Abstract
This study proposes a method for adjusting the loss peak in the spectrum of long period fiber gratings (LPFGs) fabricated with a CO$_2$ laser. By applying longitudinal tension using calibrated weights during the fabrication process, the loss peak can be precisely tuned to suit multi-point temperature sensing applications in high-temperature environments. Experimental results demonstrate an increase of 5.3 dB in the loss peak value with a 150 g weight. Crucially, this adjustment method has minimal impact on the temperature sensitivity of the LPFG across a range from room temperature to 800°C.
Introduction
Long Period Fiber Gratings (LPFGs) are vital components for sensing in extreme environments, such as industrial plants or oil wells. They function by attenuating specific wavelengths, creating characteristic "loss peaks" in the optical spectrum. A significant challenge in deploying these sensors is "multiplexing" — connecting multiple LPFGs in series on a single fiber. For effective multiplexing, each sensor must have a distinct and sufficiently deep loss peak to prevent signal overlap and ensure data integrity. Traditional methods for adjusting these peaks are often complex or require transverse loading. This research introduces a simplified technique to tune the loss peak depth (resonant loss) by applying mechanical longitudinal tension during the CO$_2$ laser fabrication process.
Methods
The LPFGs were fabricated by inducing periodic refractive index changes in a standard SMF-28 fiber using a CO$_2$ laser. The experimental setup for fabrication and real-time adjustment is shown in Figure 1.
To adjust the loss peak, longitudinal tension was applied to the fiber using weights ranging from 12.8 g to 150 g. The optical spectrum was monitored continuously using a broadband light source (BLS) and an optical spectrum analyzer (OSA). The study employed a mathematical model to correlate physical fiber stretching with changes in the coupling coefficient and resonant loss ($L_R$).
To evaluate the stability and sensitivity of these sensors under operational conditions, the LPFGs were placed in a furnace and heated up to 800°C. The setup for these thermal tests is illustrated in Figure 2.
Results and Discussion
The experimental data from seven distinct LPFG samples revealed a nearly linear relationship between the applied weight and the increase in loss peak depth, with a tuning rate of approximately 0.035 dB/g. A maximum signal boost of 5.3 dB was achieved with a 150 g weight. However, mechanical reliability tests involving 22 trials indicated that 100 g (yielding a 3.7 dB adjustment) is the practical safety limit for long-term operation, as the rupture rate was 0% at this level but rose to 5% at 150 g.
A key finding is the decoupling of tension-based adjustment and temperature sensitivity. The temperature coefficient remained remarkably stable at approximately 0.106 nm/°C across various tension levels. This allows engineers to strengthen the sensor signal without significantly altering the thermal response characteristics. Furthermore, the sensors remained functional and accurate up to 800°C, demonstrating that CO$_2$ laser-induced gratings offer superior thermal stability compared to traditional ultraviolet-written gratings.
One trade-off identified is a slight "red shift" in the resonant wavelength ($\lambda_R$) caused by the tension. A 150 g weight induced a shift of approximately 0.5 nm. While small, this shift must be accounted for during the design phase to avoid a temperature measurement error (roughly 4.2°C at room temperature) if not properly calibrated.
Conclusion
This study demonstrates a reliable and straightforward method for fine-tuning LPFG loss peaks using longitudinal tension during CO$_2$ laser fabrication. The technique enables the creation of robust, multiplexed sensors for high-temperature environments up to 800°C. The stability of the temperature sensitivity despite the applied tension makes this a practical solution for industrial sensing. Future work will focus on the long-term fatigue effects of constant tension on fiber integrity during extended thermal cycling.
Summary updated