Precoding based on Signal-to-leakage and Noise Ratio to Reduce ICI in MIMO-OFDM Systems

Ambuj Mehrish, Vikash Kumar, Ashish GoswamiInternational Journal of Computer Applications 2014 · DOI

Abstract

Current trends in the development of high-data-rate wireless systems focus on the integration of orthogonal frequency-division multiplexing (OFDM) and multiple-input multiple-output (MIMO). The combination of OFDM and MIMO techniques represents a promising candidate for future broadband wireless systems. This paper addresses the Inter-Carrier Interference (ICI) issue in multi-user MIMO-OFDM systems operating in time-varying frequency-selective channel environments. In our proposed method, precoding based on the signal-to-leakage-and-noise ratio (SLNR) is considered. Based on the introduced model, an algorithm for the precoding matrix is developed. Simulation results confirm a reduction in ICI without increasing the complexity of the system.

Introduction

Modern wireless communication relies heavily on MIMO-OFDM to achieve high data rates. While OFDM is effective at handling multipath fading by splitting data across many orthogonal subcarriers, it is highly sensitive to frequency offsets and time-varying channels. In dynamic environments, such as high-mobility scenarios, rapid channel changes destroy subcarrier orthogonality, leading to Inter-Carrier Interference (ICI). Additionally, multi-user scenarios introduce Co-Channel Interference (CCI), where signals intended for one user interfere with others.

Existing solutions like Zero-Forcing (ZF) precoding can mitigate these effects but impose strict hardware constraints—specifically, the number of receive antennas must typically exceed the number of transmit streams. This limits their flexibility in dense, heterogeneous networks. This paper proposes a linear precoding strategy based on the Signal-to-Leakage-and-Noise Ratio (SLNR) to combat ICI and CCI more effectively.

System Model and Methodology

The proposed system exploits Channel State Information at the Transmitter (CSIT) to pre-emptively manage interference. Instead of attempting to completely nullify interference as in Zero-Forcing, the SLNR approach optimizes the precoding matrix to maximize the ratio of the desired signal power to the sum of noise and "leakage" power. Leakage is defined as the power a specific user's signal induces at all other users' receivers.

Multi-user MIMO-OFDM system model illustrating user selection and precoding blocks.

The optimal precoding weights are found by calculating the generalized eigenvector corresponding to the largest eigenvalue of the channel matrix pair. This methodology effectively decouples a multi-user system into multiple independent single-user systems, significantly simplifying the receiver's processing requirements. Unlike ZF, SLNR precoding is always applicable regardless of antenna dimensions, providing a "soft" optimization that balances interference suppression with signal enhancement.

Results and Discussion

The proposed scheme was evaluated using numerical simulations in a 2-tap fading channel with Doppler effects modeled via Jakes’s model to simulate receiver mobility. The simulation parameters included 128 subcarriers, QPSK modulation, and a cyclic prefix length of 1/8th the symbol duration.

BER performance comparison showing SLNR-MIMO-OFDM outperforming ZF-MIMO-OFDM and standard MIMO-OFDM.

As illustrated in the performance curves, the SLNR-MIMO-OFDM approach consistently achieves a lower Bit Error Rate (BER) compared to both ZF-MIMO-OFDM and standard MIMO-OFDM. For example, at an SNR of 10dB, the SLNR method achieves a BER near $10^{-3}$, whereas standard MIMO-OFDM remains closer to $10^{-1}$. Furthermore, the system demonstrates excellent scalability; performance improves as the number of transmit antennas increases (e.g., comparing 2x2, 4x2, and 6x2 configurations), confirming that the algorithm effectively utilizes additional spatial degrees of freedom.

Conclusion

Precoding based on the Signal-to-Leakage-and-Noise Ratio provides a robust and flexible solution for reducing ICI in multi-user MIMO-OFDM systems. By optimizing for SLNR rather than perfect nulling, the system achieves superior BER performance without a significant increase in computational complexity. While this study assumes perfect CSIT, future research should address performance in the presence of feedback delays and explore integration with dynamic power allocation strategies to further enhance spectral efficiency.

Summary updated

Abstract

Current trends in the development of high-data-rate wireless systems focus on the integration of orthogonal frequencydivision multiplexing (OFDM) and multiple-input?multiple-output (MIMO).The combination of OFDM and the Multiple-Input-Multiple-Output (MIMO) technique represents a promising candidate for future broadband wireless systems. This paper addresses the Inter Carrier Interference (ICI) issue in multiuser MIMO-OFDM systems operating in time-varying frequency selective channel environments.In our proposed method precoding based on signal-to-leakage-and-noise ratio (SLNR) is considered.In this paper model using precoding in MIMO-OFDM is introduced.Based on the model algorithm for precoding matrix is developed.Simulation results confirms reduction in ICI without increasing complexity of a system.
BibTeX
@article{mehrish2014precoding,
  author = {Ambuj Mehrish and Vikash Kumar and Ashish Goswami},
  title = {{Precoding based on Signal-to-leakage and Noise Ratio to Reduce ICI in MIMO-OFDM Systems}},
  journal = {International Journal of Computer Applications},
  year = {2014},
  doi = {10.5120/16699-6831},
}
Figure