Long-haul optical transmission link using low-noise phase-sensitive amplifiers

Samuel L. I. Olsson, Henrik Eliasson, Egon Astra, Magnus Karlsson, Peter A. AndreksonNature Communications 2018 · DOI

TL;DR

This paper demonstrates a novel long-haul optical transmission link that utilizes phase-sensitive amplifiers (PSAs) to simultaneously reduce amplifier noise and mitigate fiber nonlinearities. This breakthrough leads to a significant 5.6-fold improvement in transmission reach compared to conventional systems, pushing the boundaries of optical communication capacity.

What Problem Does This Paper Address?

The fundamental limits of long-haul optical communication systems are dictated by two primary factors: amplifier noise and nonlinear effects within the optical fiber. Conventional amplifiers, like Erbium-Doped Fiber Amplifiers (EDFAs), introduce a certain level of noise that degrades the signal over long distances. Furthermore, as optical signals travel through fiber, they interact with each other and the fiber material, leading to nonlinear distortions that corrupt the data. While phase-sensitive amplifiers (PSAs) have been theoretically known to offer lower noise figures (up to 6 dB better than conventional amplifiers) and the potential for nonlinearity mitigation, integrating them into a practical, long-haul transmission link that leverages both benefits simultaneously has remained a significant challenge. This paper tackles this challenge by demonstrating the first such functional long-haul link.

Methods

The core innovation lies in the implementation of a recirculating loop experiment that simulates a long-haul transmission link. The key component is the "copier-PSA" scheme, which uses a fiber optical parametric amplifier (FOPA). In the first round trip, the FOPA acts as a "copier," generating an idler wave that is a phase-conjugated copy of the input signal. This idler wave is then used in subsequent round trips, where the FOPA functions as a phase-sensitive amplifier (PSA).

The PSA operation is based on a degenerate pump, two-mode configuration. This means an intense pump wave interacts with a signal and its idler. The PSA amplifies the signal while deamplifying its idler quadrature, effectively squeezing the signal's phase. Crucially, this process not only amplifies the signal with lower noise but also inherently mitigates nonlinear distortions.

The experimental setup involved a 10 GBd Quadrature Phase-Shift Keying (QPSK) signal. The recirculating loop consisted of an 80 km standard single-mode fiber (SSMF) span, dispersion compensating modules (DCMs), and the PSA. For benchmarking, the system was also configured with conventional EDFAs and a FOPA operating in a phase-insensitive amplification (PIA) mode. A sophisticated polarization tuning and pump recovery stage was employed to maintain the necessary optical conditions for PSA operation over multiple round trips.

Datasets

Not discussed in the paper. The paper focuses on experimental demonstration rather than training on large datasets.

Key Insights and Ideas

  • Dual Benefit of PSAs: The most significant insight is the successful demonstration that PSAs can indeed provide simultaneous low-noise amplification and nonlinearity mitigation in a practical long-haul link. This dual functionality is the key to unlocking extended transmission reach.
  • Unprecedented Nonlinear Tolerance: The PSA-amplified link exhibited a remarkable tolerance to nonlinear effects, accumulating a total nonlinear phase shift of 6.2 radians. This is reported as the highest nonlinear tolerance ever achieved in a lumped-amplifier system.
  • Modulation Format and Channel Independence: The copier-PSA scheme is inherently modulation-format-independent and multi-channel compatible, paving the way for its application in future high-capacity optical networks that utilize advanced modulation formats and wavelength division multiplexing (WDM).
  • The "Copier" as a Foundation: The ingenious use of the FOPA as a "copier" in the initial round trip to generate the necessary idler wave is a critical enabler for the subsequent PSA operation.

Key Results

  • Reach Improvement: The PSA-amplified link achieved a 5.6-fold improvement in transmission reach compared to a link using conventional EDFAs, when compared at optimal launch powers. Even when comparing at the same launch power (6 dBm), the reach improvement was approximately six times.
  • Nonlinear Phase Shift: The PSA-amplified link operated with a total accumulated nonlinear phase shift of 6.2 radians, demonstrating superior nonlinear tolerance.
  • Signal and Idler Power: The PSA-amplified link transmitted two data-carrying waves (signal and idler), effectively doubling the bandwidth and propagating twice the total power compared to the phase-insensitively amplified link.
  • BER Performance: Bit error rate (BER) measurements showed significantly improved performance for the PSA case, allowing for more round trips (and thus longer distances) before the error rate exceeded the 10⁻³ threshold.

Limitations and Future Work

  • Pump Recovery and Polarization Alignment: The paper acknowledges that in a real transmission link, challenges remain regarding the pump recovery mechanism (requiring a feedback system to track frequency differences) and polarization alignment of the involved waves (requiring active polarization tracking).
  • Multi-channel Complexity: While the copier-PSA scheme is multi-channel compatible, implementing it for multiple channels will increase complexity due to the need for precise polarization, delay, and phase alignment for each channel.
  • Symbol Rate and Modulation Format: While the scheme is modulation-format-independent, further investigation is needed to understand how symbol rate and specific modulation formats might affect nonlinearity mitigation capabilities.
  • Future Directions: The authors suggest that approaches like distributed Raman amplification or optimized dispersion maps could further enhance nonlinearity mitigation at higher symbol rates. They also highlight the potential of cascaded PSAs for applications in quantum information science.

Summary updated

Abstract

The capacity and reach of long-haul fiber optical communication systems is limited by in-line amplifier noise and fiber nonlinearities. Phase-sensitive amplifiers add 6 dB less noise than conventional phase-insensitive amplifiers, such as erbium-doped fiber amplifiers, and they can provide nonlinearity mitigation after each span. Realizing a long-haul transmission link with in-line phase-sensitive amplifiers providing simultaneous low-noise amplification and nonlinearity mitigation is challenging and to date no such transmission link has been demonstrated. Here, we demonstrate a multi-channel-compatible and modulation-format-independent long-haul transmission link with in-line phase-sensitive amplifiers. Compared to a link amplified by conventional erbium-doped fiber amplifiers, we demonstrate a reach improvement of 5.6 times at optimal launch powers with the phase-sensitively amplified link operating at a total accumulated nonlinear phase shift of 6.2 rad. The phase-sensitively amplified link transmits two data-carrying waves, thus occupying twice the bandwidth and propagating twice the total power compared to the phase-insensitively amplified link.
BibTeX
@inproceedings{olsson2018long,
  author = {Samuel L. I. Olsson and Henrik Eliasson and Egon Astra and Magnus Karlsson and Peter A. Andrekson},
  title = {{Long-haul optical transmission link using low-noise phase-sensitive amplifiers}},
  booktitle = {Nature Communications},
  year = {2018},
  doi = {10.1038/s41467-018-04956-5},
}
Figure