Abstract
In the premise of meeting kinematics, this research analyzes and optimizes the trafficability of long semi-trailers on narrow roads with obstacles. By adjusting and designing wheelspan and wheelbase based on geometric constraints, the authors propose a steering scheme that minimizes sweep width. Experimental results and simulations verify the feasibility of the proposed scheme.
Introduction: The "Long-Haul Headache"
In the logistics industry, increasing the length of semi-trailers directly correlates with higher transport efficiency and lower operational costs. However, physical constraints impose a significant challenge: as a trailer's length increases, its minimum turning radius grows, leading to a larger "sweep width"—the total lateral area the vehicle occupies during a maneuver.
On narrow roads with obstacles on both sides, an excessive sweep width can make passage impossible. The authors address the challenge of designing a steering scheme that allows extra-long semi-trailers to meet strict "limit steering" requirements, ensuring they can navigate specific turning diameters within constrained corridors while maintaining mechanical feasibility.
Methodology and Geometric Modeling
The researchers developed a mathematical model based on the Ackerman Steering Principle, which ensures that all wheels trace paths intersecting at a single instantaneous center to prevent tire scrubbing. To optimize the vehicle's path, the authors defined several key dimensional parameters (see Figure I) and derived trigonometric formulas to calculate the minimum track and wheelbase required to prevent mechanical interference.
The mathematical models were implemented in MATLAB Simulink using a traversal calculation method. To verify the results, the researchers used CAD to generate one-to-one ratio representations of the vehicle's swept path, ensuring the theoretical calculations matched physical reality.
Key Insights and Results
The study identifies the "included angle" between the tractor and the semi-trailer as the most critical variable for maneuverability. For a standard 45m turning diameter, this angle must reach at least 29.66 degrees to maintain a sweep width under 8 meters.
The simulation results confirmed that the proposed steering scheme successfully met all project-specific constraints:
- 35m Turning Diameter: Achieved a sweep width of 9.623m (Target: < 10m).
- 40m Turning Diameter: Achieved a sweep width of 8.788m (Target: < 9m).
- 45m Turning Diameter: Achieved a sweep width of 7.995m (Target: < 8m).
These results were consistent across different optimization priorities (prioritizing either minimum wheelbase or minimum wheelspan), proving the robustness of the geometric optimization in "squeezing" the trailer's path into the required corridor.
Conclusion and Future Directions
This research provides a feasible geometric scheme for optimizing the steering of long semi-trailers. By precisely calculating wheelbase and wheelspan, designers can significantly improve the "passability" of oversized vehicles on narrow roads.
While the current model focuses on kinematics, future research should incorporate dynamic factors such as tire slip, load shifting, and varying road friction coefficients. Additionally, integrating these calculations into automated driver-assist systems could further enhance the safety and efficiency of long-haul logistics.
Summary updated