The study tested three SiPM models: FBK VUV Low Field, FBK RGB-HD, and Hamamatsu VUV3.

Field Configuration

The SiPMs were mounted on a board placed within a 4.5 mm gap between a high-voltage cathode mesh and a grounded anode. This configuration allowed for the generation of uniform external electric fields up to 30 kV/cm, exceeding the expected operational requirements of nEXO. The researchers tested devices in both parallel and anti-parallel field orientations to check for directional dependencies.

Schematic representation of a SiPM positioned between the anode and cathode, illustrating the external electric field (E) lines.

Data Acquisition and Analysis

Data were collected in two modes: "dark data" to assess intrinsic noise and gain stability, and "illuminated data" using a 465 nm blue LED to measure Photon Detection Efficiency (PDE) and correlated noise (cross-talk and after-pulsing). A Pulse Finding Algorithm (PFA) was developed to discriminate photon signals from noise, while a reference photomultiplier tube (PMT) ensured the stability of the LED light source.

Results and Discussion

The experimental results demonstrate that SiPMs are remarkably resilient to external electric fields.

  • Gain Stability: The relative gain for all tested devices remained constant within approximately 5% across the full field range (0 to 30 kV/cm).
  • Noise Characteristics: Correlated noise rates, including prompt cross-talk and delayed pulses, showed no significant dependence on the external field, with variations remaining within an 8% uncertainty margin.
  • PDE Performance: The PDE for 465 nm light was found to be stable within 5% relative to zero-field measurements.
  • Physical Integrity: Post-exposure inspections using high-magnification microscopy (up to 128x) revealed no signs of surface tracking, discharge damage, or microcell degradation.

The observed stability is attributed to the electrostatic shielding provided by the highly doped silicon top contacts of the SiPMs. These contacts act similarly to a Metal-Oxide-Semiconductor (MOS) capacitor, effectively screening the internal avalanche regions from external field penetration.

Conclusion

This study confirms that SiPMs can operate reliably in the high-voltage environments typical of liquid noble gas TPCs. While the results are encouraging, future investigations should focus on long-term surface charge accumulation and performance at the 175 nm VUV wavelength characteristic of xenon scintillation. Additionally, the dielectric breakdown limits of liquid xenon itself remain an ongoing area of engineering research for the nEXO collaboration.

Summary updated

Abstract

In this paper, we report on the performance of silicon photomultiplier (SiPM) light sensors operating in electric field strength up to 30 kV/cm and at a temperature of 149 K, relative to their performance in the absence of an external electric field. The SiPM devices used in this study show stable gain, photon detection efficiency, and rates of correlated pulses, when exposed to external fields, within the estimated uncertainties. No visible damage to the surface of the devices was caused by the exposure.
BibTeX
@article{sun2018study,
  author = {X. Sun and T. Tolba and Guangtao Cao and Peng Lv and Liangjian Wen and A. Odian and F. Vachon and Amal Alamre and J. B. Albert and G. Anton and I. J. Arnquist and I. Badhrees and P. S. Barbeau and D. Beck and V. Belov and Trilochan Bhatta and F. Bourque and J. Brodsky and A. Brown and T. Brunner and A. Burenkov and Liqiang Cao and W. R. Cen and C. Chambers and Serge A. Charlebois and M. Chiu and B. T. Cleveland and Minor J. Coon and M. Côté and A. Craycraft and W. Cree and J. Dalmasson and T. Daniels and L. Darroch and S. J. Daugherty and J. Daughhetee and S. Delaquis and A. Der Mesrobian-Kabakian and R. DeVoe and J. Dilling and Ying Ding and M. J. Dolinski and A. Dragone and J. Echevers and L. Fabris and D. Fairbank and W. M. Fairbank and J. Farine and Soheyla Feyzbakhsh and P. Fierlinger and Réjean Fontaine and D. Fudenberg and G. Gallina and G. Giacomini and R. Gornea and G. Gratta and E. V. Hansen and Devin K. Harris and M. Heffner and E. W. Hoppe and J. Hößl and A. House and P. Hufschmidt and M. Hughes and Y. Ito and A. Iverson and A. Jamil and C. E. Jessiman and M. J. Jewell and X. S. Jiang and A. Karelin and L. J. Kaufman and D. Kodroff and T. Koffas and S. Kravitz and R. Krücken and A. Kuchenkov and K.S. Kumar and Y. Lan and A. C. Larson and D. S. Leonard and Gordon Li and S. Li and Z. Li and C. Licciardi and Y. H. Lin and R. MacLellan and Thilo Michel and M. K. Moe and B. Mong and David C. Moore and K. Murray and J. Newby and Zhe Ning and O. Njoya and F. Nolet and O. Nusair and K. Odgers and M. Oriunno and J. L. Orrell},
  title = {{Study of silicon photomultiplier performance in external electric fields}},
  journal = {Journal of Instrumentation},
  year = {2018},
  doi = {10.1088/1748-0221/13/09/t09006},
}
Figure