Spin Hall magnetoresistance in Pt/YIG bilayers via varying magnon excitation

Q. B. Liu, Kangkang Meng, Shiqi Zheng, Yong Wu, Jinshui Miao, Xiaofeng Xu, Yong JiangarXiv 2020 · DOI · arXiv

Abstract

Spin Hall magnetoresistance (SMR) and magnon excitation magnetoresistance (MMR) both originate from the spin Hall effect (SHE) and inverse spin Hall effect (ISHE) in nonmagnetic materials and are intrinsically related. However, the influence of magnon excitation on SMR is frequently overlooked due to the typically negligible magnitude of MMR. In this study, we investigate SMR in Pt/Y3Fe5O12 (YIG) bilayers from 5 to 300 K, comparing standard samples with those where the YIG layer has been treated via Ar+-ion milling. We observe that SMR in the treated devices is significantly smaller than in non-treated counterparts. Theoretical simulations attribute this reduction to a decrease in interfacial spin-mixing conductance at the treated Pt/YIG interface, induced by magnon suppression. Our results demonstrate that SMR and MMR are interconnected, and that SMR can be effectively modulated via magnon excitation, providing a novel approach for separating and clarifying the underlying mechanisms of spin transport.

Introduction

In the field of spintronics, heavy metal/ferromagnetic insulator (HM/FMI) bilayers are essential for studying spin-to-charge conversion. Two primary phenomena dominate these systems: Spin Hall Magnetoresistance (SMR) and Magnon Excitation Magnetoresistance (MMR). SMR is traditionally viewed as an interface-driven effect where the resistance of the heavy metal layer depends on whether the spin current generated by the Spin Hall Effect is absorbed or reflected at the FMI interface. Conversely, MMR is a non-local effect involving the diffusion of magnons—quantized spin waves—within the magnetic layer.

While both effects rely on the same fundamental physics, the influence of magnon dynamics on SMR is often ignored because MMR signals are generally much weaker. This research challenges that separation, investigating how the suppression of magnon transport directly impacts the observed SMR magnitude.

Experimental Methodology

To explore the link between magnons and SMR, researchers fabricated epitaxial Yttrium Iron Garnet (YIG) films on GGG substrates using Pulsed Laser Deposition (PLD), followed by the deposition of Platinum (Pt) via magnetron sputtering.

The core of the experiment involved comparing two device architectures:

  1. Untreated Devices: Standard Pt/YIG bilayers.
  2. Treated Devices ($YIG^+$): These devices underwent $Ar^+$ ion milling to etch away the YIG film surrounding the Pt Hall bar.

This etching process creates a physical boundary that restricts the in-plane diffusion of magnons away from the active area under the Pt contact. By creating this "magnon trap," the researchers could observe how limiting magnon transport affects the SMR signal. Measurements were conducted using angular-dependent magnetoresistance (ADMR) across a temperature range of 5 K to 300 K, with varying Pt thicknesses (2–7 nm) to facilitate theoretical fitting.

Results and Discussion

The Impact of Magnon Suppression

The experimental results revealed a clear discrepancy between the two device types. At room temperature, the SMR ratio in the untreated Pt/YIG device was approximately 1.4 times larger than in the treated $YIG^+$ device ($7.814 \times 10^{-4}$ vs. $5.723 \times 10^{-4}$).

This reduction in SMR in the treated device is counter-intuitive if one considers SMR a purely local interface effect. However, by applying spin drift-diffusion theory, the team determined that the suppression of lateral magnon diffusion leads to a local accumulation of magnons. This accumulation increases the magnon chemical potential, which in turn reduces the efficiency of spin absorption at the interface. Consequently, the real part of the spin-mixing conductance ($G_r$)—a measure of how easily spins cross the interface—was found to be five to ten times smaller in the treated devices.

Temperature and Thickness Dependence

The difference in SMR between the treated and untreated samples was highly temperature-dependent. The effect was most pronounced at 300 K and nearly disappeared below 100 K. This trend aligns with the behavior of thermal magnons, which are more active at higher temperatures. As the temperature drops, the magnon population decreases, and the influence of magnon diffusion on the SMR signal wanes.

Furthermore, the study found that SMR increased with YIG thickness. Thicker YIG films provide a larger volume for magnon diffusion, preventing the "bottleneck" effect seen in the treated samples and allowing for a higher spin-mixing conductance.

Conclusion

This research provides definitive evidence that SMR and MMR are not independent phenomena. By demonstrating that SMR can be modulated by controlling magnon transport, the study highlights the importance of the magnetic environment surrounding a spintronic device. The extraction of a high Spin Hall Angle ($\theta_{SH} \approx 0.131$) further emphasizes the efficiency of the Pt/YIG interface. These findings suggest that "magnon engineering"—the strategic manipulation of spin-wave populations—could become a vital tool for designing next-generation sensors and logic devices that rely on precise spin-to-charge conversion.

Summary updated

Abstract

Spin Hall magnetoresistance (SMR) and magnon excitation magnetoresistance (MMR) that all generate via the spin Hall effect and inverse spin Hall effect in a nonmagnetic material are always related to each other. However, the influence of magnon excitation for SMR is often overlooked due to the negligible MMR. Here, we investigate the SMR in Pt/Y3Fe5O12 (YIG) bilayers from 5 to 300K, in which the YIG are treated after Ar+-ion milling. The SMR in the treated device is smaller than in the non-treated. According to theoretical simulation, we attribute this phenomenon to the reduction of the interfacial spin-mixing conductance at the treated Pt/YIG interface induced by the magnon suppression. Our experimental results point out that the SMR and the MMR are inter-connected, and the former could be modulated via magnon excitation. Our findings provide a new approach for separating and clarifying the underlying mechanisms.
BibTeX
@misc{liu2020spin,
  author = {Q. B. Liu and Kangkang Meng and Shiqi Zheng and Yong Wu and Jinshui Miao and Xiaofeng Xu and Yong Jiang},
  title = {{Spin Hall magnetoresistance in Pt/YIG bilayers via varying magnon excitation}},
  year = {2020},
  eprint = {2002.12550},
  archivePrefix = {arXiv},
  url = {https://arxiv.org/abs/2002.12550},
}
Figure