Layer Number Dependence of MoS2 Photoconductivity Using Photocurrent Spectral Atomic Force Microscopic Imaging

Young‐Woo Son, Qing Hua Wang, Joel A. Paulson, C. K. Shih, Ananth Govind Rajan, Kevin Tvrdy, Sojin Kim, Bassam Alfeeli, Richard D. Braatz, Michael S. StranoACS 2015 · DOI

TL;DR

This paper uses a novel photocurrent spectral atomic force microscopy (PCS-AFM) technique to map the electrical and optoelectronic properties of molybdenum disulfide (MoS₂) nanosheets as a function of their layer number. They reveal a complex interplay between tunneling barriers and light absorption that dictates photoconductivity, offering crucial insights for designing next-generation 2D electronic and optoelectronic devices.

What Problem Does This Paper Address?

Atomically thin molybdenum disulfide (MoS₂) is a promising material for electronics and optoelectronics due to its unique 2D quantum confinement effects. However, a critical gap in understanding exists regarding how its optoelectronic properties, particularly at metal-semiconductor junctions, scale with the number of layers. Furthermore, the spatial uniformity of these properties across a MoS₂ flake and how they are affected by the nanoscale interface with metal contacts remained largely unaddressed. This lack of understanding hinders the rational design and optimization of MoS₂-based devices.

Methods

The researchers employed a sophisticated technique called Photocurrent Spectral Atomic Force Microscopy (PCS-AFM). This method combines the high spatial resolution of Atomic Force Microscopy (AFM) with the ability to measure both dark current and photocurrent under varying illumination wavelengths. Specifically:

  • Conductive AFM (C-AFM): Used to map the current flow between a conductive PtIr-coated AFM tip and the MoS₂ nanosheet under applied bias voltages. This allowed for the characterization of dark current transport.
  • Photocurrent Spectral AFM (PCS-AFM): Extended C-AFM by illuminating the sample with a supercontinuum laser filtered to specific wavelengths. This enabled the measurement of photocurrent and its spectral dependence.
  • Spatially Resolved I-V Curves: By sweeping the bias voltage across different regions of the MoS₂ flake, thousands of local current-voltage (I-V) curves were generated simultaneously with topographic imaging. This provided unprecedented detail on spatial variations.
  • Raman Spectroscopy: Used to accurately determine the number of MoS₂ layers in different regions of the sample.
  • 2D Fourier Analysis: Applied to topographic and current images to analyze spatial frequency variations and understand the nature of the tip-sample contact.

This approach is novel in its ability to simultaneously probe layer-dependent electronic and optoelectronic properties with nanoscale resolution on a single, continuous MoS₂ flake, avoiding the complexities and potential damage associated with fabricating individual devices.

Datasets

The paper does not describe the use of pre-existing datasets for training or evaluation. Instead, the authors generated their own experimental data by performing measurements on exfoliated MoS₂ nanosheets of varying layer thicknesses (from 1 to 20 layers) on an Indium Tin Oxide (ITO)-coated glass substrate.

Key Insights and Ideas

  • Fowler-Nordheim Tunneling Dominance: Dark current measurements revealed a diode-like behavior well-described by Fowler-Nordheim (FN) tunneling. This suggests that carrier transport at the nanoscale MoS₂-metal junction is primarily governed by tunneling through a barrier.
  • Linear Scaling of Tunneling Barrier: The effective tunneling barrier height was found to scale linearly with the number of MoS₂ layers. This provides a predictable way to tune the electronic properties by controlling layer thickness.
  • Non-monotonic Photoconductivity: The photocurrent response showed a surprising trend: it decreased for the first few layers (up to 4 layers) but then increased again for thicker layers. This is a key finding that challenges simple expectations.
  • Competition Between Barrier and Absorption: The authors propose a model where the non-monotonic photoconductivity arises from a competition between an increasing tunneling barrier (which hinders carrier collection) and increasing light absorption (which generates more carriers) as the layer number increases.
  • Direct vs. Indirect Bandgap Impact: Monolayer MoS₂ (1L), with its direct bandgap, exhibited the highest photoresponse due to more efficient photoexcitation, even though its tunneling barrier was low.
  • Spatial Inhomogeneity: 2D Fourier analysis revealed spatial variations in the MoS₂/substrate contact that exceeded those imposed by the substrate itself, suggesting subtle crinkling or imperfect contact at the nanoscale.

