Abstract
According to the results of the early theory research of concrete expanded-plates pile and the simulation analysis, this paper discusses the influence of moisture content of fine silty sand for failure behavior and compressive bearing capacity. It puts forward a tentative plan for further research on the influence of moisture content in fine silty sand to improve the calculation theory of concrete expanded-plates piles under vertical pressure and address shortcomings in relevant theoretical research regarding the characteristics of fine silty sand.
Introduction
Concrete expanded-plates (MEEP) piles represent a significant advancement in geotechnical engineering, utilizing "plates" or branches to enhance bearing capacity and minimize settlement. Historically, theoretical models for MEEP piles have focused on cohesive soils like clay. However, in regions such as the Yangtze River basin, fine silty sand is the dominant soil type. Unlike clay, the mechanical properties of sand are highly sensitive to moisture. This research investigates how varying moisture levels in fine silty sand affect the structural integrity and bearing capacity of MEEP piles, a critical factor often overlooked in current engineering models.
Theoretical Framework and Moisture Sensitivity
The bearing capacity of a MEEP pile is determined by several components, notably the force at the plate end ($F_3$). This force is heavily dependent on the soil's cohesion force ($c$) and internal friction angle ($\Phi$).
Experimental data indicates that as moisture content increases from 0% to 25%, both $c$ and $\Phi$ decrease. Notably, the cohesion force exhibits a "two-segment" relationship with moisture content, where strength drops more precipitously after reaching a critical moisture threshold.
Comparative Performance: Sand vs. Clay
To understand the practical implications of these soil characteristics, preliminary simulations using ANSYS finite element analysis were conducted. The study compared the performance of MEEP piles in silty clay versus fine silty sand at a constant 25% moisture level.
The results demonstrate a stark contrast in stability. Under identical vertical loads, piles embedded in fine silty sand exhibited significantly greater displacement compared to those in silty clay. This suggests that the bearing capacity in wet sandy environments is lower, and designs optimized for clay may not provide adequate safety margins in sand.
Key Findings and Discussion
- Moisture Sensitivity: Cohesion force in silty sand is more sensitive to moisture changes than the internal friction angle.
- Frictional Resistance: Site-specific data shows that side frictional resistance in sand layers can be significantly higher (up to 70 kPa) than in clay layers (as low as 21 kPa), creating high-stress zones at soil transitions.
- Model Refinement: By integrating moisture-dependent variables directly into the $F_3$ plate-bearing formula, engineers can develop more accurate, dynamic calculation models for sandy environments.
Conclusion and Future Work
While this study provides a pathway for refining MEEP pile design, several challenges remain. Finite element models must be improved to better capture the non-linear interaction between pile and soil. Furthermore, future research should address "size effects" in small-scale testing and investigate the impact of moisture on uplift (tension) bearing capacity. Ensuring uniform moisture content in experimental setups also remains a priority for validating these theoretical advancements.
Summary updated