Prediction of osteoporosis at the sacrum using opportunistic CT of the abdomen and pelvis: a retrospective feasibility study in 277 patients comparing CT and QCT data

Xiao Yan, Wen Li, Wei Zhou, Miao Wei, Bangyuan Long, Jeffrey J. Pu, Fajin LvResearch Square 2025 · DOI

TL;DR

This study demonstrates that Hounsfield Unit (HU) values from routine abdominopelvic CT scans of the sacrum can accurately predict osteoporosis, correlating strongly with established bone mineral density (BMD) measurements. A predictive model incorporating age, sex, and sacral HU values achieves even higher accuracy, suggesting opportunistic CT screening of the sacrum could be a valuable tool for early osteoporosis detection.

What Problem Does This Paper Address?

Osteoporosis, a condition characterized by reduced bone mass and increased fragility, poses a significant global health challenge, leading to increased fracture risk and reduced quality of life. While Dual-energy X-ray absorptiometry (DXA) is the gold standard for diagnosis, it has limitations. Quantitative CT (QCT) offers greater accuracy but requires dedicated scans and higher radiation doses. The paper addresses the gap in accessible, widespread osteoporosis screening by exploring the potential of "opportunistic screening" using existing abdominopelvic CT scans, which are frequently performed for other medical reasons. Specifically, it investigates whether the Hounsfield Unit (HU) values of the sacrum, a region often overlooked in routine CT interpretations, can serve as a reliable proxy for bone mineral density (BMD) and predict osteoporosis.

Methods

The researchers conducted a retrospective feasibility study on 277 patients (aged 19-81) who underwent abdominopelvic CT scans. They extracted Hounsfield Unit (HU) values from the cancellous bone of the sacral vertebrae (S1-S3). These HU values were then correlated with bone mineral density (BMD) measurements obtained via Quantitative CT (QCT) of the lumbosacral spine (L1-S3), with L1-L2 BMD serving as a primary reference.

Key methodological aspects include:

  • Opportunistic HU Measurement: HU values were manually outlined in the cancellous bone of the sacral vertebrae at three axial levels, excluding cortical bone and other structures. This is a novel application of standard CT imaging parameters for bone density assessment.
  • QCT as Gold Standard: QCT was used to establish BMD values for comparison, with patients categorized into normal, osteopenia, and osteoporosis groups based on established QCT criteria.
  • Correlation Analysis: Spearman's correlation coefficient was employed to assess the relationship between sacral HU values, sacral BMD, and the reference L1-L2 BMD.
  • ROC Curve Analysis: Receiver Operating Characteristic (ROC) curves were generated to determine optimal HU thresholds for predicting osteoporosis and excluding bone abnormalities for individual sacral vertebrae.
  • Predictive Modeling: A multi-factor model incorporating age, sex, and sacral HU values was developed to assess its predictive accuracy.

Datasets

The study utilized a dataset of 277 patients who underwent abdominopelvic CT scans at the First Hospital of Chongqing Medical University between September 2022 and September 2025. This dataset was retrospectively analyzed. No new benchmark datasets were introduced.

Key Insights and Ideas

  • Sacral HU as a Bone Density Proxy: The study strongly supports the idea that HU values from the sacrum, a bone readily visualized on routine abdominopelvic CTs, can serve as a reliable indicator of bone mineral density. This opens up a vast, underutilized source of data for osteoporosis screening.
  • Age-Related Bone Loss Pattern: The observed pattern of bone density decline from L1 to L3, increase to S1, and subsequent decrease to S3 in the lumbosacral spine, with a notable decrease from S1 to S3, highlights regional variations in bone density and the vulnerability of the sacrum to age-related bone loss.
  • Sex Differences Emerge with Age: While males generally had higher BMD, the difference became more pronounced after age 50, and the proportion of females increased significantly in the osteopenia and osteoporosis groups, aligning with known postmenopausal bone loss patterns.
  • Sacrum's Underappreciated Role: The sacrum, often overlooked in routine CT interpretation, plays a crucial role in bone health. Its susceptibility to osteoporosis, potentially leading to asymptomatic lower back pain, underscores the importance of assessing this region.
  • Combined Model Superiority: The most impactful insight is that a predictive model combining age, sex, and sacral HU values significantly outperforms models based on individual sacral vertebrae alone, suggesting a holistic approach to opportunistic screening.

