MD simulation of tool wear behaviour based on changes of tool rake and flank angle caused by diamond tool position adjustment
Lists
Only you see this
Abstract
A new method for adjusting the tool rake and flank angles by changing the position of the tools was used to explore the behaviour of wear using MD simulation. In this paper, a new improved tool was used and found to have lower wear compared to conventional tools. Simulations under the same cutting conditions were carried out using a tool swinging to six different rake angles of six different adjustment angles. Further analysis of the influence of different adjustment angles on the wear behaviour of the tool by cutting force, friction coefficient, temperature, radial distribution function and wear rate was conducted. The highest normal force was observed with the tool swung to −15°, and the tangential force did not produce any significant changes. The friction coefficients were also not observed as a linear change with the increasing angle of adjustment. At the same time, the particularities and differences at −15° were illustrated, from the most intuitive tool flank wear images. Finally, the causes of this phenomenon were further explained in terms of temperature and radial distribution function and the correctness of this phenomenon was proved, which is different from previous researches.
BibTeX
@inproceedings{wang2018md,
author = {Ming Hai Wang and Si Yao You and Fu Ning Wang and Qi Liu},
title = {{MD simulation of tool wear behaviour based on changes of tool rake and flank angle caused by diamond tool position adjustment}},
booktitle = {Molecular},
year = {2018},
doi = {10.1080/08927022.2018.1559309},
}Loading related content...