Abstract
In this work, the kinetics of oxidation of Ethylenediamine and Ethanolamine by Potassium Ferrate (VI) has been studied by using stop –flow spectrometer under alkaline media. The results show that the oxidation-reduction reaction is a first-order to reactant and a negative fraction order to [OH-]. A convincing mechanism involving a slow response as the rate-controlling step is proposed and the rate equations derived from the mechanism was shown to fit all the experimental observations. The rate constants of the rate-controlling step and the thermodynamic activation parameters were calculated.
Introduction
Ethylenediamine (EDA) and ethanolamine (EA) are critical industrial chemicals used in detergents, corrosion inhibitors, and various chemical syntheses. However, they are also significant pollutants; ethanolamine waste, in particular, possesses a high Chemical Oxygen Demand (COD) that can overwhelm biological sewage treatment systems. Potassium Ferrate (VI) is an attractive "green" oxidant for treating such waste because it is highly potent and reduces to harmless iron oxides. This study investigates the reaction kinetics and mechanism to resolve whether Fe(VI) oxidation proceeds via a single-electron or a two-electron transfer.
Methods
The researchers employed stopped-flow spectrophotometry to monitor the reaction in real-time at a wavelength of 508 nm, where Fe(VI) has a characteristic absorption peak. The experiments were conducted in alkaline media (pH ~9.90) with an ionic strength maintained at 0.8 mol/L using $KNO_3$. To simplify the kinetic modeling, "pseudo-first-order" conditions were used, where the concentration of the organic reductant (EDA or EA) was significantly higher than that of Fe(VI). Temperature was varied between 283.2 K and 303.2 K to determine thermodynamic activation parameters.
Kinetic Analysis and Results
The experimental data confirmed that the reaction follows first-order kinetics with respect to both the Fe(VI) oxidant and the organic reductant. As illustrated in Figure 1, the observed rate constant ($k_{obs}$) increases linearly with the concentration of Ethylenediamine across the range of temperatures studied.
Furthermore, the reaction exhibited a "negative fractional order" with respect to hydroxide ions ($[OH^-]$). This indicates that higher alkalinity inhibits the reaction rate, likely because $OH^-$ competes with the formation of the active monoprotonated ferrate species ($HFeO_4^-$), which is the primary oxidant even in basic conditions.
Thermodynamic Activation Parameters
The study calculated the activation energy ($E_a$), enthalpy of activation ($\Delta H^\ddagger$), and entropy of activation ($\Delta S^\ddagger$) for both compounds. These parameters are summarized in the following table:
The negative entropy of activation (-100.75 J/K·mol for EDA and -127.88 J/K·mol for EA) suggests a more ordered transition state, consistent with the formation of an intermediate complex between the iron center and the organic molecule during the rate-controlling step.
Discussion and Mechanism
At 298.2 K, the rate constant for EDA ($5.77 \times 10^{-4} \text{ mol}^{-1}\text{L s}^{-1}$) is more than double that of EA ($2.68 \times 10^{-4} \text{ mol}^{-1}\text{L s}^{-1}$). This difference is attributed to the lower electronegativity of nitrogen compared to oxygen, making electron transfer easier from the amino groups in EDA. Additionally, EDA has two amino groups, doubling the statistical probability of an effective collision with a ferrate molecule. The derived rate equations and experimental fit strongly support a mechanism involving a two-electron transfer, providing clarity on the fundamental pathway of Fe(VI) oxidation.
Conclusion
This study provides a definitive kinetic framework for the oxidation of common industrial pollutants by Potassium Ferrate (VI). While the mechanism and reaction orders are now well-defined, future research should focus on identifying the specific organic degradation products to ensure that no harmful intermediates remain after treatment.
Summary updated