Kinematic analysis of a rotary dobby heald frame considering multiple clearance joints
Lists
Only you see this
Abstract
Based on the working principle of a rotary dobby lifting mechanism, this paper investigates the typical four-link mechanism in a heald lifting setup. The Monte Carlo method is used to simulate the generation of clearance size, while the kinematic equations of the rotary dobby machine motion transfer mechanism, considering multiple clearance joints, are established. First, a method to measure the reliability index of the mechanism is proposed and the influence of clearance position and size, on the kinematic performance of the mechanism, is quantitatively analyzed. Following, the influence of different numbers of clearances on the chaos phenomenon of the mechanism is investigated, using the Poincare mapping diagrams, while the motion state of the mechanism, at different rotational speeds with the pin in the shaft sleeve, is analyzed. Finally, the influence of the size of the clearance, considering the case of three clearances, is focused on the investigation of the motion accuracy of the heald frame. The results of the study show that, the existence of multiple clearance joints leads to lower output motion accuracy of the rotary dobby heald frame; at the same time, the use of reliability measures proves that the motion stability of the mechanism deteriorates, as the clearance size increases; the increase in the number of clearances and in the rotational speed of the mechanism result in quasi-periodic and chaos phenomena, regarding the kinematic characteristics of the mechanism. Therefore, in order to ensure the motion accuracy of the mechanism, operating at high speed and with multiple clearances, the clearance size should be minimized.
BibTeX
@article{dong2024kinematic,
author = {Yongchun Dong and Haoran Sun and Hongbin Yu and Yang Liu},
title = {{Kinematic analysis of a rotary dobby heald frame considering multiple clearance joints}},
journal = {Journal of Textile Engineering},
year = {2024},
doi = {10.4188/jte.231115a},
}Loading related content...