Modeling the Morphology and Phase Stability of TiO2Nanocrystals in Water

Amanda S. Barnard, Peter Zapol, Larry A. CurtissJournal of Chemical Theory and Computation 2004 · DOI

TL;DR

This paper models the shape and phase stability of titanium dioxide (TiO2) nanocrystals in water, finding that water significantly influences their morphology and shifts the anatase-to-rutile phase transition to larger sizes. This work highlights the critical need to consider surface hydration when predicting the behavior of nanomaterials.

What Problem Does This Paper Address?

Titanium dioxide (TiO2) is a crucial material for photocatalysis and other advanced applications, with its properties heavily dependent on its size, phase (anatase or rutile), and shape. While rutile is generally more stable in bulk, anatase is often the preferred phase for nanocrystals. Understanding the factors that control the anatase-to-rutile phase transition at the nanoscale is therefore critical. Previous work had established a thermodynamic model for TiO2 nanocrystals in a vacuum, but the behavior of these nanoparticles in aqueous environments, where they are often synthesized and used, remained less understood. Specifically, the impact of water adsorption on the surface energy, surface tension, and ultimately, the phase stability and morphology of TiO2 nanocrystals needed to be investigated.

Methods

The researchers employed a multi-pronged approach:

  • Density Functional Theory (DFT) Calculations: They used DFT with the Generalized Gradient Approximation (GGA) and the Perdew-Wang (PW91) functional, implemented within the Vienna Ab initio Simulation Package (VASP), to calculate the surface energies and surface tensions of low-index hydrated stoichiometric surfaces of anatase and rutile. This involved relaxing both clean and hydrated surfaces (with molecular and dissociative water adsorption) to determine the most energetically favorable configurations.
  • Thermodynamic Model: They extended their previously developed thermodynamic model for nanocrystals. This model relates the free energy of a nanocrystal to its bulk properties, surface energies, surface tensions, size, and shape. The model accounts for the influence of surface hydration by incorporating the calculated surface properties of hydrated surfaces.
  • Wulff Construction and Shape Optimization: The Wulff construction, a standard method for predicting equilibrium crystal shapes based on surface energies, was used as a starting point. They then performed a numerical optimization of the nanoparticle shape, considering the effects of surface tension, to find the lowest energy morphology as a function of size and the presence of water.

Datasets

Not discussed in the paper. The study relies on ab initio calculations rather than experimental datasets for training or evaluation.

Key Insights and Ideas

  • Water's Sculpting Power: Water is not just a passive solvent; it actively modifies the surface structure and energetics of TiO2 nanocrystals. This leads to changes in their equilibrium shapes.
  • Morphological Shifts: In anatase, water adsorption leads to variations in the size of the (001) and (001̄) truncation facets. For rutile, water reduces the aspect ratio, making the crystals less needle-like.
  • Phase Transition Shift: The presence of water significantly shifts the anatase-to-rutile phase transition to larger nanocrystal sizes. This implies that anatase is more stable in aqueous environments than in a vacuum.
  • Surface Passivation is Key: The study underscores that the specific chemical environment at the nanocrystal surface (in this case, water) plays a crucial role in determining phase stability, not just the termination of undercoordinated sites.

Key Results

  • Surface Properties: The paper provides a consistent set of surface energies and surface tensions for hydrated low-index surfaces of anatase and rutile, calculated using DFT.
  • Morphology Changes:
    • For anatase, the optimized B/A ratio (related to truncation facet size) was found to be smaller in water (0.30) compared to vacuum (0.32) for small nanocrystals.
  • For rutile, the presence of water reduced the aspect ratio, leading to less elongated shapes.
  • Phase Transition Size:
    • In a vacuum, the anatase-to-rutile phase transition was predicted to occur at approximately 9.6 nm (around 12,600 TiO2 units).
  • In water, this transition size increased to approximately 15.1 nm (around 52,580 TiO2 units). This is in good agreement with experimental observations for hydrothermal samples.

Limitations and Future Work

  • Model Applicability: The thermodynamic model used is most applicable to faceted nanocrystals in the size range of 2-100 nm. For very small nanoparticles (< 2 nm), explicit calculations of isolated nanoparticles are preferred.
  • Temperature Effects: The calculations were performed at T=0 K. While the authors suggest temperature effects on surface free energy are small, further investigation into temperature's impact on phase stability could be valuable.
  • pH Effects: The study focused on neutral water. The authors note that further work is underway to examine the effects of pH on the phase transition size and shape, which is a crucial aspect for many applications.
  • Other Solvents/Environments: The model could be extended to explore the behavior of TiO2 nanocrystals in other solvents or chemical environments.

Summary updated

Abstract

The potential of titanium dioxide nanoparticles for advanced photochemical applications has prompted a number of studies to analyze the size, phase, and morphology dependent properties. Previously we have used a thermodynamic model of nanoparticles as a function of size and shape to predict the phase stability of titanium dioxide nanoparticles, with particular attention given to the crossover of stability between the anatase and rutile phases. This work has now been extended to titanium dioxide nanoparticles in water, to examine the effects of various adsorption configurations on the equilibrium shape and the phase transition. Density functional calculations have been used to accurately determine surface energies and surface tension of low index hydrated stoichiometric surfaces of anatase and rutile, which are presented along with a brief outline of the surface structure. We have shown that morphology of TiO2 nanocrystals is affected by the presence of water, resulting in variations in the size of the (001) and (001̄) truncation facets in anatase, and a reduction in the aspect ratio of rutile nanocrystals. Our results also highlight that the consideration of hydrated nanocrystal surfaces is necessary to accurately predict the correct size dependence of the anatase to rutile phase transition.
BibTeX
@article{barnard2004modeling,
  author = {Amanda S. Barnard and Peter Zapol and Larry A. Curtiss},
  title = {{Modeling the Morphology and Phase Stability of TiO<sub>2</sub>Nanocrystals in Water}},
  journal = {Journal of Chemical Theory and Computation},
  year = {2004},
  doi = {10.1021/ct0499635},
}
Figure