Sliding-Mode Control With Multipower Approaching Law for DC-Link Voltage of Z-Source Photovoltaic Inverters

Yan Chen, Tan Rui, Yong Zheng, Zhiyang ZhouIEEE Access 2019 · DOI

Abstract

Z-source photovoltaic inverters feature a unique topology and a special modulation strategy that enables a traditional two-stage system function through a single-stage structure. Therefore, Z-source inverters are expected to gain an extensive application when inputs change significantly. Given the objective of achieving DC-link voltage control based on small-signal model analyses, this study proposes a sliding-mode control method with a multipower approaching law (MPAL) for the DC-link control of inverters. This novel approach can solve the slow convergence rate and serious buffeting of the traditional sliding-mode control. The proposed approach makes the system state reach the sliding surface rapidly. The inherent buffeting of the sliding-mode control is simultaneously weakened and even eliminated in a few cases. The simulation and experimental analyses prove that the proposed sliding-mode control with an MPAL features significant advantages unlike the traditional sliding-mode control and provides a certain practical value.

Introduction

Photovoltaic (PV) power generation is a cornerstone of renewable energy, yet it presents significant engineering challenges due to the inherent variability of solar irradiance and temperature. To manage these fluctuations, Z-source inverters (ZSIs) have emerged as a robust solution. Unlike traditional two-stage systems that require separate DC-DC boost and DC-AC inversion stages, ZSIs utilize a unique impedance network to provide both voltage boost and inversion in a single stage. This integration improves efficiency and reliability.

However, controlling ZSIs is complex. They exhibit non-minimum phase behavior, characterized by "right-half-plane zeros," where an attempt to rapidly increase voltage can cause an initial drop or oscillation. Traditional Proportional-Integral (PI) controllers often fall short in handling these nonlinear dynamics. While Sliding-Mode Control (SMC) offers robustness against such nonlinearities, it is frequently hampered by "buffeting"—high-frequency oscillations known as chattering—and slow convergence when the system state is far from the target.

Figure 3: Overall system architecture of the Z-source photovoltaic inverter, including the PV array, Z-network, and three-phase inverter.

Proposed Methodology: Multipower Approaching Law (MPAL)

To overcome the limitations of standard SMC, this research introduces a specialized control strategy based on a Multipower Approaching Law (MPAL). The core innovation lies in the design of the approaching law, which dictates how the system state moves toward the "sliding surface" (the desired stable state).

Small-Signal Modeling and Indirect Control

The control strategy begins with a small-signal model of the Z-source network. This model maps how the "shoot-through" duty cycle—the period during which inverter legs are shorted to boost voltage—impacts the capacitor and DC-link voltages. Because the DC-link voltage ($v_{dc}$) is a pulsating square wave and difficult to measure directly for control purposes, the authors employ an indirect control method. By regulating the more stable Z-source capacitor voltages ($v_{C1}, v_{C2}$), they can effectively stabilize the output DC-link voltage.

Figure 2: Equivalent circuit of the Z-source network showing the inductors (L1, L2) and capacitors (C1, C2) used for voltage boosting and stabilization.

The MPAL Innovation

Traditional SMC typically uses an Exponential Approaching Law (EAL). The proposed MPAL replaces this with a more sophisticated law comprising four distinct terms:

  1. Fixed-Power Terms: Two terms ($|s|^\alpha$ and $|s|^\beta$) provide consistent drive toward the sliding surface.
  2. Linear Term: A term ($\xi_4s$) ensures steady progress.
  3. Adaptive Power Term: A unique term ($|s|^\gamma$) where the exponent $\gamma$ adapts based on the system's distance from the target.

This multi-segmented approach allows the controller to be aggressive when errors are large, ensuring rapid convergence, and gentle as the system nears the target, which effectively eliminates the steady-state chatter that plagues traditional methods.

Experimental Results and Validation

The effectiveness of the MPAL-SMC was validated through MATLAB/Simulink simulations and Hardware-in-the-Loop (HIL) testing using an RT-LAB real-time simulator.

Convergence and Stability

The MPAL demonstrated a dramatic improvement in convergence speed. In comparative simulations, the system reached the sliding surface in just 0.65 seconds, a nearly 10-fold improvement over the 5.1 seconds required by the traditional EAL method.

Dynamic Response to Irradiance Changes

To simulate sudden changes in solar intensity, the researchers applied step changes to the input voltage (from 300V to 400V). The MPAL-based controller showed superior performance:

  • Overshoot: Reduced from 6% (EAL) to 3.2% (MPAL).
  • Settling Time: Reduced from 100ms (EAL) to a mere 20ms (MPAL).

Experimental HIL tests further confirmed these results, showing a DC-link voltage overshoot of only 1.2% and a settling time under 10ms during reference voltage transitions.

Conclusion

The proposed sliding-mode control with a Multipower Approaching Law offers a significant advancement for Z-source photovoltaic inverters. By combining rapid convergence with the elimination of control buffeting, the MPAL ensures stable and efficient power delivery even under volatile input conditions. Future research will focus on the controller's sensitivity to component aging and its performance within complex microgrid environments.

Summary updated

Abstract

Z-source photovoltaic inverters feature a unique topology and a special modulation strategy that enables a traditional two-stage system function through a single-stage structure. Therefore, Z-source inverters are expected to gain an extensive application when inputs change significantly. Given the objective of achieving DC-link voltage control based on small-signal model analyses, this study proposes a sliding-mode control method with a multipower approaching law (MPAL) for the DC-link control of inverters. This novel approach can solve the slow convergence rate and serious buffeting of the traditional sliding-mode control. The proposed approach makes the system state reach the sliding surface rapidly. The inherent buffeting of the sliding-mode control is simultaneously weakened and even eliminated in a few cases. The simulation and experimental analyses prove that the proposed sliding-mode control with an MPAL features significant advantages unlike the traditional sliding-mode control and provides a certain practical value.
BibTeX
@inproceedings{chen2019sliding,
  author = {Yan Chen and Tan Rui and Yong Zheng and Zhiyang Zhou},
  title = {{Sliding-Mode Control With Multipower Approaching Law for DC-Link Voltage of Z-Source Photovoltaic Inverters}},
  booktitle = {IEEE Access},
  year = {2019},
  doi = {10.1109/access.2019.2941536},
}
Figure