Abstract
Aiming at the strength problem of amphibious landing on water, the pressure distribution of ship bottom is studied. RANS multi-phase flow method is used to solve the coupling problem of gas, liquid and solid in the process of amphibious landing on the water surface. Overlapping grid technology is used to simulate the landing under different initial horizontal velocity and vertical velocity. The influence of initial conditions on the motion response of amphibious is analyzed, and the variation law of pressure on each section of ship bottom with time is obtained. This paper analyzes the variation of pressure with time and position, and provides technical reference for the design and application of water loads in the development of amphibious.
Introduction
Landing an amphibious aircraft on water is a violent fluid-structure interaction (FSI) event. Unlike a runway landing, water provides a dynamic, yielding, yet high-pressure surface that can exert massive impact loads on the hull. If these loads aren't accurately predicted, the aircraft risks structural failure. The challenge lies in the complexity of the physics: a solid body moving through two phases (air and water) simultaneously. Traditional theoretical analysis is often too simplified, and physical model testing is both expensive and difficult to instrument for high-resolution pressure mapping across the entire hull. This research utilizes high-fidelity Computational Fluid Dynamics (CFD) to provide a technical reference for water load design.
Methodology
The researchers employed a multi-pronged CFD approach to simulate the landing process. The Reynolds-Averaged Navier-Stokes (RANS) equations were used to model incompressible viscous flow, capturing mean flow behavior in turbulent environments. To track the free surface—the interface between air and water—the Volume of Fluid (VOF) method was implemented. The SST k-ω turbulence model was selected for its accuracy in predicting flow separation and boundary layer behavior near the hull surface.
A critical component of the simulation is the use of Overlapping (Overset) Grid Technology. Instead of a single static mesh, a moving mesh around the aircraft slides through a background mesh of the water/air domain. This allows the aircraft to pitch, heave, and move horizontally without distorting the underlying grid cells. The Dynamic Fluid Body Interaction (DFBI) module allowed for three degrees of freedom: longitudinal displacement, vertical displacement, and pitch rotation.
The study utilized a scaled physical model of an amphibious aircraft (mass: 49.8 kg). Seven distinct conditions were tested by varying horizontal speeds (14.0 m/s to 16.6 m/s) and vertical velocities (0.2 m/s to 0.8 m/s).
Key Insights and Results
The simulations revealed several critical aspects of the landing dynamics:
- The "Second Bounce" Risk: The maximum impact load does not always occur at the moment of initial contact. Due to the physics of the landing, the aircraft often bounces, and subsequent impacts can generate higher peak pressures than the first.
- Aerodynamic Lift Buffer: Higher horizontal speeds can actually mitigate hull impact loads. At increased horizontal velocities, the wings generate more aerodynamic lift, which "lightens" the aircraft during the impact phase, reducing the total water load compared to a slower landing at the same vertical sink rate.
- Pressure Distribution Dynamics: The pressure peak is not static. The stagnation point moves rapidly toward the bow and out toward the bilges as the aircraft settles. The bilge area experiences concentrated pressure peaks during the moment of maximum impact.
- Vertical Velocity Correlation: There is a direct, positive correlation between initial vertical velocity ($V_z$) and landing load. Higher $V_z$ leads to a deeper draught and a shorter time to reach peak impact. Higher vertical velocities also cause a more violent bounce, correlating with higher structural stress.
Conclusion and Future Work
This study demonstrates that RANS-based CFD with overset grids is an effective tool for mapping complex pressure distributions on amphibious hulls. However, the current research focuses on a rigid body simulation. In reality, aircraft hulls are elastic; hull plating deforms under pressure, which can cushion peak loads (hydroelasticity). Future research should integrate Finite Element Analysis (FEA) with CFD for a two-way FSI study to account for hull flexibility. Additionally, full-scale validation is necessary to account for Reynolds number scaling effects in production aircraft.
Summary updated