On Simple-Sectored Multi-Probe Anechoic Chamber Design for mmWave Adaptive Terminal

Xiaoli Yang, Wei Fan, Nan Ma, Jianqiao Chen, Ping ZhangIEEE Access 2020 · DOI

Introduction

The transition to 5G millimeter-wave (mmWave) technology has introduced significant challenges for mobile device testing. Unlike previous generations where physical RF connectors were standard, mmWave devices utilize highly integrated antenna arrays for beamforming, necessitating Over-the-Air (OTA) testing. Traditional Multi-Probe Anechoic Chambers (MPAC) are often prohibitively large and expensive for these frequencies. This paper proposes a "white box" approach to designing Simple-Sectored Multi-Probe Anechoic Chambers (SS-MPAC), significantly reducing hardware requirements by leveraging knowledge of the device's internal antenna placement.

System Architecture and Methodology

The researchers investigated the SS-MPAC configuration, which employs a limited sector of probes instead of a full ring. The core of their study compares two design philosophies: a "Black Box" approach, which assumes no knowledge of the device's internal structure, and a "White Box" approach, which utilizes specific information about antenna sub-array locations and beamwidths.

System architecture of the proposed SS-MPAC testing environment.

The study simulated various antenna sub-arrays (patch, slot, Yagi-Uda, dipole, and Vivaldi) under 3GPP-standard spatial channel models, specifically Line-of-Sight (LoS) and Clustered Delay Line-C (CDL-C) at 28 GHz. Performance was evaluated using Beam Pattern Similarity (BPS) and Spatial Correlation Error for MIMO configurations.

Key Insights: The "White Box" Advantage

A primary finding is that the "black box" approach often leads to over-engineering. By accounting for the physical position of antenna sub-arrays on the terminal, the number of active probes can be reduced without compromising accuracy. Interestingly, the specific type of antenna element has a negligible effect on testing fidelity compared to the sub-array's physical position and its Half Power Beamwidth (HPBW).

Comparison of single and multiple adaptive sub-array configurations on a terminal device.

Testing multiple active sub-arrays for spatial multiplexing (MIMO) increases hardware demands. While a single active port might only require 8 probes and a 1-meter range, a MIMO setup with two 1x4 sub-arrays requires at least 38 active probes to maintain a spatial correlation error below 0.1.

Results and Future Outlook

The study demonstrates that for single-array testing, an SS-MPAC with just 8 active probes and a 1-meter range is sufficient to achieve high beam similarity across all simulated channel models. This "white box" strategy offers a clear path toward reducing the cost and physical footprint of mmWave testing facilities.

However, challenges remain in the physical calibration of these systems at high frequencies. Future work will focus on integrating more complex channel models and adapting chamber designs to the evolving beamwidth standards of 5G terminals.

Summary updated

BibTeX
@article{yang2020simple,
  author = {Xiaoli Yang and Wei Fan and Nan Ma and Jianqiao Chen and Ping Zhang},
  title = {{On Simple-Sectored Multi-Probe Anechoic Chamber Design for mmWave Adaptive Terminal}},
  journal = {IEEE Access},
  year = {2020},
  doi = {10.1109/access.2020.2971338},
}
Figure