Self-Healing Silver Nanowires and Reduced Graphene Oxide/Polyurethane Composite Film Based on the Diels–Alder Reaction under Infrared Radiation

Yi Wang, Zhimin Zhou, Jiali Chen, Sixing Li, Han Zheng, Jiaxin Lu, Shuyue Wang, Jiahao Zhang, Kaiwen Lin, Ke Wang, Yuehui WangMembranes 2022 · DOI

TL;DR

This paper presents a novel self-healing composite film made from silver nanowires (AgNWs) and reduced graphene oxide (RGO) embedded in a Diels-Alder (DA) polyurethane matrix. This material can effectively repair itself when exposed to infrared (IR) light, demonstrating improved electrical and thermal conductivity, and remarkable self-healing capabilities, making it promising for flexible electronics and smart materials.

What Problem Does This Paper Address?

The development of "smart" materials that can autonomously repair damage is a significant area of research. Self-healing polymers offer the potential to extend material lifespan, improve reliability, and reduce waste. While Diels-Alder (DA) chemistry has been a successful route to intrinsic self-healing polymers due to its reversible nature, these materials often suffer from limitations like poor mechanical properties, low healing efficiency, and a decline in healing capability with repeated cycles. Furthermore, achieving simultaneous improvements in electrical conductivity and self-healing remains a challenge. This paper aims to address these limitations by creating a composite material that leverages the unique properties of AgNWs and RGO to enhance both conductivity and IR-triggered self-healing in a DA-PU matrix.

Methods

The researchers synthesized a hybrid AgNWs-RGO composite using an improved polyol-thermal method. This composite was then incorporated into a thermo-reversible DA-reaction polyurethane (DA-PU) matrix. The DA-PU prepolymer was prepared using a conventional two-step method involving ethylene glycol, MDI, furan-terminated prepolymer (FA), and a crosslinking agent (BMI). The AgNWs-RGO was then dispersed into the DA-PU solution, followed by solvent evaporation and drying to form the composite film.

Characterization techniques included:

  • Scanning Electron Microscopy (SEM): To examine the microstructure and dispersion of AgNWs-RGO within the DA-PU matrix.
  • Raman Spectroscopy: To confirm the reduction of graphene oxide (GO) to reduced graphene oxide (RGO).
  • Differential Scanning Calorimetry (DSC): To study the thermal reversibility of the DA-PU matrix.
  • Four-point probe system: To measure electrical resistivity.
  • Infrared thermal imager: To assess the IR thermal response.
  • Heat flow meter instrument: To measure thermal conductivity.
  • Universal tensile testing machine: To evaluate mechanical properties (tensile strength, Young's modulus, fracture strain) before and after healing.

Self-healing was triggered by exposing a pre-made scratch on the film to infrared light, followed by a thermal treatment at 60°C. Healing efficiency was calculated based on the recovery of tensile strength.

Datasets

Not discussed in the paper. The study relies on experimental synthesis and characterization of the developed composite material.

Key Insights and Ideas

  • Synergistic effect of AgNWs and RGO: Combining AgNWs (primary conductor) and RGO (auxiliary conductor) creates more robust conductive pathways than either material alone, leading to improved electrical and thermal conductivity at lower filler loadings.
  • IR-triggered self-healing: The AgNWs-RGO composite acts as an efficient photothermal agent, converting IR light into heat. This localized heating facilitates the reversible Diels-Alder reaction, enabling the polymer chains to flow and mend cracks.
  • Mechanical property trade-off: While AgNWs-RGO enhances conductivity and self-healing, it generally leads to a decrease in tensile strength and fracture strain, though Young's modulus increases. This highlights a common challenge in composite material design.
  • Optimal AgNWs-RGO content: There appears to be an optimal range (around 25 wt%) for AgNWs-RGO dispersion and performance. Higher concentrations can lead to agglomeration, negatively impacting mechanical properties and fluidity.
  • Multiple self-healing cycles: The composite demonstrates good performance over multiple healing cycles, with higher AgNWs-RGO content contributing to better sustained self-healing efficiency.

