N-Doped Modified Graphene/Fe2O3 Nanocomposites as High-Performance Anode Material for Sodium Ion Storage

Yaowu Chen, Zhu Guo, Bangquan Jian, Cheng Zheng, Haiyan ZhangNanomaterials 2019 · DOI

TL;DR

This paper presents a novel nitrogen-doped graphene/Fe₂O₃ (N-GF-300) nanocomposite as a high-performance anode material for sodium-ion batteries and supercapacitors. By strategically doping graphene with nitrogen, the researchers significantly improved the electrical conductivity and structural stability of the Fe₂O₃ nanoparticles, leading to enhanced capacity, rate capability, and cycle life.

What Problem Does This Paper Address?

The growing demand for portable electronics and electric vehicles has spurred interest in high-performance electrical energy storage (EES) devices. Sodium-ion batteries (SIBs) and sodium-ion supercapacitors (SICs) are particularly attractive due to the abundance and low cost of sodium. However, a major hurdle for their widespread adoption is the poor performance of current anode materials, especially those based on conversion reactions like Fe₂O₃. These materials suffer from sluggish reaction kinetics, low Coulombic efficiency, and structural degradation during cycling, primarily due to their inherent low electrical conductivity and significant volume changes. This paper aims to overcome these limitations by developing a modified Fe₂O₃ anode material with improved electrochemical properties.

Methods

The researchers employed a multi-step synthesis process to create the N-GF-300 nanocomposite.

  1. Water Bath Synthesis: Graphene oxide (GO) and FeCl₃·6H₂O were mixed and reacted in a water bath, followed by reduction with hydrazine hydrate. This resulted in a graphene/Fe₂O₃ (GF) nanocomposite.
  2. Annealing (GF-300): The GF composite was annealed at 300 °C under an argon atmosphere to remove unstable microporous structures and improve its properties.
  3. Nitrogen Doping (N-GF-300): The GF-300 was further annealed at 600 °C in an ammonia atmosphere to dope nitrogen atoms into the graphene nanosheets.

The structural and morphological characterization involved:

  • FESEM/HRTEM: To observe the morphology and microstructure.
  • XRD: To determine the crystal structure.
  • Raman Spectroscopy: To analyze the structural features of graphene.
  • XPS: To investigate the surface chemistry and confirm nitrogen doping.
  • BET: To measure the specific surface area and pore size distribution.

Electrochemical performance was evaluated using:

  • Galvanostatic Charge-Discharge (GCD): To measure capacity and cycle performance.
  • Cyclic Voltammetry (CV): To study the reaction kinetics and reversibility.
  • Electrochemical Impedance Spectroscopy (EIS): To analyze the charge transfer resistance and overall impedance.

Datasets

Not discussed in the paper. The study focuses on the synthesis and electrochemical characterization of a novel material, rather than training or evaluating on existing datasets.

Key Insights and Ideas

  • Nitrogen Doping as a Game Changer: The introduction of nitrogen atoms into the graphene lattice was the key innovation. This doping significantly enhances the interaction between Fe₂O₃ nanoparticles and the graphene support.
  • Synergistic Effects: The nitrogen-doped graphene not only provides a conductive framework but also acts as a buffer for the volume expansion of Fe₂O₃ during cycling, preventing structural degradation.
  • Improved Kinetics: The enhanced electrical conductivity and increased reactive sites due to nitrogen doping lead to faster sodium ion diffusion and insertion/extraction, boosting rate capability.
  • Defect Engineering: Nitrogen doping introduces defects into the graphene structure, which can create more active sites for ion storage, contributing to higher capacity.
  • Dual Application Potential: The material demonstrates promising performance in both sodium-ion batteries and sodium-ion supercapacitors, highlighting its versatility.

Key Results

For Sodium-Ion Batteries (SIBs): * High Reversible Capacity: N-GF-300 delivered a remarkable reversible discharge capacity of 638 mAh g⁻¹ at a current density of 0.1 A g⁻¹. * Excellent Rate Capability: Even at a higher current density of 0.5 A g⁻¹, the material retained a substantial capacity of 428.3 mAh g⁻¹ after 100 cycles, demonstrating strong cyclability. * Improved Coulombic Efficiency: While not explicitly quantified in the abstract, the paper implies improved Coulombic efficiency due to better kinetics and stability.

