Abstract
The increasing performance requirements of ultra-high-load low-pressure turbines have brought higher challenges to the blade angle of attack and Reynolds number adaptability. The leading edge geometrical parameters have a greater influence on the aerodynamic performance of the blade type. In order to investigate its influence on the blade angle of attack and Reynolds number adaptability, the PACK-B blade is taken as the research object, and the flow field analysis is carried out through numerical simulation for wide working conditions, and the blade design method of combining the leading edge radius with the leading edge wedge angle is adopted to reduce the blade loss. The results show that increasing the leading edge radius and leading edge wedge angle can reduce the loss at large positive angle of attack, while it is insensitive to the loss at negative angle of attack; the modified vane type has a strong improvement effect on the flow under wide operating conditions at high and low Reynolds numbers.
Introduction
In the pursuit of more efficient and lighter aircraft engines, engineers are increasingly turning to ultra-high-load low-pressure turbine (LPT) blades. These components are designed to deliver high work output with reduced weight. However, a significant drawback of ultra-high-load designs is their extreme sensitivity to variations in the Angle of Attack (AoA) and the Reynolds number (Re).
When operating outside their design point, these blades often experience massive flow separation on the suction surface. This separation creates stagnant air bubbles that significantly increase aerodynamic drag and reduce overall engine efficiency. This study investigates how modifying the leading-edge geometry—specifically the radius and wedge angle—can enhance the adaptability of the PACK-B turbine blade across a broad range of operating conditions.
Methodology
The research utilizes the PACK-B blade, a standard research profile for low-pressure turbines, as the baseline for geometric optimization.
Numerical simulations were performed using ANSYS CFX. To accurately capture the complex flow physics of LPTs, where the boundary layer often transitions from laminar to turbulent on the blade surface, the researchers employed the Gamma-Theta ($\gamma-\theta$) transition model coupled with the Shear Stress Transport (SST) model.
The numerical methodology was validated against experimental data from cascade test rig measurements. As shown in the validation plot, the SST model with the Gamma-Theta transition model provides the best agreement with experimental pressure coefficient ($C_p$) distributions, particularly in capturing the suction side pressure plateau associated with transition.
The study systematically varied two primary geometric parameters: the leading-edge radius ($l_e$) and the leading-edge wedge angle ($\alpha$).
Results and Discussion
The investigation revealed several key insights into the aerodynamic behavior of modified leading edges:
Asymmetry of Loss and the Buffer Effect
Turbine blades exhibit a marked asymmetry in their sensitivity to AoA. While they are relatively resilient to negative angles of attack, positive AoA (where air impacts the pressure side) leads to rapid flow separation on the suction side. Increasing the leading-edge radius acts as a "buffer," smoothing the pressure distribution near the stagnation point and delaying the onset of separation.
Coupled Geometric Optimization
The most significant performance gains were achieved by simultaneously increasing both the leading-edge radius and the wedge angle. For the PACK-B profile, an optimal configuration was found with a radius of 1.9 mm and a wedge angle of 62° (up from the baseline 1.1 mm and 42°). This modification shifts the stagnation point and reduces the peak velocity near the leading edge, which is crucial for maintaining attached flow at high positive AoA.
Reynolds Number Adaptability
At low Reynolds numbers, which are characteristic of high-altitude flight, the flow is more susceptible to separation due to increased effective viscosity. The modified leading-edge design demonstrated a "strong improvement effect" under these conditions, maintaining lower loss coefficients compared to the original geometry.
Conclusion
This study demonstrates that strategic modifications to leading-edge geometry can significantly improve the off-design performance of ultra-high-load turbine blades. By increasing the leading-edge radius and wedge angle, researchers successfully reduced aerodynamic losses at high positive angles of attack and low Reynolds numbers.
Future work will expand this research to include 3D cascade effects and unsteady flow simulations to better replicate the environment within a real rotating turbine stage. These findings provide a foundation for multi-objective optimization using advanced computational techniques like genetic algorithms.
Summary updated