Abstract
With the rapid development of technology and economy, rough machining has not been able to keep pace with the times. Heavy industry is more and more inclined to the field of precision and ultra-precision machining. During that time, abrasive flow machining technology emerged as the times require. The process of micro cutting is achieved through the contact between abrasive particles and workpiece, so that the accuracy of workpiece's inner surface can be polished, and the accuracy of workpiece improved, which is a representative polishing method. Taking the three-order variable diameter tube as the research object, this paper discusses the polishing characteristics of three level variable diameter pipe with solid liquid two phase abrasive flow. The removal pattern of abrasive flow micro cutting is analyzed, with the collision effect between abrasive particles and wall considered and ignored, which provides technical support for abrasive flow polishing variable diameter pipe parts.
Introduction
Precision and ultra-precision machining have become critical in modern heavy industry, surpassing the capabilities of traditional rough machining. Abrasive Flow Machining (AFM) has emerged as a leading technique for finishing internal surfaces of complex components. This process utilizes a pressurized mixture of fluid and abrasive particles, such as silicon carbide, to perform micro-cutting through contact with the workpiece walls. This paper investigates the polishing characteristics of a three-stage variable diameter pipe using solid-liquid two-phase abrasive flow, specifically analyzing how particle collision dynamics influence the removal pattern and overall efficiency.
Methodology
The study utilizes a 3D numerical simulation approach to model solid-liquid two-phase flow. A three-stage variable diameter pipe was modeled in SolidWorks to represent complex internal geometries. To ensure computational accuracy and convergence, the model was discretized using high-quality hexahedral grids. Mesh quality was verified using a determinant test, maintaining values above 0.5 to guarantee reliable results.
The simulation parameters included an inlet velocity of 30 m/s and a 10% concentration of Silicon Carbide (SiC) particles (density 3100 kg/m³) suspended in a carrier fluid (density 1260 kg/m³). The core of the study involved a comparative analysis between two distinct modeling scenarios: one ignoring particle-to-particle collisions and another incorporating these interactions to determine their impact on the polishing process.
Results and Discussion
The "Squeeze" Effect and Pressure Distribution
The simulations revealed a significant "squeeze" effect, where dynamic pressure increases as the pipe diameter decreases. This intensification of fluid kinetic energy in narrower sections enhances the micro-cutting action of the abrasive grains. Dynamic pressure reaches its maximum at the third and smallest stage of the pipe.
Impact of Particle Collisions and Geometry
A critical finding is the role of particle collisions. While the general flow patterns remained consistent across both models, the inclusion of collision dynamics resulted in significantly higher predicted dynamic pressures and particle fluxes, particularly in the narrower stages. In the initial large-diameter stage, the models yielded nearly identical results, but the discrepancy grew as the flow entered more constricted areas, suggesting that ignoring collisions leads to an underestimation of polishing power.
Furthermore, the study observed that particle flux is higher near the walls than in the center of the pipe during the first and second stages, which is ideal for polishing as the abrasive grains are concentrated where they are most needed. Particles also tended to accumulate at transition points between stages. These areas of diameter change experienced intensified collisions and irregular particle motion, which effectively aids the micro-cutting process on the internal surface. Finally, the researchers noted that tapered sections (where the pipe narrows) provide superior polishing effects compared to diffused sections (where it widens).
Conclusion
Numerical analysis confirms that accounting for particle collisions is essential for accurately modeling AFM in variable diameter components. Collisions significantly boost dynamic pressure and particle flux near the walls, particularly in constricted areas, thereby improving polishing efficiency. While these findings provide a robust theoretical foundation for optimizing AFM processes, future work should include experimental validation to confirm simulated pressure values and explore the effects of varying particle concentrations and more complex, non-linear geometries.
Summary updated