For Sodium-Ion Supercapacitors (SICs): * High Energy and Power Density: An asymmetrical SIC (Graphene//N-GF-300) achieved a high energy density of 58 Wh kg⁻¹ at a power density of 1365 W kg⁻¹ in an organic electrolyte.

Electrochemical Impedance Spectroscopy (EIS) Insights: * Reduced Charge Transfer Resistance (Rct): The N-GF-300 electrode showed a significantly lower Rct (18.24 Ω) compared to GF (52.31 Ω) and GF-300 (40.17 Ω), confirming enhanced electrical conductivity.

Limitations and Future Work

Limitations: * The paper focuses on a specific Fe₂O₃ phase (likely α-Fe₂O₃ or γ-Fe₂O₃, though not explicitly stated for the final N-GF-300). Further exploration of other iron oxide phases might yield different results. * While the abstract mentions "potential feasibility," further long-term cycling studies and optimization of electrolyte composition could be beneficial for practical applications.

Future Work: * The authors suggest that the nitrogen doping approach is a general and effective technique for modifying carbon matrix composites for improved electrochemical storage. This opens avenues for applying this strategy to other metal oxides and carbon materials for various energy storage applications. * Further investigation into the precise role of different nitrogen species (pyridinic, pyrrolic, graphitic) and their impact on performance could lead to more targeted material design. * Scaling up the synthesis process for industrial applications would be a logical next step.

Summary updated

Abstract

Sodium-ion storage devices have received widespread attention because of their abundant sodium resources, low cost and high energy density, which verges on lithium-ion storage devices. Electrochemical redox reactions of metal oxides offer a new approach to construct high-capacity anodes for sodium-ion storage devices. However, the poor rate performance, low Coulombic efficiency, and undesirable cycle stability of the redox conversion anodes remain a huge challenge for the practical application of sodium ion energy storage devices due to sluggish kinetics and irreversible structural change of most conversion anodes during cycling. Herein, a nitrogen-doping graphene/Fe<sub>2</sub>O<sub>3</sub> (N-GF-300) composite material was successfully prepared as a sodium-ion storage anode for sodium ion batteries and sodium ion supercapacitors through a water bath and an annealing process, where Fe<sub>2</sub>O<sub>3</sub> nanoparticles with a homogenous size of about 30 nm were uniformly anchored on the graphene nanosheets. The nitrogen-doping graphene structure enhanced the connection between Fe<sub>2</sub>O<sub>3</sub> nanoparticles with graphene nanosheets to improve electrical conductivity and buffer the volume change of the material for high capacity and stable cycle performance. The N-GF-300 anode material delivered a high reversible discharge capacity of 638 mAh g<sup>-1</sup> at a current density of 0.1 A g<sup>-1</sup> and retained 428.3 mAh g<sup>-1</sup> at 0.5 A g<sup>-1</sup> after 100 cycles, indicating a strong cyclability of the SIBs. The asymmetrical N-GF-300//graphene SIC exhibited a high energy density and power density with 58 Wh kg<sup>-1</sup> at 1365 W kg<sup>-1</sup> in organic solution. The experimental results from this work clearly illustrate that the nitrogen-doping graphene/Fe<sub>2</sub>O<sub>3</sub> composite material N-GF-300 is a potential feasibility for sodium-ion storage devices, which further reveals that the nitrogen doping approach is an effective technique for modifying carbon matrix composites for high reaction kinetics during cycles in sodium-ion storage devices and even other electrochemical storage devices.
BibTeX
@inproceedings{chen2019n,
  author = {Yaowu Chen and Zhu Guo and Bangquan Jian and Cheng Zheng and Haiyan Zhang},
  title = {{N-Doped Modified Graphene/Fe2O3 Nanocomposites as High-Performance Anode Material for Sodium Ion Storage}},
  booktitle = {Nanomaterials},
  year = {2019},
  doi = {10.3390/nano9121770},
}
Figure