Qos-Based Optimal Resource Allocation for Multimedia Transmission in Wireless Networks

Qian Wang, Yilong Yin, Xiushan NieInternational Journal of Communications Network and System Sciences 2017 · DOI

Abstract

In this paper, aiming to improve the quality of multimedia transmission while satisfying the quality of service (QoS) requirements, we propose an optimal subcarrier allocation by jointly considering the video coding rate and the available power resource. We jointly analyze the effects on the performance of multimedia transmission from video coding rate at the application layer as well as the power control at the physical layer. This proposed joint power and subcarrier allocation algorithm in MIMO OFDM systems enables us both to overcome the challenge of full CSI (channel state information) with RD (the rate-distortion) to make minimum of the distortion of each user under delay and power constraints. Simulation results show that the proposed optimal subcarrier allocation algorithm improves the multimedia transmission quality considerably through the comparison with the resource allocation algorithms that only use a single layer of information.

Introduction

As multimedia traffic increasingly dominates wireless networks, maintaining high Quality of Service (QoS) has become a significant challenge due to the volatile nature of wireless channels. Traditionally, network layers are optimized in isolation: the Application (APP) layer handles video compression (such as H.264 or HEVC), while the Physical (PHY) layer manages power and frequency allocation.

However, this "siloed" approach is often suboptimal. A high video coding rate might provide better source quality but can overwhelm a fading channel, leading to packet loss and severe distortion. Conversely, physical layer resource allocation that ignores the specific rate-distortion (RD) characteristics of a video stream may waste power or bandwidth. This paper addresses these challenges by proposing a cross-layer optimization framework that jointly tunes application-layer parameters and physical-layer resources to minimize distortion for multiple users under strict power and delay constraints.

System Architecture and Methodology

The researchers developed a cross-layer design that facilitates information exchange between the APP and PHY layers. The system utilizes a MIMO-OFDM (Multiple Input Multiple Output - Orthogonal Frequency Division Multiple Access) setup where multiple users transmit video to a single access point.

System architecture for the proposed MIMO-OFDM video transmission framework showing the receiver-side processing chain.

The optimization framework is formulated as a distortion minimization task. The objective is to find the optimal quantization parameter ($q_i^*$) for each user's video stream. By proving the optimization problem is convex, the authors employ Lagrangian Multipliers and Karush-Kuhn-Tucker (KKT) conditions to derive a closed-form solution for optimal quantization and subcarrier allocation. At the PHY layer, a modified "water-filling" algorithm distributes power across subcarriers based on feedback from the APP layer's requirements and current Channel State Information (CSI).

Simulation Environment

The framework's performance was evaluated using numerical simulations with the following parameters:

  • Network: MU-MIMO OFDM with 32 subcarriers and up to 64 users.
  • Power/Bandwidth: System power constraint of -150 dB/Hz; transmit power ($P_t$) of 200 mW; subcarrier bandwidth of 100 kHz.
  • Channel Model: Rayleigh fading with a path-loss constraint ($\gamma$) of 2.45.
  • Video Standards: Compatibility with H.264/AVC and HEVC (H.265) rate-distortion models.

Key Insights

The core innovation lies in the mathematical link between optimal video quantization and physical channel capacity. By treating the quantization parameter as a variable in the network optimization, the system can dynamically adjust video quality in real-time based on channel fading. Because the problem is convex, the solution is globally optimal and computationally efficient enough for potential real-time implementation. Furthermore, the framework is versatile, applicable to both multicast and unicast systems.

Results and Performance Analysis

Simulation results demonstrate the clear advantages of the cross-layer approach over traditional single-layer methods:

  • PSNR Gains: The proposed algorithm consistently achieved higher Peak Signal-to-Noise Ratio (PSNR) values. In an 8-user scenario, the cross-layer approach maintained a PSNR approximately 4-6 dB higher than APP-layer-only methods.
  • Scalability: As the number of users increased from 2 to 16, the performance of the cross-layer system degraded gracefully, whereas baseline methods experienced sharp drops in video quality.
  • Robustness: The system showed superior resilience to increasing Symbol Error Rates (SER), proving that joint allocation is more robust against channel noise than iterative water-filling alone.

Conclusion and Future Work

While the proposed framework offers significant improvements, it currently relies on the assumption of full Channel State Information (CSI). In high-mobility scenarios, obtaining perfect CSI is difficult and introduces overhead. Future research could extend this framework to multi-hop relay networks or integrate more sophisticated error-control coding, such as Unequal Error Protection (UEP), to further safeguard high-priority video data.

Summary updated

Abstract

In this paper, aiming to improve the quality of multimedia transmission while satisfying the quality of service (QoS) requirements, we propose an optimal subcarrier allocation by jointly considering the video coding rate and the available power resource. We jointly analyses the effects on the performance of multimedia transmission from video coding rate at the application layer as well as the power control at the physical layer. This proposed joint power and subcarrier allocation algorithm in MIMO OFDM systems enables us both to overcome the challenge of full CSI (channel state information) with RD (the rate-distortion) to make minimum of the distortion of each users under delay and power constraints. Simulation results show that the proposed optimal subcarrier allocation algorithm improves the multimedia transmission quality considerably through the comparison with the resource allocation algorithms only use a single layer of information.
BibTeX
@article{wang2017qos,
  author = {Qian Wang and Yilong Yin and Xiushan Nie},
  title = {{Qos-Based Optimal Resource Allocation for Multimedia Transmission in Wireless Networks}},
  journal = {International Journal of Communications Network and System Sciences},
  year = {2017},
  doi = {10.4236/ijcns.2017.105b029},
}
Figure