TL;DR
This study investigates how fatigue from prolonged brisk walking affects elderly individuals' gait by analyzing plantar pressure. They found that fatigue leads to increased pressure and impulse in certain foot regions, along with altered variability and asymmetry, suggesting these metrics can be used to assess fatigue-induced instability with wearable in-shoe sensors.
What Problem Does This Paper Address?
As the global population ages, maintaining physical fitness and preventing falls in the elderly is a critical public health concern. Falls are a significant cause of morbidity and mortality in this demographic, often linked to fatigue and resulting gait instability. While traditional methods for assessing gait instability rely on laboratory equipment like motion capture systems, this paper explores the potential of wearable in-shoe pressure sensors for a more accessible and field-deployable solution. Specifically, the researchers aim to understand how prolonged physical exertion (60 minutes of brisk walking) induces fatigue in older adults and how this fatigue manifests in their plantar pressure distribution, variability, and asymmetry. This understanding could lead to better tools for early detection of fatigue-related instability, ultimately reducing fall risks.
Methods
The study employed a within-subject design where 15 elderly participants (average age 59.6 years) underwent a 60-minute continuous brisk walking session on a treadmill. Plantar pressure data was collected using wearable in-shoe pressure sensors (Novel Pedar-X system) at three time points: baseline (1st minute), 30 minutes, and 60 minutes into the walk. The data was segmented by gait cycle, and key parameters were extracted for nine distinct plantar regions: hallux (Hx), lesser toes (LT), medial metatarsal (MM), central metatarsals (CM), lateral metatarsals (LM), medial arch (MA), lateral arch (LA), medial heel (MH), and lateral heel (LH).
The primary outcome variables analyzed were:
- Contact Time (CT): The duration the foot is in contact with the ground.
- Peak Pressure (PP): The maximum pressure exerted on a specific plantar region.
- Impulse (IM): The integral of pressure over time, representing the total force applied.
- Asymmetry Index (ASI): Measures the difference in pressure parameters between the dominant and non-dominant feet.
- Median Absolute Deviation (MAD): A measure of variability in pressure over time within a gait cycle.
Statistical analysis involved the nonparametric Friedman test to compare the three time conditions, followed by post-hoc pairwise comparisons using the Wilcoxon signed-rank test with Bonferroni correction to identify specific significant differences.
Datasets
Not discussed in the paper. The study collected data from participants during the experimental protocol.
Key Insights and Ideas
- Fatigue Alters Pressure Distribution: Prolonged walking significantly increased peak pressure and impulse in specific areas like the medial and lateral arches, and central metatarsal regions. This suggests that as fatigue sets in, the elderly's ability to distribute load effectively diminishes.
- Variability as a Fatigue Indicator: The variability of plantar pressure in the medial arch significantly increased with fatigue, pointing towards a potential breakdown in stability control in this region.
- Asymmetry as a Compensatory Mechanism: Interestingly, while variability increased in some areas, asymmetry in plantar pressure decreased in others. This suggests that the body might attempt to compensate for fatigue by making gait more symmetrical, possibly to maintain balance.
- Prolonged Contact Time as Compensation: The study observed a significant increase in contact time across all plantar regions. This prolonged ground contact could be a deliberate compensatory strategy to improve stability and allow for better micro-adjustments during walking when fatigued.
- Wearable Sensors Show Promise: The findings strongly support the utility of wearable in-shoe pressure sensors for assessing fatigue-induced gait instability in real-world settings, moving beyond laboratory constraints.
Key Results
- After 60 minutes of brisk walking, peak pressure increased significantly in the medial and lateral arch, and central metatarsal regions (p < 0.05).
- Impulse also showed significant increases in the same regions (p < 0.05).
- Variability (MAD) of plantar pressure in the medial arch significantly increased (p < 0.05).
- Asymmetry (ASI) of peak plantar pressure in the medial arch significantly decreased (p < 0.05), suggesting improved symmetry.
- Contact time significantly increased in all plantar regions (p < 0.05).
- Participants reported varying levels of fatigue, with 73.3% reporting severe fatigue.
Limitations and Future Work
The authors acknowledge several limitations:
- "Fatigue" is Broad: Fatigue is a complex phenomenon with neuromuscular, mental, and metabolic components, and this study primarily induced fatigue through prolonged exercise without differentiating these aspects.
- Indirect Relationship: The study relies on the assumption that changes in plantar pressure parameters are directly indicative of fatigue, a relationship supported by existing literature but not directly measured.
- Confounding Factors: Individual factors like physical fitness level, sports habits, footwear, and even gender could influence endurance and fatigue responses, potentially introducing variability.
- Treadmill vs. Overground: Treadmill walking may not perfectly replicate overground walking, although studies suggest kinematic and kinetic similarities.
- Limited Load Direction: The study focused on vertical load, not considering medial-lateral or anterior-posterior forces.
- Sampling Method: A convenient sampling approach was used, limiting generalizability.
Future work suggested includes:
- Differentiating Fatigue Types: Employing methods like electromyography and near-infrared spectroscopy to differentiate between myoelectric and metabolic fatigue.
- Repeatability Analysis: Using repeatability analysis to further assess gait stability.
- Inertial Measurement Units (IMUs): Integrating IMUs for enhanced wearability and a more comprehensive understanding of gait dynamics.
- Biofeedback Systems: Developing biofeedback systems to provide real-time feedback to users.
- Larger Sample Sizes and Random Sampling: Increasing sample size and using random sampling for improved external validity.
Summary updated