Method of Carrier Acquisition and Track for HAPS

Mingxiang Guan, Fang Yuan, Xueyuan Wan, Weizhi ZhongCommun. Netw 2010 · DOI

Abstract

This paper emphasizes on the characteristics and schemes of carrier acquisition and track in high dynamic and high information-rate situation. Carrier acquisition model is analyzed theoretically and the design principle of carrier acquisition is deduced and described clearly. An algorithm for carrier acquisition in high dynamic and high information-rate situation is provided. This paper also proves the validity of the algorithm and design scheme in high dynamic and high information-rate situation.

Introduction

High Altitude Platform Stations (HAPS) serve as stratospheric relay stations, positioned approximately 20km above the Earth. They combine the low latency of terrestrial towers with the wide coverage of satellites. However, HAPS communication faces significant challenges due to high mobility, which induces massive Doppler shifts and rapid phase changes—the "high dynamic" problem. Coupled with the demand for high information rates, traditional carrier tracking loops often fail to maintain signal lock. This paper addresses these challenges by proposing a robust carrier acquisition and tracking algorithm.

Methodology

The proposed scheme is derived from Maximum Likelihood (ML) estimation and Differential Quadrature Phase Shift Keying (DQPSK) demodulation principles. The architecture, illustrated in Figure 1, utilizes a non-linear $N$-power process to recover the carrier from suppressed carrier QPSK signals.

Figure 1: Block diagram of the proposed carrier acquisition and tracking system architecture.

The system splits the sampled signal into In-phase ($I$) and Quadrature ($Q$) paths. A control signal ($S_{AFC}$), acting as a correction factor for the local Numerical Control Oscillator (NCO), is defined based on the cross-product of current and previous signal samples. This signal passes through a loop filter to drive the NCO frequency toward zero error, ensuring the local reference signal matches the incoming carrier.

Results and Discussion

The DQPSK-based method was evaluated via simulation against the Extended Kalman Filter (EKF) method. Simulation parameters included a 10.7 MHz carrier frequency and dynamic frequency offsets ranging from 200 Hz to 400 Hz.

Figure 2: Comparison of phase offset estimation performance between the proposed DQPSK method and the EKF method against the real phase offset.

As shown in Figure 2, the DQPSK method demonstrates a significantly tighter fit to the "real phase offset" compared to the EKF. While EKF is often considered a standard for estimation, its complexity can be a bottleneck in high-dynamic scenarios. The proposed algorithm maintained its lock even when frequency shifts doubled, demonstrating rapid recovery (tracking variations in less than 20 data time units) and high convergence speed.

Conclusion

The study demonstrates that a DQPSK-derived approach offers superior performance and lower hardware complexity for HAPS carrier tracking compared to traditional EKF methods. Its efficiency makes it highly suitable for engineering implementation on FPGA or ASIC hardware. Future work will focus on real-world testing to account for atmospheric turbulence and performance under low Signal-to-Noise Ratio (SNR) conditions.

Summary updated

BibTeX
@article{guan2010method,
  author = {Mingxiang Guan and Fang Yuan and Xueyuan Wan and Weizhi Zhong},
  title = {{Method of Carrier Acquisition and Track for HAPS}},
  journal = {Commun. Netw},
  year = {2010},
  doi = {10.4236/cn.2010.22015},
}
Figure