Abstract
The advancement of new energy power generation technology has led to practical applications in various regions. Microgrid systems composed of renewable energy can enhance grid reliability and power quality. However, the external power output of these stations varies significantly during generation. This research focuses on analyzing the characteristics of photovoltaic (PV) and wind power and their subsequent influence on the power system's load peaks and troughs. By questioning traditional wind-light complementary theories, this paper analyzes how various combinations of new energy access impact system stability.
Introduction
Integrating renewable energy into the power grid is not merely about increasing "green" capacity; it fundamentally alters the daily demand curve. As nations transition toward sustainable energy, the inherent variability of "new energy" sources like wind and solar presents significant challenges for grid operators. Ideally, renewable generation would align with peak demand. However, because these sources are dictated by natural cycles—such as solar irradiance and wind patterns—their output often diverges from human consumption patterns.
This study investigates how different levels and timings of renewable energy access affect the "peaks and troughs" of the load curve. Misalignment can increase grid volatility, forcing traditional thermal power plants to ramp up or down beyond their optimal design parameters, potentially leading to economic inefficiency or system instability.
Methodology and Modeling
The research utilizes mathematical modeling and simulation to characterize the behavior of PV and wind power systems.
Photovoltaic Modeling
The authors employ a standard diode equation and equivalent circuit models to describe the electrical behavior of solar cells. This model accounts for how light intensity and temperature fluctuations affect output.
The simulation results, as shown in the characteristic curves, demonstrate how environmental variables shift the maximum power point (MPP) of the array.
Wind Power Modeling
Wind turbine performance is simulated using the fundamental power equation $P = \frac{1}{2} \rho A v^3$, incorporating the power coefficient ($C_p$) and tip speed ratio ($\lambda$). The model respects the Betz limit, acknowledging the theoretical maximum efficiency of 59.3%.
Scenario Simulation
The core analysis involves overlaying renewable generation curves onto standard load profiles to identify three distinct "peak effects":
- Positive Peak Effect: Renewable generation coincides with high demand periods, reducing the burden on traditional plants.
- Negative Peak Effect (Peak Inverse Effect): Renewables generate during low demand periods, deepening the "trough."
- Overload Peak Effect: Excessive renewable output during peaks pushes traditional plants below their stable minimum operating thresholds.
Key Insights: The Peak Inverse Effect
A critical finding is the "Peak Inverse Effect." When wind or solar power floods the grid during a low-demand trough, traditional fossil fuel plants must drastically reduce output. If these plants reach their technical lower limits, the security and frequency stability of the entire system are jeopardized.
Furthermore, the study challenges the common assumption of "wind-light complementarity"—the idea that wind and solar naturally balance each other (e.g., wind peaking at night). Field data suggests that in many regions, wind resources can peak during the day, meaning they may exacerbate solar peaks rather than fill the gaps. This shift from scheduled "artificial force" generation to weather-dependent "natural force" generation requires a fundamental reassessment of spinning reserves.
Results and Conclusion
The simulations yielded the following key results:
- Positive Impact: Alignment with peaks successfully reduces the peak-to-trough difference, saving fuel and decreasing required reserve capacity.
- Negative Impact: In "peak inverse" scenarios, the difference between peak and trough increased, forcing traditional plants to operate at absolute minimum capacity and reducing grid flexibility.
- Overload Risk: Excessive access can force thermal generation so low that safe system operation is compromised.
In conclusion, adding renewable energy is a complex timing challenge. Without detailed analysis of the regional "composite structure" of wind and solar resources, increased green energy access could inadvertently lead to a less stable power grid. Future work should incorporate energy storage solutions and more granular, real-world load data to refine these stability models.
Summary updated