Abstract
The machine output power smoothing has an important significance to improve the efficiency and quality of machining. With the secondary development of cutting geometry simulation software, we have got the geometry cutting parameters, carried out a physical simulation of the whole cutting processing and optimized the cutting parameters in this paper. The results show that this method is efficient and practical and finally improve the stability of NC machining process.
Introduction
In Numerical Control (NC) machining, cutting power serves as a critical indicator of the forces exerted on the tool. Significant fluctuations in power often result in "flutter" or vibrations, excessive thermal accumulation, and unpredictable tool failure. Traditional approaches to predicting these forces, such as Finite Element Analysis (FEA), are often too computationally intensive for complex tool paths. Conversely, simple empirical formulas fail to capture the dynamic "heartbeat" of individual cutting teeth. This research addresses the need for an efficient, dynamic power calculation method that optimizes machining parameters without producing fragmented NC code that would be unexecutable by standard machine controllers.
Methodology
Geometry Extraction and Integration
The researchers utilized the secondary development API of VERICUT, a standard machining simulation suite, to extract precise geometric data—such as axial depth and radial width—at regular intervals along the tool path. This integration allows the model to account for the evolving geometry of the workpiece in real-time during simulation.
Dynamic Force Modeling
A dynamic cutting force model was implemented based on analytical frameworks that treat the cutting tool as a series of infinitesimal elements. Specific thickness models were developed for various tool geometries, including flat-head, ball-end, and circular nose cutters.
The model calculates tangential ($F_t$), radial ($F_r$), and axial ($F_a$) forces by integrating across the cutting elements, as shown in the mathematical formulations above. This allows for a granular understanding of the power requirements at any given point in the tool path.
Two-Step Optimization Strategy
To bridge the gap between theoretical optimization and practical factory floor execution, a two-step process was employed:
- Clustering Segmentation: To prevent the generation of "fragmented" NC code—where parameters change too frequently for the controller to process smoothly—a clustering algorithm groups data points into manageable segments.
- Dichotomy Algorithm: Within each segment, a dichotomy (binary search) algorithm iteratively identifies the optimal feed rate and cutting depth. The goal is to bring the segment's average power as close as possible to a target threshold, prioritizing feed rate adjustments to maintain tool path integrity.
Case Study and Results
The model was validated using a 3-axis NC milling machine (Fanuc 15m) machining carbon structural steel with a hard alloy steel tool. The test involved 825 lines of NC code with a spindle speed of 5000 r/min.
Comparison between the original and optimized NC code revealed:
- Qualitative Improvement: The original power curve exhibited jagged, high-amplitude spikes. The optimized curve was significantly smoother, maintaining a consistent power level throughout the operation.
- Practicality: The optimized NC code was successfully executed on physical hardware, demonstrating the method's high practical value for improving machining stability and potentially extending tool life.
Discussion and Limitations
A key insight from this study is the prioritization of feed rate adjustments over cutting depth changes. Adjusting depth is more complex as it requires re-calculating the entire tool path and performing new interference checks.
Current limitations include the "offline" nature of the optimization, which cannot account for mid-process variables like material inconsistencies or real-time tool wear. Future work will focus on incorporating tool wear models and streamlining the layered optimization required for depth changes.
Summary updated