Key Results

  • Effective Barrier Height: The effective barrier height for FN tunneling was found to be approximately 0.61 eV for a monolayer, scaling linearly with layer number.
  • Photocurrent Minimum: A minimum in photocurrent was observed around 4 layers of MoS₂, attributed to the interplay of barrier height and light absorption.
  • Layer Number Dependence: The photoresponse ratio (normalized to the 4L value) was approximately 15:4:2:1:4 for 1L, 2L, 3L, 4L, and 10L, respectively, highlighting the significant impact of layer number.
  • Barrier Symmetry: The 1L MoS₂ regions showed symmetric photoresponse with respect to bias voltage, while 2L, 3L, and 4L regions exhibited noticeable asymmetry.
  • Sublinear Power Dependence: Photocurrent showed a sublinear dependence on incident laser power (exponents ranging from 0.56 to 0.67), attributed to exciton-exciton annihilation (EEA) in atomically thin MoS₂.

Limitations and Future Work

  • Model Simplifications: The proposed model for photoresponse assumes an effective bias voltage increase due to photoexcitation and a change in effective barrier height. While it captures the trend, further refinement might be needed for precise quantitative predictions.
  • Tip-Sample Contact Variability: While efforts were made to ensure stable tip-sample contact, the paper acknowledges that small amounts of crinkling in the MoS₂ flake under the scanning tip can lead to more variable electrical contact and current inhomogeneity.
  • Future Work: The authors suggest that their findings provide a fundamental understanding of layer-number-dependent electronic and optoelectronic behavior at the nanoscale MoS₂-metal junction. This knowledge can be leveraged for the selection of appropriate metals and the precise control of MoS₂ layer numbers to achieve a wide range of electrical property modulation for future device applications. Further investigation into the role of exciton dynamics and their interaction with tunneling barriers could also be fruitful.

Summary updated

Abstract

Atomically thin MoS2 is of great interest for electronic and optoelectronic applications because of its unique two-dimensional (2D) quantum confinement; however, the scaling of optoelectronic properties of MoS2 and its junctions with metals as a function of layer number as well the spatial variation of these properties remain unaddressed. In this work, we use photocurrent spectral atomic force microscopy (PCS-AFM) to image the current (in the dark) and photocurrent (under illumination) generated between a biased PtIr tip and MoS2 nanosheets with thickness ranging between n = 1 to 20 layers. Dark current measurements in both forward and reverse bias reveal characteristic diode behavior well-described by Fowler-Nordheim tunneling with a monolayer barrier energy of 0.61 eV and an effective barrier scaling linearly with layer number. Under illumination at 600 nm, the photocurrent response shows a marked decrease for layers up to n = 4 but increasing thereafter, which we describe using a model that accounts for the linear barrier increase at low n, but increased light absorption at larger n creating a minimum at n = 4. Comparative 2D Fourier analysis of physical height and photocurrent images shows high spatial frequency spatial variations in substrate/MoS2 contact that exceed the frequencies imposed by the underlying substrates. These results should aid in the design and understanding of optoelectronic devices based on quantum confined atomically thin MoS2.
BibTeX
@inproceedings{son2015layer,
  author = {Young‐Woo Son and Qing Hua Wang and Joel A. Paulson and C. K. Shih and Ananth Govind Rajan and Kevin Tvrdy and Sojin Kim and Bassam Alfeeli and Richard D. Braatz and Michael S. Strano},
  title = {{Layer Number Dependence of MoS<sub>2</sub> Photoconductivity Using Photocurrent Spectral Atomic Force Microscopic Imaging}},
  booktitle = {ACS},
  year = {2015},
  doi = {10.1021/nn506924j},
}
Figure