Sound Source Localisation for a High-Speed Train and Its Transfer Path to Interior Noise

Jie Zhang, Xinbiao Xiao, Xiaozhen Sheng, Zhihui LiChinese 2019 · DOI

Abstract

Noise is one of the key issues in the operation of high-speed railways, with sound source localisation and its transfer path as the two major aspects. This study investigates both the exterior and interior sound source distribution of a high-speed train and presents a method for performing the contribution analysis of airborne sound with regard to the interior noise. First, both exterior and interior sound source locations of the high-speed train are identified through in-situ measurements. Second, the sound source contribution for different regions of the train and the relationships between the exterior and interior noises are analysed. Third, a method for conducting the contribution analysis of airborne sound with regard to the interior noise of the high-speed train is described. Lastly, a case study on the sidewall area is carried out, and the contribution of airborne sound to the interior noise of this area is obtained. The results show that, when the high-speed train runs at 310 km/h, dominant exterior sound sources are located in the bogie and pantograph regions, while main interior sound sources are located at the sidewall and roof. The interior noise, the bogie area noise and the sound source at the middle of the coach exhibit very similar rates of increase with increasing train speed. For the selected sidewall area, structure-borne sound dominates in most of the 1/3 octave bands.

Introduction

As high-speed rail networks expand globally, passenger acoustic comfort has become a critical design priority. Mitigating cabin noise is a complex challenge because the interior environment is a "cockpit of sounds" originating from diverse sources—including wheel-rail interactions, aerodynamic turbulence, and pantographs—traveling through both air and structural vibrations. Historically, industry research has often studied exterior and interior noise in isolation. This paper bridges that gap by introducing a novel methodology for joint analysis, specifically quantifying the "transfer contribution" of exterior noise to the cabin interior.

Methodology

The researchers conducted in-situ experiments using an eight-coach high-speed train (HST) operating on a slab track viaduct in China. The study employed a two-pronged measurement approach:

  1. Exterior Mapping: A 78-channel "wheel" microphone array was positioned 7.5 meters from the track. Using moving source beamforming, the team localized noise sources along the entire train as it passed at speeds up to 350 km/h.
Experimental setup featuring a 78-channel microphone array for exterior noise mapping.
  1. Interior Mapping: Inside the coach, a 50-channel spherical microphone array equipped with 12 cameras was used to create 360-degree acoustic maps via spherical harmonics beamforming.
  2. Transfer Path Analysis: To distinguish between airborne and structure-borne noise, the researchers developed a method comparing the train at a standstill versus running. By placing omnidirectional sources inside the cabin at a standstill to measure car-body transmission loss, they could isolate the ratio of sound entering through the air versus sound generated by structural vibrations during operation.

Key Results and Discussion

The study produced a comprehensive "noise map" of the HST at a primary operational speed of 310 km/h.

Exterior noise source distribution of the high-speed train running at 310 km/h (frequency range: 500–5000 Hz).

Exterior and Interior Contributions

  • Exterior Sources: The bogie area was identified as the largest contributor to total exterior sound power (33.5%), followed by the middle area of the coach (24.1%). While the pantograph is an intense source, its smaller surface area limits its total contribution to 6.7%.
  • Interior Sources: The roof (25.0%), floor (18.4%), and sidewalls (~17%) are the primary contributors to the internal sound field. The high roof contribution is largely attributed to exterior air conditioning units.
  • The Vibration Factor: For the sidewall area, structure-borne sound (vibration) was found to dominate most of the 1/3 octave bands. Airborne sound only becomes the primary factor at high frequencies (2000 Hz to 5000 Hz).

Acoustic Weak Points

Acoustic mapping revealed that the interface between windows and sidewalls acts as an acoustic "leak" due to lower transmission loss and specific structural installation characteristics. Furthermore, the study found that interior noise and bogie area noise increase at nearly identical rates as train speed increases, confirming the bogie as the primary driver of cabin noise levels.

Conclusion

This research provides a robust framework for identifying and mitigating noise in high-speed rail. While the methodology successfully isolated transfer paths, the authors note that future work must address the reciprocity assumption—specifically how high-speed airflow might alter transmission properties—and use surface-mounted pressure sensors to better distinguish near-field aerodynamic noise from far-field acoustic sources.

Summary updated

Abstract

Noise is one of the key issues in the operation of high-speed railways, with sound source localisation and its transfer path as the two major aspects. This study investigates both the exterior and interior sound source distribution of a high-speed train and presents a method for performing the contribution analysis of airborne sound with regard to the interior noise. First, both exterior and interior sound source locations of the high-speed train are identified through in-situ measurements. Second, the sound source contribution for different regions of the train and the relationships between the exterior and interior noises are analysed. Third, a method for conducting the contribution analysis of airborne sound with regard to the interior noise of the high-speed train is described. Lastly, a case study on the sidewall area is carried out, and the contribution of airborne sound to the interior noise of this area is obtained. The results show that, when the high-speed train runs at 310 km/h, dominant exterior sound sources are located in the bogie and pantograph regions, while main interior sound sources are located at the sidewall and roof. The interior noise, the bogie area noise and the sound source at the middle of the coach exhibit very similar rates of increase with increasing train speed. For the selected sidewall area, structure-borne sound dominates in most of the 1/3 octave bands.
BibTeX
@inproceedings{zhang2019sound,
  author = {Jie Zhang and Xinbiao Xiao and Xiaozhen Sheng and Zhihui Li},
  title = {{Sound Source Localisation for a High-Speed Train and Its Transfer Path to Interior Noise}},
  booktitle = {Chinese},
  year = {2019},
  doi = {10.1186/s10033-019-0375-1},
}
Figure