Key Results

  • Strong Correlation: Sacral spine HU values showed a strong positive correlation with both sacral spine BMD (r = 0.830 to 0.905) and the mean BMD of L1-L2 (r = 0.844 to 0.905), with S1 demonstrating the highest correlation.
  • High Diagnostic Performance: Individual sacral vertebrae achieved high Area Under the Curve (AUC) values for predicting osteoporosis (0.909-0.977) and excluding bone abnormalities (0.933-0.950).
  • Optimal Thresholds for S1: The study identified specific HU thresholds for the S1 vertebra:
  • Excluding Bone Abnormalities: >165.17 HU (91.5% specificity, 83.0% sensitivity).
  • Diagnosing Osteoporosis: <130.50 HU (90.0% specificity, 96.6% sensitivity).
  • Superior Combined Model: A predictive model incorporating sex, age, and sacral vertebrae HU values achieved an impressive AUC of 0.981 for osteoporosis prediction.

Limitations and Future Work

The authors acknowledge several limitations:

  • Retrospective, Single-Center Study: The study's retrospective nature, single-center design, and use of a single CT device may introduce selection bias and limit the generalizability of the findings.
  • No Fracture Prediction: The study focused on predicting osteoporosis, not fracture risk, which is a critical outcome of the disease.
  • Opportunistic vs. Dedicated Screening: Sacral HU measurement is presented as an opportunistic approach, not a replacement for dedicated BMD assessments in all cases.
  • QCT vs. DXA Comparison: The use of QCT as a reference, rather than DXA, might affect direct comparison with established clinical diagnostic standards.

Future work suggested includes:

  • Multi-center, Multi-device Studies: To improve generalizability and mitigate selection bias.
  • Fracture Prediction: Investigating the correlation between sacral HU values and actual fracture incidence.
  • Automated Measurement: Exploring software-based automated methods for HU measurement to improve consistency and efficiency.
  • External Validation: Validating the predictive model in independent cohorts.

Summary updated

Abstract

<title>Abstract</title> <bold>Objectives</bold> To examine the distribution pattern of bone density in the L1-S3 vertebrae using opportunistic abdominopelvic imaging.QCT was employed as a reference to establish HU thresholds for the sacral vertebrae facilitating the prediction of osteoporosis and the exclusion of bone abnormalities. <bold>Methods</bold> A total of 277 subjects aged 19 to 81 years who underwent abdominopelvic CT were evaluated. Bone mineral density (BMD) measurements for the L1-S3 vertebrae and HU values for the S1-S3 vertebrae were collected. The study analyzed the correlation between sacral spine HU values and sacral spine BMD, along with the clinically utilized mean BMD for L1-L2, was analyzed. Receiver operating characteristic (ROC) curves were generated to identify the optimal diagnostic thresholds. <bold>Results</bold> The BMD of the lumbosacral vertebrae displayed a gradual decrease from L1 to L3, followed by an increase from L4 to S1, and a subsequent decline from S1 to S3. HU values of the sacral vertebrae across all planes were strongly correlated with both sacral spine BMD and the mean BMD values for L1-L2( r=0.830 to 0.905, <italic>P</italic> <0.05). For individual vertebrae, the area under the curve(AUC) of HU values for predicting osteoporosis ranged from 0.909 to 0.977, while the AUC for excluding bone abnormalities ranged from 0.933 to 0.950, with S1 demonstrating the highest predictive efficacy. The optimal threshold for S1 was &gt;165.17 HU, yielding a specificity of 91.5% and a sensitivity of 83.0% for excluding bone abnormalities. Conversely, an S1 threshold of &lt;130.50 HU resulted in a diagnostic specificity of 90.0% and a sensitivity of 96.6% for osteoporosis. Additionally, a predictive model that incorporated sex, age, and vertebral cancellous bone HU values achieved an AUC of 0.981. <bold>Conclusions</bold> Our data demonstrate a strong correlation between the HU values of the sacral spine and the clinically used BMD values for L1-L2, supporting the prediction of osteoporosis based on sacral spine HU values. Moreover, a predictive model that includes sex, age, and vertebral measurements offers improved diagnostic accuracy.
BibTeX
@inproceedings{yan2025prediction,
  author = {Xiao Yan and Wen Li and Wei Zhou and Miao Wei and Bangyuan Long and Jeffrey J. Pu and Fajin Lv},
  title = {{Prediction of osteoporosis at the sacrum using opportunistic CT of the abdomen and pelvis: a retrospective feasibility study in 277 patients comparing CT and QCT data}},
  booktitle = {Research Square},
  year = {2025},
  doi = {10.21203/rs.3.rs-7716661/v1},
}
Figure