Key Results

  • Electrical Conductivity: Resistivity decreased significantly with increasing AgNWs-RGO content. For example, at 25 wt%, resistivity was 0.544 Ω·m, and at 37 wt%, it dropped to 0.005 Ω·m.
  • Thermal Conductivity: Increased from approximately 0.1572 W·m⁻¹·K⁻¹ for pure DA-PU to 0.3501 W·m⁻¹·K⁻¹ at 35 wt% AgNWs-RGO, a 2.2-fold increase.
  • Mechanical Properties: Tensile strength decreased from 14.08 MPa (pure DA-PU) to 6.63 MPa at 35 wt% AgNWs-RGO, but increased to 10.55 MPa at 37 wt%. Young's modulus increased significantly, reaching 246.40 MPa at 37 wt%.
  • IR Thermal Response: The composite films showed a rapid temperature increase under IR light. The maximum temperature reached was 176.2 °C for the 20 wt% AgNWs-RGO composite after 1 minute of irradiation.
  • Self-Healing Efficiency: The IR-triggered self-healing efficiency for a 0.5 mm scratch reached up to 118% (at 25 wt% AgNWs-RGO) after 600 seconds of IR irradiation and subsequent thermal treatment. Multiple healing cycles showed efficiencies of 75-86% after five cycles for the 35 wt% composite.
  • Functional Demonstration: A composite film with 30 wt% AgNWs-RGO was used to form a circuit with an LED, demonstrating that the damaged conductive network could be repaired after scratching and IR irradiation.

Limitations and Future Work

  • Mechanical Property Degradation: A significant limitation is the decrease in tensile strength and fracture strain with increasing AgNWs-RGO content, attributed to stress concentration and poor dispersion at higher loadings.
  • Dispersion Challenges: Achieving uniform dispersion of AgNWs-RGO, especially at higher concentrations, remains a challenge, leading to agglomeration and affecting film quality and properties.
  • Future Work: The authors suggest that further optimization of the AgNWs-RGO synthesis and dispersion methods could lead to improved mechanical properties. Exploring different DA-PU formulations or alternative matrices could also be beneficial. Investigating the long-term durability and performance under various environmental conditions would be valuable for practical applications. The potential for these materials in flexible electronics, wearable sensors, and self-healing coatings is highlighted.

Summary updated

Abstract

The hybrid composite of silver nanowires (AgNWs) and reduced graphene oxide (RGO) was synthesized in situ by an improved polyol-thermal method. The AgNWs-RGO with mass contents of 5-37 wt% was added into the thermo-reversible Diels-Alder reaction polyurethane (DA-PU) matrix with the AgNWs as the main conductor and the RGO as the auxiliary conductor to prepare self-healing composite conductive films. Further, the electrical conductivity, thermal conductivity, mechanical properties, infrared thermal response, and self-healing property of the composite film under infrared light irradiation were studied. The experimental results demonstrate that the AgNWs-RGO endows the composite film with good electrical and thermal conductivity and infrared thermal response ability, while the mechanical properties of the composite film decrease as the AgNWs-RGO mass content increases. The self-healing efficiency of the composite film is higher than that of the pure DA-PU under infrared light irradiation due to the good infrared photothermal response ability of the AgNWs-RGO. When the mass content of AgNWs-RGO in the composite film was 25 wt%, the AgNWs-RGO showed good dispersion in composite films, and the resistivity, thermal conductivity, and tensile strength of the composite film were 0.544 Ω·m, 0.3039 W·m<sup>-1</sup>·K<sup>-1</sup>, and 9.05 MPa, respectively. The infrared photothermal conversion temperature of the composite film is 158.5 °C (3450 lux for 1 min), and the infrared photothermal self-healing efficiency is 118% (3450 lux for 600 s). The AgNWs-RGO also improves the multiple self-healing ability of the composite film. The use of a high mass content of AgNWs-RGO in the composite film is beneficial in obtaining high multiple self-healing efficiencies. The first and the fifth infrared thermal self-healing efficiencies of the composite film with AgNWs-RGO of 35 wt% are 105% and 86%, respectively, and the resistivity of the composite film changes little and still maintains good conductivity.
BibTeX
@inproceedings{wang2022self,
  author = {Yi Wang and Zhimin Zhou and Jiali Chen and Sixing Li and Han Zheng and Jiaxin Lu and Shuyue Wang and Jiahao Zhang and Kaiwen Lin and Ke Wang and Yuehui Wang and Yuehui Wang and Yuehui Wang},
  title = {{Self-Healing Silver Nanowires and Reduced Graphene Oxide/Polyurethane Composite Film Based on the Diels–Alder Reaction under Infrared Radiation}},
  booktitle = {Membranes},
  year = {2022},
  doi = {10.3390/membranes12040405},
}
Figure