Self-Contained High-SNR Underwater Acoustic Signal Acquisition Node and Synchronization Sampling Method for Multiple Distributed Nodes

Jiajia Jiang, Han Liu, Fajie Duan, Xianquan Wang, Xiao Fu, Chunyue Li, Zhongbo Sun, Xinyuan DongSensors 2019 · OpenReview

TL;DR

This paper introduces a novel, self-contained underwater acoustic signal acquisition (UASA) node designed for high signal-to-noise ratio (SNR) and long-term operation. It also presents a Master-Slave Dual Phase-Locked Loop (MSDPLL) method to achieve highly accurate synchronization sampling among multiple distributed UASA nodes, crucial for applications like underwater localization.

What Problem Does This Paper Address?

Underwater acoustic signal acquisition is vital for various applications, including marine noise monitoring, animal observation, and target localization. However, existing systems face challenges: single nodes often lack sufficient SNR and long-term data storage capabilities, while distributed systems struggle with precise synchronization, which is critical for accurate time-difference-of-arrival (TDOA) based localization. Traditional synchronization methods like NTP and PTP are not ideal for underwater environments, and PPS signals from GPS are difficult to receive underwater. This paper aims to bridge this gap by developing a robust UASA node and an effective synchronization method for distributed underwater sensor networks.

Methods

The researchers designed a UASA node with two main components: a surface unit and an underwater unit. The surface unit includes a satellite receiver for PPS signals, a main phase-locked loop (MPLL) for generating sampling signals, a hard disk drive (HDD) for large-capacity storage, and solar cells for continuous power. The underwater unit houses a low-noise signal conditioning circuit, an analog-to-digital converter (ADC), and a microprocessor for data acquisition and local storage.

A key innovation is the Master-Slave Dual Phase-Locked Loop (MSDPLL) synchronization method. This approach utilizes a master phase-locked loop (MPLL) to lock onto the satellite-received PPS signal and generate a sampling signal. A slave phase-locked loop (SPLL) then synchronizes the ADC's data-ready (DRDY) signal to this sampling signal. This dual-loop system aims to mitigate cumulative errors that arise from independent local clocks in traditional synchronization methods, thereby improving accuracy.

For data storage, a flexible scheme is implemented, allowing for local storage on SD cards (up to 2 TB) and data upload to an HDD. The system also incorporates a "Ping-Pong cache" to manage data acquisition and storage efficiently on the microprocessor.

Datasets

Not discussed in the paper. The experiments rely on generated signals and measurements from the developed hardware.

Key Insights and Ideas

  • Integrated High-SNR Node: Combining a low-noise signal conditioning circuit with a self-contained acquisition system and floating platform significantly improves the performance of individual UASA nodes.
  • MSDPLL for Underwater Synchronization: The MSDPLL method offers a novel solution to the critical challenge of achieving high-accuracy time synchronization in distributed underwater acoustic sensor networks, overcoming limitations of traditional methods.
  • Flexible Data Storage: The dual-mode storage (SD card and HDD) with intelligent switching addresses the need for both immediate local storage and long-term data archiving, crucial for continuous monitoring.
  • Importance of Preamplifier Design: The paper highlights that the preamplifier's noise performance is paramount in determining the overall SNR of the signal conditioning circuit, leading to the selection of a low-noise operational amplifier and JFETs for impedance matching.

Key Results

  • Acquisition Performance: The UASA node exhibits a pass-band of 2 Hz to 20 kHz, with a signal-to-noise ratio (SNR) of 106.2 dB.
  • Data Storage Reliability: Both local storage on SD cards and data upload to HDD achieved a bit error rate of 0 in tests.
  • Synchronization Accuracy:
    • Synchronization error between two satellite receivers: 50 ns.
  • Synchronization error between PPS and sampling signal (MPLL): 66.51 ns (average).
  • Synchronization error between sampling signal and DRDY signal (SPLL): 70.05 ns (average).
  • Overall synchronization sampling error between two UASA nodes: 115.04 ns (average).
  • Underwater Positioning: In a field experiment with two UASA nodes, the positioning error for a target within 100 m was 0.78 m, with a standard deviation of 0.3857 m, validating the system's effectiveness.

Limitations and Future Work

  • Limited Underwater PPS Reception: The paper acknowledges the difficulty of receiving PPS signals underwater, which is a fundamental limitation for the synchronization method. While the satellite receiver is on the surface, the underwater unit relies on the surface unit's signal.
  • Synchronization Error: While the MSDPLL significantly improves synchronization accuracy, the resulting error (around 115 ns) might still be a limiting factor for extremely high-precision localization tasks.
  • Future Work: The authors suggest that the developed UASA node and synchronization method are well-suited for various underwater applications, including acoustic communication, noise monitoring, marine animal observation, antisubmarine operations, and underwater target localization. Further exploration and deployment in these diverse scenarios would be a natural next step.

Summary updated

Abstract

Aiming at the application demand in underwater noise monitoring, observation of marine animal, antisubmarine and underwater target localization, a high-SNR underwater acoustic signal acquisition (UASA) node that combines a self-contained acquisition system and floating platform is designed to improve the acquisition performance of a single UASA node, and a high-accuracy synchronization sampling method among multiple distributed UASA nodes based on master-slave dual phase-locked loops (MSDPLL) is proposed to improve the synchronization sampling accuracy. According to the equivalent model of hydrophone and application requirements, low noise signal conditioning circuit and large-capacity data storage modules are designed. Based on the long-term monitoring requirements for underwater acoustic signal and distributed positioning requirements for underwater targets, the structure of a single UASA node is designed and MSDPLL is developed for high-accuracy synchronization sampling among multiple UASA nodes. Related experimental results verified the performance of the UASA node and the synchronization sampling method.
BibTeX
@inproceedings{jiang2019self,
  author = {Jiajia Jiang and Han Liu and Fajie Duan and Xianquan Wang and Xiao Fu and Chunyue Li and Zhongbo Sun and Xinyuan Dong},
  title = {{Self-Contained High-SNR Underwater Acoustic Signal Acquisition Node and Synchronization Sampling Method for Multiple Distributed Nodes}},
  booktitle = {Sensors},
  year = {2019},
  url = {https://openreview.net/forum?id=PZi13RgriG},
}
Figure