Numerical Study on the Performance of a Cogeneration System of Solid Oxide Fuel Cell Based on Biomass Gasification

Zheng Dang, Zhaoyi Jiang, Jinyan Ma, Xinmin Shen, Guang XiFrontiers in Energy Research 2021 · DOI

Abstract

In order to solve the environmental pollution problem caused by winter heating of rural residential building in northern of China, in this paper a biomass gasification (BG)-solid oxide fuel cell (SOFC) combined heat and power (CHP) system has been established and numerically investigated. Taking a rural village around Xi’an as the study object, the energy saving ratio and economical efficiency of the CHP system under three different operation schemes compared with the traditional energy system have been analyzed. The results show that the operation scheme for heating designated rooms in rural buildings and meeting the average heat demand of users is the most energy-efficient and economical way. The primary energy saving rate and annual cost saving rate can reach 18.0% and 10.3%, respectively.

Introduction

Rural residential heating in Northern China relies heavily on the distributed burning of coal, leading to severe winter air pollution. While biomass resources like crop straw are abundant in these regions, they are often burned in fields, further exacerbating pollution. Traditional combustion-based heat engines are inefficient and produce significant emissions. This paper explores a cleaner alternative: using biomass gasification to produce syngas, which then fuels a Solid Oxide Fuel Cell (SOFC). SOFCs are highly efficient because they convert chemical energy directly into electricity via electrochemical reactions, bypassing the Carnot limit of heat engines.

System Architecture and Methodology

The authors developed a comprehensive numerical model of a BG-SOFC-CHP system. The system integrates a biomass pyrolyzer/gasifier, an expander for pressure regulation, a burner for tail-gas combustion, and heat exchangers to recover waste heat for residential use.

Figure 1: BG-SOFC-CHP system flowchart showing the integration of biomass gasification and fuel cell components.

Electrochemical Modeling

The SOFC performance was modeled using the Nernst equation for electromotive force, with the Achenbach model used to calculate activation and ohmic losses. Concentration losses were neglected under the assumption of normal current density operation.

Building Load Simulation

Using the Designer’s Simulation Toolkit (DeST), the authors simulated the hourly thermal and electrical loads of a typical two-story rural building in Xi’an. The load profile for a typical winter day (January 21) was used as the baseline for system sizing and evaluation.

Figure 2: Typical daily heat load and electric load in winter for a rural residential building.

Operational Schemes

The system was evaluated under three scenarios:

  1. Scheme One: Meeting the basic load for 20 residential users (heating all rooms).
  2. Scheme Two: Meeting the average heat demand for 123 users by heating only "designated rooms" (living rooms and bedrooms).
  3. Scheme Three: Meeting the average daily electrical load for an entire village.

Key Insights and Results

The most critical factor for energy efficiency is the Thermal-to-Electric Ratio (TER). The closer the system’s output TER is to the user’s demand TER, the higher the Primary Energy Saving Ratio (PESR).

  • Scheme Two (Winner): Achieved a PESR of 18.0% and an Annual Cost Saving Rate (ACSR) of 10.3%. Heating entire rural houses is inefficient because many rooms remain idle. By restricting heating to commonly used areas, the system can support more users (123 vs. 20) and achieve much higher energy and cost savings.
  • Scheme One: Resulted in a PESR of 8.6% and an ACSR of 5.5%. The high thermal demand of heating entire houses limited the number of users the 100 kW system could support.
  • Scheme Three: While it achieved a PESR of 8.5%, it resulted in a negative cost saving rate (-20.2%). The low and intermittent electricity consumption in rural areas meant the CHP system couldn't be utilized effectively, making it more expensive than the traditional grid.

The optimized 100 kW system showed a cogeneration efficiency of 93.86%, with a net electrical generation efficiency of 39.45%.

Conclusion

The study demonstrates that a BG-SOFC-CHP system is a viable and efficient solution for rural heating in Northern China. The performance is highly dependent on matching the system output to the specific load profiles of the users. Strategic heating of designated rooms (Scheme Two) proved to be the most economical and energy-efficient approach. Future work should address seasonal performance variations and the high initial capital cost of SOFC technology.

Summary updated

Abstract

In order to solve the environmental pollution problem caused by winter heating of rural residential building in northern of China, in this paper a biomass gasification (BG)-solid oxide fuel cell (SOFC) combined heat and power (CHP) system has been establishedand numerically investigated. Taking a rural village around Xi’an which is an ancient city and located at central of northern China as the study object, according to heat and electricity output of the system and the heating and electrical load characteristics of the residential building of village, the energy saving ratio and economical efficiency of the CHP system under three different operation schemes compared with the traditional energy system have been analyzed. The results show that the operation scheme for heating designated rooms in rural buildings and meeting the average heat demand of users is the most energy-efficient and economical way. The primary energy saving rate and annual cost saving rate can reach 18.0% and 10.3%, respectively. When the user’s heat and power load demand is clear, the closer the system’s output heat and power ratio to the user’s heat and power load ratio, the more significant the system’s energy saving effect.
BibTeX
@inproceedings{dang2021numerical,
  author = {Zheng Dang and Zhaoyi Jiang and Jinyan Ma and Xinmin Shen and Guang Xi},
  title = {{Numerical Study on the Performance of a Cogeneration System of Solid Oxide Fuel Cell Based on Biomass Gasification}},
  booktitle = {Frontiers in Energy Research},
  year = {2021},
  doi = {10.3389/fenrg.2021.609534},
}
Figure