Abstract
High-precision navigation systems increasingly rely on fiber optic gyroscopes (FOGs) for their reliability and lack of moving parts. However, achieving ultra-low noise floors is often hindered by Relative Intensity Noise (RIN), which is inversely proportional to the spectral width of the light source. This paper proposes and experimentally demonstrates a low-noise closed-loop FOG driven by a super broadband light source (SBLS) composed of two superluminescent diodes (SLDs) operating at different wavelengths (1310nm and 1550nm). By effectively tripling the spectral width, the researchers achieved a significant reduction in RIN. The system incorporates a customized multifunction integrated optical circuit (MIOC) and a polarization-maintaining photonic crystal fiber (PCF) coil, resulting in superior bias stability and noise performance compared to traditional single-source FOGs.
The Challenge: Overcoming the RIN Noise Floor
In the quest for higher precision in inertial navigation, FOGs face a fundamental "noise floor." While increasing the power of the light source can help mitigate thermal and shot noise, it simultaneously exacerbates Relative Intensity Noise (RIN)—the inherent power fluctuations or "flicker" of the light source. In high-performance FOGs, RIN is typically the dominant noise contributor.
Because RIN is inversely proportional to the spectral width of the light source, standard superluminescent diodes (SLDs) with bandwidths of 40–60nm are limited in their noise-reduction potential. To push past this limit, a significantly wider spectrum is required, which is difficult to achieve with a single semiconductor diode.
System Architecture and Methodology
The researchers addressed this limitation by developing a "Super Broadband Light Source" (SBLS) architecture. Instead of relying on a single diode, the system combines two separate sources—one centered at 1310nm and another at 1550nm—using a Wavelength Division Multiplexer (WDM). This approach creates an equivalent source with a massive effective bandwidth exceeding 150nm.
As shown in the system schematic above, the light from the SBLS passes through a Dual Window Coupler (DWC) and into a customized Multifunction Integrated Optical Circuit (MIOC). The MIOC is designed to operate efficiently across both wavelength windows. A critical challenge in this dual-wavelength setup is the dispersion of the MIOC’s half-wave voltage ($V_\pi$). The team theoretically modeled and experimentally verified that the relationship between wavelength and $V_\pi$ is highly linear, allowing the digital closed-loop control system to maintain precise phase modulation across the entire broad spectrum.
The Super Broadband Advantage
By combining the 1310nm and 1550nm SLDs, the authors achieved a total spectral bandwidth of 151.99nm. This "bandwidth hack" provides a physical mechanism to suppress noise that cannot be easily addressed through electronic filtering alone.
To ensure stable propagation of these two widely separated wavelengths, the sensing coil utilizes 1km of polarization-maintaining Photonic Crystal Fiber (PCF). Standard optical fibers are typically optimized for a specific wavelength; a fiber designed for 1550nm might support multiple spatial modes at 1310nm, which would introduce significant errors. PCF, however, supports "endless single-mode" propagation, maintaining a single spatial mode across the entire operating range of the SBLS.
Key Results and Performance Metrics
The experimental dual-source FOG demonstrated substantial improvements over single-source configurations across all primary performance metrics:
- Noise Reduction: The Angle Random Walk (ARW), the primary measure of white noise in a gyro, was reduced to $1.7 \times 10^{-4} \text{ deg/h}^{1/2}$. This represents a 2.5x improvement over single-source benchmarks ($4.2–4.6 \times 10^{-4} \text{ deg/h}^{1/2}$).
- Bias Stability: The long-term bias drift (1$\sigma$, 100s) improved to $8.848 \times 10^{-4} \text{ deg/h}$, significantly better than the $\sim 2.3 \times 10^{-3} \text{ deg/h}$ seen in single-source setups.
- Scale Factor Integrity: Despite the complexity of managing two distinct wavelength bands, the scale factor nonlinear error remained excellent at 1.682 ppm, confirming that the broader spectrum does not compromise the sensor's fundamental accuracy.
Conclusion and Future Outlook
This work demonstrates that a dual-source SBLS approach is a highly effective method for depressing RIN and achieving ultra-low noise in closed-loop FOGs. While the current implementation increases system complexity by requiring dual drivers and specialized optical components, the performance gains are significant for high-end navigation applications. Future research may focus on integrating this optical bandwidth expansion with electronic RIN subtraction techniques to further push the boundaries of inertial sensing precision.
Summary updated