<title>Sodium beacon laser system for the Lick Observatory</title>

Herbert W. Friedman, Gaylen V. Erbert, Thomas C. Kuklo, Joseph Salmon, David A. Smauley, Gary R. Thompson, Jody G. Malik, Jen Nan Wong, V. Keith Kanz, Kurt P. NeebProceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE 1995 · DOI

TL;DR

This paper details the installation and performance of a 20 W sodium beacon laser system for the Lick Observatory's 3-meter Shane telescope. This system is crucial for adaptive optics, enabling ground-based telescopes to achieve diffraction-limited imaging by creating an artificial "guide star" in the mesosphere.

What Problem Does This Paper Address?

Ground-based telescopes are limited by atmospheric turbulence, which distorts incoming light, blurring images and reducing resolution. Adaptive optics (AO) systems can correct for these distortions, but they require a reference point to measure the atmospheric aberrations. Traditionally, this reference is a natural guide star, but these are not always available in the desired location or bright enough. The solution is to create an artificial "guide star" using a laser that excites sodium atoms in the mesosphere, creating a bright, localized source. This paper addresses the practical challenges of integrating such a laser system onto a large telescope, focusing on its design, installation, and initial performance.

Methods

The system utilizes a 20 W sodium beacon laser, where the dye laser amplifiers are located directly on the telescope for precise pointing. To manage heat and complexity, the pump lasers and waveform generator are housed remotely. Optical fibers are used to deliver the pump light and control signals, minimizing the need for complex beam directors. The system includes a comprehensive diagnostics and alignment (D&A) table, featuring a wavefront sensor (Shack-Hartmann) to measure wavefront aberrations and a high-speed tilt stage for real-time correction. The D&A table is designed to ensure beam quality and stability before propagation.

Datasets

Not discussed in the paper.

Key Insights and Ideas

  • Remote Pumping for Thermal Management: Locating pump lasers and waveform generators away from the telescope dome significantly simplifies thermal management, a critical factor for high-power laser systems.
  • Fiber Optic Delivery: The use of optical fibers for pump light and signal transmission is key to enabling remote laser component placement and simplifying integration.
  • On-Board Diagnostics are Crucial: The paper emphasizes the importance of a comprehensive suite of on-board diagnostics (wavefront sensor, pointing/centering cameras) for rapid beam acquisition and reduced downtime, especially for valuable telescope time.
  • Off-Axis Propagation Trade-offs: While coaxial propagation of the laser beam would be ideal, the paper concludes that off-axis propagation introduces only a small, acceptable degradation in wavefront fitting error (0.01 Strehl units).

Key Results

  • The 20 W sodium beacon laser system has been successfully installed on the 3 m Shane telescope.
  • The system has demonstrated an output power of 20 W with amplitude stability of ±5% over several hours.
  • The measured wavefront quality is approximately 1/7 wave (rms), which is expected to yield a Strehl ratio of about 45% in the mesosphere.
  • The laser operates at a pulse duration of 100 ns (FWHM), with a peak power intensity below the saturation flux of sodium atoms.

Limitations and Future Work

The paper acknowledges that the final bore-sight alignment of the laser launch telescope to the 3 m telescope has been delayed due to poor weather and limited telescope access. Consequently, they have not yet been able to acquire the sodium guide star in the telescope's acquisition camera to measure its diameter or return signal. Future work will focus on completing this alignment and integrating the laser system with an existing adaptive optics package (Hartmann wavefront sensor, deformable mirror, etc.) to create the first closed-loop sodium-layer guide star AO system. The authors also suggest that closed-loop control systems could be applied to the waveform generator to extend adjustment periods.

Summary updated

Abstract

The installation and performance characteristics of a 20 W sodium beacon laser system for the 3 m Shane telescope at the Lick Observatory are presented.
BibTeX
@inproceedings{friedman1995lt,
  author = {Herbert W. Friedman and Gaylen V. Erbert and Thomas C. Kuklo and Joseph Salmon and David A. Smauley and Gary R. Thompson and Jody G. Malik and Jen Nan Wong and V. Keith Kanz and Kurt P. Neeb},
  title = {{\<title\>Sodium beacon laser system for the Lick Observatory\</title\>}},
  booktitle = {Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE},
  year = {1995},
  doi = {10.1117/12.217734},
}
Figure