Abstract
There are many reasons for the high water temperature of the engine, such as cooling fan not working, fan control module circuit failure, insufficient cooling medium and PCM failure. Primarily based on the analysis of the engine failure in this paper, the reasons for the failures were found out, and the fault diagnosis and maintenance method for high water temperature of the engine was checked with the adoption of real vehicle testing.
Introduction
Engine overheating is a critical failure that can lead to reduced power performance or catastrophic engine damage. While mechanical causes—like a broken water pump or a stuck thermostat—are well-understood, modern vehicles rely on a complex web of electronic control modules to manage cooling. This paper addresses the "ghost in the machine": a scenario where the mechanical components are functional and the Powertrain Control Module (PCM) is sending the correct commands, yet the cooling fan remains stationary. Diagnosing faults originating from software corruption or inter-module communication failures presents a significant challenge compared to simple hardware breakage.
Methodology
The study employs a systematic "step-by-step" elimination method combined with real-vehicle testing on a 2013 Ford Focus (1.6MT). The diagnostic process involved initial triage using the Integrated Diagnostic System (IDS) to check for fault codes and monitoring real-time data streams. Hardware substitution was performed by replacing the cooling fan and the PCM with known-good units to rule out localized hardware failure.
As part of the circuit analysis, technicians mapped the wiring from the fan module to the PCM, checking for physical continuity and contact quality. The circuit diagram above illustrates the critical connections between the cooling fan motor (1E203) and the electronic control module that were scrutinized during the investigation.
Results and Discussion
The investigation revealed that while the PCM was correctly issuing fan operation instructions, the necessary pulse instructions were not being processed correctly at the module level. A breakthrough occurred when an unrelated issue with the tire pressure monitoring system suggested a broader electronic failure within the Body Control Module (BCM).
Waveform analysis using a Vehicle Measurement Module (VMM) oscilloscope was used to compare the pulse-width modulation (PWM) signals of the faulty vehicle against a healthy "control" vehicle.
As seen in the waveform analysis, a healthy fan requires specific PWM duty cycles—approximately 7.84% for standby and 9.02% for starting—to trigger operation. In the faulty vehicle, these signals were corrupted due to a BCM damaged by a previous firmware upgrade. Installing the "faulty" BCM into a healthy car successfully reproduced the fan failure, while a new BCM resolved the overheating issue in the original vehicle.
Conclusion
The high water temperature was traced to an electronic fan failure caused by a faulty BCM, highlighting that software integrity is as vital as mechanical reliability in modern automotive engineering. While this case study provides a robust framework for troubleshooting via waveform analysis and module swapping, it is limited to a specific vehicle model. Future research should explore advanced onboard diagnostics (OBD) capable of self-verifying control module programming integrity to streamline the detection of software-based failures.
Summary updated