Orbital magnetic moment and coercivity of<mml:math xmlns:mml="http://www.w3.org/1998/Math/MathML"><mml:mi>Si</mml:mi><mml:msub><mml:mi mathvariant="normal">O</mml:mi><mml:mn>2</mml:mn></mml:msub></mml:math>-coated FePt nanoparticles studied by x-ray magnetic circular dichroism

Y. Takahashi, Takashi Kadono, Satoshi Yamamoto, V. R. Singh, V. K. Verma, Keisuke Ishigami, Goro Shibata, Takayuki Harano, Yukiharu Takeda, T. Okane, Y. Saitoh, Hiroshi Yamagami, M. Takano, A. FujimoriPhysical 2014 · DOI · arXiv

Abstract

We have investigated the spin and orbital magnetic moments of Fe in FePt nanoparticles in the $L1_0$-ordered phase coated with $SiO_2$ by x-ray absorption spectroscopy (XAS) and x-ray magnetic circular dichroism (XMCD) measurements at the Fe $L_{2,3}$ absorption edges. Using XMCD sum rules, we evaluated the ratio of the orbital magnetic moment ($M_{orb}$) to the effective spin magnetic moment ($M_{spin}^{eff}$) of Fe to be $M_{orb}/M_{spin}^{eff} = 0.08$. This value is comparable to gas-phase condensed nanoparticles (0.09) and larger than thin films (~0.05), indicating a high degree of $L1_0$ order. The magnetic coercivity ($H_c$) was found to be 1.8 T at room temperature, significantly higher than reference materials. The hysteresis behavior is well-described by the Stoner-Wohlfarth model for noninteracting single-domain nanoparticles.

Introduction

As the demand for high-density data storage increases, materials must maintain magnetic stability at ever-decreasing scales. The FePt alloy in its $L1_0$-ordered phase is a primary candidate due to its massive magnetocrystalline anisotropy. However, synthesizing $L1_0$-ordered FePt nanoparticles is challenging; standard chemical methods often yield a disordered phase, and the high-temperature annealing required for ordering typically leads to particle coalescence or oxidation. This study explores a "nanoreactor" approach, encasing FePt nanoparticles in a protective silica ($SiO_2$) shell to preserve their structural and magnetic integrity during processing.

Experimental Methods

The researchers synthesized fcc-phase FePt nanoparticles via wet chemistry, subsequently coating them with a 10-15 nm $SiO_2$ layer. This shell acted as a barrier, allowing high-temperature annealing to induce $L1_0$ ordering without fusion. Characterization was performed using X-ray Absorption Spectroscopy (XAS) and X-ray Magnetic Circular Dichroism (XMCD) at the Fe $L_{2,3}$ edges at the SPring-8 synchrotron. XMCD is particularly effective here as it provides an element-specific "microscopic fingerprint," allowing the team to isolate the magnetic behavior of Fe from the $SiO_2$ background and any surface oxides.

Microscopic Magnetic Insights

By applying XMCD sum rules, the team calculated the ratio of the orbital magnetic moment ($M_{orb}$) to the spin magnetic moment ($M_{spin}$). They found a ratio of 0.08, which serves as a critical quality metric. Because the orbital moment is intrinsically linked to crystal symmetry, this high value—surpassing that of FePt thin films—directly confirms a high degree of $L1_0$ crystalline order within the isolated nanoparticles.

Comparison of magnetic moments and coercivity for $SiO_2$-coated FePt nanoparticles versus gas-phase nanoparticles and thin films.

While the $SiO_2$ coating successfully prevented coalescence, spectral analysis revealed some surface oxidation ($Fe^{3+}$). However, the element-specific nature of XMCD allowed researchers to mathematically decompose the signal, isolating the robust ferromagnetic behavior of the FePt core from the paramagnetic or antiferromagnetic oxide contributions.

Record Coercivity and Single-Domain Behavior

The most striking result of the "nanoreactor" approach is the achievement of a magnetic coercivity ($H_c$) of 1.8 T at room temperature. This is approximately three times larger than that of FePt thin films and fifty times larger than nanoparticles prepared without the silica shell.

Hysteresis loops of the FePt component measured by XMCD at room temperature, showing a coercivity of 1.8 T and a fit to the Stoner-Wohlfarth model.

As shown in Figure 3, the hysteresis curves align closely with the Stoner-Wohlfarth model, which describes non-interacting single-domain particles. The fit assumes a distribution of coercivities between 1 T and 5 T, confirming that the nanoparticles are thermally stable and magnetically isolated. The magnetization saturates around 6 T, highlighting the high fields necessary to manipulate these "hard" magnetic materials.

Conclusion and Future Outlook

The study demonstrates that $SiO_2$-coated FePt nanoparticles can achieve the high crystalline order and magnetic isolation required for advanced storage applications. While surface oxidation remains a limitation—resulting in a spin magnetic moment of $1.4 \mu_B/Fe$ compared to the bulk $2.0 \mu_B/Fe$—the record coercivity proves the effectiveness of the silica shell. Future work focusing on optimizing the core-shell interface to eliminate oxidation could further enhance performance, bringing the spin moment closer to theoretical bulk values.

Summary updated

Abstract

We have investigated the spin and orbital magnetic moments of Fe in FePt nanoparticles in the $L$1${}_{0}$-ordered phase coated with $\mathrm{Si}{\mathrm{O}}_{2}$ by x-ray absorption spectroscopy (XAS) and x-ray magnetic circular dichroism (XMCD) measurements at the Fe ${L}_{2,3}$ absorption edges. Using XMCD sum rules, we evaluated the ratio of the orbital magnetic moment (${M}_{\mathrm{orb}}$) to the effective spin magnetic moment (${M}_{\mathrm{spin}}^{\mathrm{eff}}$) of Fe to be ${M}_{\mathrm{orb}}/{M}_{\mathrm{spin}}^{\mathrm{eff}}=0.08$. This ${M}_{\mathrm{orb}}/{M}_{\mathrm{spin}}^{\mathrm{eff}}$ value is comparable to the value (0.09) obtained for FePt nanoparticles prepared by gas phase condensation, and is larger than the values ($\ensuremath{\sim}$0.05) obtained for FePt thin films, indicating a high degree of $L$1${}_{0}$ order. The hysteretic behavior of the FePt component of the magnetization was measured by XMCD. The magnetic coercivity (${H}_{c}$) was found to be as large as 1.8 T at room temperature, $\ensuremath{\sim}$3 times larger than the thin film value and $\ensuremath{\sim}$50 times larger than that of the gas phase condensed nanoparticles. The hysteresis curve is well explained by the Stoner-Wohlfarth model for noninteracting single-domain nanoparticles with the ${H}_{c}$ distributed from 1 to 5 T.
BibTeX
@inproceedings{takahashi2014orbital,
  author = {Y. Takahashi and Takashi Kadono and Satoshi Yamamoto and V. R. Singh and V. K. Verma and Keisuke Ishigami and Goro Shibata and Takayuki Harano and Yukiharu Takeda and T. Okane and Y. Saitoh and Hiroshi Yamagami and M. Takano and A. Fujimori},
  title = {{Orbital magnetic moment and coercivity of<mml:math xmlns:mml="http://www.w3.org/1998/Math/MathML"><mml:mi>Si</mml:mi><mml:msub><mml:mi mathvariant="normal">O</mml:mi><mml:mn>2</mml:mn></mml:msub></mml:math>-coated FePt nanoparticles studied by x-ray magnetic circular dichroism}},
  booktitle = {Physical},
  year = {2014},
  doi = {10.1103/physrevb.90.024423},
}
Figure