Radiation-Resistant Er3+-Doped Superfluorescent Fiber Sources

Chengxiang Liu, Xu Wu, Jianhui Zhu, Nie He, Zhuoyan Li, Gongshen Zhang, Li Zhang, Shuangchen Ruan2018 · DOI

TL;DR

This paper tackles the critical issue of radiation-induced degradation in Er3+-doped superfluorescent fiber sources (SFSs), crucial components for space-based interferometric fiber optic gyroscopes (IFOGs). By combining spectral trimming with a Gaussian-shaped filter and implementing a feedback control loop for pump power, the researchers achieved unprecedented radiation resistance, with minimal output power loss and wavelength drift even after exposure to over 1000 Gy of gamma radiation.

What Problem Does This Paper Address?

Interferometric fiber optic gyroscopes (IFOGs) are essential for navigation in spacecraft and satellites due to their reliability and stability. A key component of these IFOGs is the Er3+-doped superfluorescent fiber source (SFS), which provides a stable light source. However, space missions expose these SFSs to harsh environments with significant ionizing radiation. This radiation can cause two major problems: radiation-induced attenuation (RIA), leading to a loss of output power, and mean wavelength drift, which directly impacts the accuracy and stability of the IFOG. While previous research has explored methods to mitigate these effects, such as optimizing fiber design and using filters, the performance has not been sufficient for demanding space applications. This paper aims to significantly improve the radiation resistance of SFSs to meet these stringent requirements.

Methods

The researchers employed a two-pronged approach to enhance the radiation resistance of SFSs:

  1. Spectral Trimming with a Gaussian-Shaped Filter: They observed that the SFS spectrum around 1530 nm is less susceptible to radiation-induced attenuation than the band around 1560 nm. Based on this, they designed a custom filter with a Gaussian-like transmission spectrum. This filter was used to reshape the SFS output spectrum, emphasizing the more radiation-resistant 1530 nm band and suppressing the more vulnerable 1560 nm band. This technique aims to reduce mean wavelength drift by concentrating the output in a more stable spectral region.
  2. Feedback Control of Pump Power: To further combat the output power loss caused by radiation, a feedback control loop was implemented. This system monitors the output power and adjusts the pump laser diode (LD) current accordingly to compensate for any radiation-induced power degradation. This ensures a more stable output power level.

The experimental setup involved irradiating the SFS components (except for the LD driver circuits, which were shielded) with 60Co gamma rays at a dose rate of 2.988 Gy/h. Measurements of output power and spectral properties were taken using an optical power meter (OPM) and an optical spectrum analyzer (OSA), respectively.

Datasets

Not discussed in the paper. The experiments were conducted using custom-built SFSs and a 60Co gamma radiation source.

Key Insights and Ideas

  • Spectral Sensitivity to Radiation: The paper clearly demonstrates that different spectral regions of an Er3+-doped fiber exhibit varying degrees of radiation sensitivity. The 1530 nm band is significantly more robust than the 1560 nm band. This insight is crucial for designing radiation-hardened fiber optic sources.
  • Gaussian Filtering for Stability: Tailoring the spectrum with a Gaussian-shaped filter is an effective strategy to reduce mean wavelength drift. By concentrating the output power in the more stable 1530 nm region, the overall spectral stability is enhanced.
  • Synergy of Filtering and Feedback Control: The combination of spectral trimming and pump power feedback control yields a synergistic effect, significantly improving both wavelength stability and output power consistency under irradiation. Neither method alone achieves the same level of performance.
  • Practical Implications for Space Applications: The achieved performance metrics (low power loss and minimal wavelength drift) are directly relevant and highly beneficial for the demanding requirements of space-based IFOGs, where reliability and accuracy are paramount.

Key Results

The paper reports impressive results for the SFS equipped with both spectral trimming and feedback control:

  • Output Power Loss: Under a total dose higher than 1000 Gy, the output power loss was less than 0.2 dB. This is a significant improvement compared to previous methods. For instance, SFS#1 (without trimming) experienced a loss of 3.187 dB under 500 Gy, while the improved SFS#4 showed only a 0.112 dB loss under the same dose.
  • Mean Wavelength Drift: The mean wavelength drift was less than 40 ppm (parts per million) under a total dose higher than 1000 Gy. This is a substantial reduction compared to SFS#1, which exhibited a drift of 611.766 ppm under 500 Gy. The improved SFS#4 achieved a drift of 21.54 ppm under 500 Gy.
  • Spectral Stability: The spectral power within the 1530 nm band for the improved SFS showed an attenuation of less than 1.65 dB even under 500 Gy of irradiation, indicating excellent stability.

Limitations and Future Work

  • EDF Length Trade-off: The paper acknowledges that while longer EDFs can improve pump power conversion, they can also reduce radiation resistance. The optimal EDF length needs careful consideration.
  • Filter Bandwidth: The paper notes that the bandwidth of the custom filter was narrower than an ideal Gaussian spectrum. Further optimization of the filter design could potentially yield even better results.
  • Future Work: The authors suggest that the demonstrated methods can effectively improve the radiation-resistant capabilities of SFSs for space environments. While not explicitly stated as future work, further testing under different radiation types (e.g., protons, neutrons) and extended irradiation periods could provide a more comprehensive understanding of the long-term performance in space. Investigating the impact of temperature variations in conjunction with radiation could also be a valuable area for future research.

Summary updated

BibTeX
@misc{liu2018radiation,
  author = {Chengxiang Liu and Xu Wu and Jianhui Zhu and Nie He and Zhuoyan Li and Gongshen Zhang and Li Zhang and Shuangchen Ruan},
  title = {{Radiation-Resistant Er3+-Doped Superfluorescent Fiber Sources}},
  year = {2018},
  doi = {10.3390/s18072236},
}

Loading related content...

Figure