Mitigation of relative intensity noise of Quantum Dash mode-locked lasers for PAM4 based optical interconnects using encoding techniques

Vidak Vujicic, Aravind P. Anthur, Arsalan Saljoghei, Vivek Panapakkam, Rui Zhou, Quentin Gaimard, Kamel Merghem, Francois Lelarge, Abderrahim Ramdane, Liam P. BarryarXiv 2016 · arXiv

Introduction: The Challenge of Low-Frequency Noise

As data centers strive to meet ever-increasing bandwidth demands, 4-level Pulse Amplitude Modulation (PAM4) has become a critical signaling technique, doubling the data rate per symbol compared to traditional non-return-to-zero (NRZ) formats. To scale these systems efficiently, researchers are looking toward Quantum Dash (Q-Dash) Passively Mode-Locked Lasers (PMLLs). These devices act as "comb" sources, generating dozens of stable optical carriers from a single laser chip, which could significantly reduce the complexity and power consumption of multi-channel transceivers.

However, Q-Dash lasers are plagued by high Relative Intensity Noise (RIN) at low frequencies (typically below 4 GHz), primarily due to Mode Partition Noise (MPN). Because PAM4 relies on four distinct amplitude levels, it is exceptionally sensitive to such fluctuations. This noise often pushes the Bit Error Rate (BER) above the Forward Error Correction (FEC) threshold, rendering these efficient lasers unusable for high-speed interconnects without mitigation.

Characterization of the Q-Dash PMLL: (a) optical comb spectrum, (b) RF beat note, and (c, d) RIN spectra showing significant noise at low frequencies.

Methodology: Digital Line Coding as a Solution

Instead of employing complex and expensive optical hardware to stabilize the laser, this study explores the use of digital line coding to mitigate noise. The strategy is to reshape the signal's power spectrum to avoid the high-noise region of the laser. Two primary encoding schemes were evaluated:

  1. 8B/10B Encoding: A standard telecommunications code that maps 8-bit data to 10-bit symbols, ensuring DC balance and creating a "spectral notch" at very low frequencies.
  2. Manchester Encoding: A more aggressive scheme where every bit contains a transition, effectively shifting the signal's energy further away from DC and creating a wider low-frequency notch.

The experimental setup utilized a 33.6 GHz Q-Dash PMLL producing approximately 40 optical carriers. A 28 GBaud PAM4 signal was transmitted over 3 km of standard single-mode fiber (SSMF) and analyzed using a real-time oscilloscope for offline digital signal processing (DSP).

Power spectral density (PSD) comparison of standard PAM4 versus 8B/10B and Manchester encoded versions, demonstrating the creation of a low-frequency spectral notch.

Key Insights: The Spectral Notch Strategy

The effectiveness of these codes lies in their ability to "hide" the data signal in frequency bands where the laser is relatively quiet. As shown in the power spectral density measurements, both 8B/10B and Manchester encoding suppress the signal power at low frequencies. This reduces the overlap between the PAM4 signal and the laser's high-intensity RIN, thereby improving the signal-to-noise ratio (SNR) at the receiver.

While these codes introduce overhead—20% for 8B/10B and 50% for Manchester—the trade-off is often necessary to achieve reliable transmission. For many high-density interconnect applications, the ability to use a single comb source for 40+ channels outweighs the loss in per-channel spectral efficiency.

Experimental Results and Performance

The study benchmarked the Q-Dash laser performance against a high-end, low-noise External Cavity Laser (ECL).

  • Uncoded PAM4: Most channels from the Q-Dash comb performed poorly, with BERs frequently exceeding the 7% FEC limit ($3.8 \times 10^{-3}$).
  • 8B/10B PAM4: The introduction of the spectral notch allowed the majority of the 40 channels to move safely below the FEC threshold.
  • Manchester PAM4: This scheme provided an order-of-magnitude improvement in BER. All channels performed exceptionally well, showing only a ~2 dB power penalty compared to the "gold standard" ECL benchmark.

Conclusion and Future Outlook

This research demonstrates that digital line coding is a viable and cost-effective method for mitigating the inherent noise of Q-Dash mode-locked lasers. By shifting the signal spectrum away from low-frequency RIN, reliable PAM4 transmission can be achieved across dozens of optical carriers.

Future work will focus on developing more rate-efficient codes that maintain sufficient low-frequency suppression while reducing overhead. Additionally, implementing these encoding steps in real-time CMOS hardware (ASICs or FPGAs) will be a critical step toward commercializing Q-Dash-based optical transceivers for next-generation data centers.

Summary updated

Abstract

Quantum Dash (Q-Dash) Passively Mode-Locked Lasers (PMLLs) exhibit significant low frequency Relative Intensity Noise (RIN), due to the high Mode Partition Noise (MPN), which prevents the implementation of multilevel amplitude modulation formats such as PAM4. The authors demonstrate low frequency RIN mitigation by employing 8B/10B and Manchester encoding with PAM4 modulation format. These encoding techniques reduce the overlap between the modulation spectral content and the low-frequency RIN of the Q-Dash devices, at the expense of increased overhead. The RIN of the 33.6 GHz free spectral range Q-Dash PMLL was characterized, and the results obtained show very high levels of RIN from DC to 4 GHz, but low levels for higher frequencies. The performance improvement for 28 GBaud 8B/10B and Manchester encoded PAM4 signal has been demonstrated compared to the case when no encoding is used. Finally, the effect of RIN on the system performance was demonstrated by comparing the Bit Error Rate (BER) performance of the PAM4 signaling obtained with an External Cavity Laser (ECL) to those obtained with Q-Dash PMLL.
BibTeX
@misc{vujicic2016mitigation,
  author = {Vidak Vujicic and Aravind P. Anthur and Arsalan Saljoghei and Vivek Panapakkam and Rui Zhou and Quentin Gaimard and Kamel Merghem and Francois Lelarge and Abderrahim Ramdane and Liam P. Barry},
  title = {{Mitigation of relative intensity noise of Quantum Dash mode-locked lasers for PAM4 based optical interconnects using encoding techniques}},
  year = {2016},
  eprint = {1612.00271},
  archivePrefix = {arXiv},
  url = {https://arxiv.org/abs/1612.00271},
}
Figure