Abstract
Rod-like cellulose nanocrystals (CNRs) can self-organize into chiral nematic liquid crystals owing to their anisotropy character. Unexpectedly, sphere-like cellulose nanocrystals (CNSs) have been observed to form a chiral liquid crystalline phase also. Herein, to understand how the similar assembly takes place as the particle dimension changes, the organization features of the CNSs were investigated. It reveals that CNSs organize into a liquid-crystal phase constituted by periodically parallel-aligned layer-structure above a critical concentration in suspension, the structure of which remains after drying. Compared with CNRs, the CNSs alignment shows short layer distance, low order degree, and weak long-range orientation. Considering the lower surface charge and the spherical appearance, a “knot-like” model, captured by “freezing” the CNSs suspension in an intermediate aggregation state, is proposed for the early stage of tactoid formation. Such structure acts as the fundamental unit to achieve the liquid-crystal assembly further.
Introduction
Cellulose nanocrystals (CNCs) are sustainable, high-stiffness building blocks used to create advanced optical materials. For decades, the prevailing wisdom has been that their ability to form lyotropic liquid crystals—phases that are liquid but possess long-range molecular order—depends on their rod-like shape (anisotropy). When these rods align, they create "chiral nematic" structures that reflect specific wavelengths of light, resulting in characteristic iridescence.
However, recent observations have shown that even sphere-like cellulose nanocrystals (CNSs) can form these ordered phases. This is counterintuitive, as isotropic particles typically lack a preferred orientation for alignment. This study investigates the mechanisms behind CNS assembly, comparing them directly to rod-shaped nanocrystals (CNRs) to determine how particle geometry influences final material properties.
Materials and Methods
The researchers synthesized three distinct morphologies from cotton pulp using sulfuric acid hydrolysis: Large aspect ratio rods (LCNRs), small aspect ratio rods (SCNRs), and sphere-like nanocrystals (CNSs) with an average diameter of approximately 78 nm.
Characterization was performed using a suite of high-resolution imaging and scattering techniques. Morphology was assessed via TEM, SEM, and AFM. Wide-angle X-ray Diffraction (WAXD) was employed to confirm the crystallinity of the samples. For the CNSs, a high crystallinity of 91% was recorded, calculated using the standard Crystallinity Index (CrI) formula.
Phase behavior was tracked using Polarized Optical Microscopy (POM) and Dynamic Light Scattering (DLS). To observe the intermediate stages of assembly, the team utilized a "frozen state" technique: CNS suspensions were mixed into a polyacrylamide (PAAm) monomer solution, and UV light was used to trigger rapid polymerization. This process locked the intermediate CNS structures in a hydrogel matrix, allowing for SEM imaging without the distortions caused by standard drying.
Results and Discussion
The "Knot-like" Assembly Model
The most significant finding is the proposed "knot-like" assembly mechanism for spheres. Unlike rods that align side-by-side, CNSs first form small, dense clusters or "knots." These knots then act as the fundamental building blocks that organize into periodically parallel-aligned layers. This behavior is attributed to the lower surface charge of CNSs compared to rods, which reduces electrostatic repulsion and allows attractive van der Waals forces to dominate at short ranges.
Concentration and Phase Transition
The study identified critical concentration thresholds for CNS assembly. Below 1 wt.%, CNSs remain isolated. Between 2-4 wt.%, they exhibit flow birefringence, indicating ordering under shear. Above 5 wt.%, the suspension spontaneously forms a biphasic liquid crystalline state. Rheological analysis of a 6 wt.% CNS suspension showed a "three-region" viscosity behavior (shear thinning followed by a plateau and further shear thinning), which is a classic signature of liquid crystal phase separation.
Structural and Optical Properties
CNSs successfully organized into a chiral nematic-like phase with distinct fingerprint textures under polarized light. However, compared to rod-based assemblies, CNS films exhibited:
- Shorter Layer Distance: Resulting in a "blue shift" of reflected light (approximately 415 nm).
- Lower Degree of Order: Weaker long-range orientation and more discontinuous fingerprint patterns.
- Improved Uniformity: CNS films showed almost no "coffee-ring" effect, leading to more uniform optical properties across the film surface compared to CNRs.
Conclusion
This research demonstrates that spherical cellulose nanocrystals can overcome their isotropic shape to form ordered liquid crystalline phases via a unique "knot-like" intermediate state. While the long-range orientation in CNS films is currently weaker than that of their rod-shaped counterparts, the discovery of this assembly pathway opens new possibilities for sustainable optical materials. Future work will focus on improving global alignment through controlled flow dynamics and environmental conditions, potentially leading to new classes of responsive sensors and optical filters.
Summary updated