Interference Analysis of QAM based Filter Bank Multicarrier System with Index Modulation

Adnan Zafar, Aijun Cao, Mahmoud Abdullahi, Lei Zhang, Pei Xiao, Muhammad Ali ImranarXiv 2018 · DOI · arXiv

Abstract

Index modulation (IM) has recently emerged as a promising concept for spectrum and energy-efficient next generation wireless communications systems since it strikes a good balance among error performance, complexity, and spectral efficiency. IM technique, when applied to multicarrier waveforms, yields the ability to convey the information not only by M-ary signal constellations as in conventional multicarrier systems but also by the indexes of the subcarriers, which are activated according to the incoming bit stream. Although IM is well studied for OFDM based systems, FBMC with index modulation has not been thoroughly investigated. In this paper, we shed light on the potential and implementation of IM technique for QAM based FBMC system. We start with a mathematical model of the IM based QAM-FBMC system (FBMC/QAM-IM) along with the derivation of interference terms at the receiver due to channel distortions and noise. The interference terms including the ones introduced by the multipath channel are analyzed in terms of MSE and output SINR. It is shown with analytical and simulation results that the interference power in FBMC/QAM-IM is smaller compared to that of the conventional FBMC/QAM system as some of the subcarriers are inactive. The performance of FBMC/QAM with IM is investigated by comparing the SIR and output SINR with that of the conventional FBMC/QAM system along with the BER performance which shows that the FBMC/QAM-IM is a promising transmission technique for future wireless networks.

Introduction

As the demand for higher data rates in wireless communications grows, researchers are exploring alternatives to the standard Orthogonal Frequency Division Multiplexing (OFDM) used in 4G and Wi-Fi. While OFDM is effective, its high side-lobe levels lead to spectral leakage, necessitating guard bands that reduce spectral efficiency. Filter Bank Multicarrier (FBMC) systems offer a solution by using well-designed filters to achieve much lower out-of-band emissions. However, FBMC systems, particularly those using Quadrature Amplitude Modulation (QAM), face challenges with intrinsic interference when subjected to multipath fading.

This paper proposes a hybrid approach: FBMC/QAM-IM, which integrates Index Modulation (IM) into the FBMC/QAM framework. Index modulation conveys information not just through the symbols themselves, but through the specific pattern of active subcarriers. This "on/off" signaling inherently reduces total interference power because inactive subcarriers do not contribute to the interference floor.

System Architecture and Methodology

The proposed FBMC/QAM-IM system splits the incoming bitstream into two parts. One part determines the indices of the active subcarriers within a block, while the other part maps bits to M-ary QAM symbols for those active subcarriers.

Figure 1: Block diagram of the proposed FBMC/QAM-IM transmitter architecture.

As shown in the transmitter architecture (Figure 1), the bit splitter organizes data into groups. For each group of $n$ subcarriers, only $k$ are activated. The "saved" power from the $n-k$ inactive subcarriers is redistributed to the active ones, enhancing the signal-to-noise ratio (SNR) for those specific symbols without increasing the overall transmit power.

At the receiver, a Log-Likelihood Ratio (LLR) detector is employed. While Maximum Likelihood (ML) detection is theoretically optimal, it is computationally prohibitive for real-time systems. The LLR detector offers a low-complexity alternative that achieves near-ML performance.

Interference Analysis

A key contribution of this work is the rigorous mathematical derivation of interference components in the FBMC/QAM-IM system. The authors identify and model four primary sources of degradation:

  1. MMSE Estimation Bias: Errors arising from the receiver's channel equalization process.
  2. Filter Distortion: Interference caused by the interaction between the multipath channel and the FBMC synthesis/analysis filters.
  3. Inter-Block Interference (IBI): Leakage between consecutive data blocks.
  4. Additive White Gaussian Noise (AWGN): Standard background thermal noise.

The analysis demonstrates that by keeping a fraction of subcarriers inactive, the total interference power is reduced by approximately the ratio $k/n$.

Key Results and Performance Comparison

The performance of the FBMC/QAM-IM system was evaluated through Monte Carlo simulations over a quasi-static Rayleigh fading channel.

Figure 6: Performance analysis showing individual MSE components and comparisons of total MSE and SINR between FBMC/QAM and FBMC/QAM-IM.

As illustrated in Figure 6, the FBMC/QAM-IM system consistently outperforms the conventional FBMC/QAM system:

  • MSE Reduction: For a (4,3) configuration (3 active subcarriers out of 4), the Mean Square Error (MSE) is reduced by approximately 1.25 dB compared to the conventional system.
  • SINR Improvement: The Signal-to-Interference-plus-Noise Ratio (SINR) is significantly higher for the IM-based system, especially at high SNR levels where interference becomes the dominant limiting factor.
  • Component Analysis: The individual MSE component plots (Figure 6, left side) show that while noise decreases linearly with SNR, other interference terms like filter distortion and IBI eventually create a performance floor. The IM technique effectively lowers this floor.

Conclusion

The integration of Index Modulation into FBMC/QAM systems provides a robust mechanism for mitigating intrinsic interference in multipath environments. By utilizing subcarrier indices to carry information, the system achieves better MSE and SINR performance than conventional multicarrier techniques. While the current study focuses on quasi-static channels, future research could extend this framework to high-mobility scenarios and Multiple-Input Multiple-Output (MIMO) configurations to further enhance spectral efficiency for 5G and beyond.

Summary updated

Abstract

Index modulation (IM) has recently emerged as a promising concept for spectrum and energy-efficient next generation wireless communications systems since it strikes a good balance among error performance, complexity, and spectral efficiency. IM technique, when applied to multicarrier waveforms, yields the ability to convey the information not only by M-ary signal constellations as in conventional multicarrier systems but also by the indexes of the subcarriers, which are activated according to the incoming bit stream. Although IM is well studied for OFDM based systems, FBMC with index modulation has not been thoroughly investigated. In this paper, we shed light on the potential and implementation of IM technique for QAM based FBMC system. We start with a mathematical model of the IM based QAM-FBMC system (FBMC/QAM-IM) along with the derivation of interference terms at the receiver due to channel distortions and noise. The interference terms including the ones introduced by the multipath channel are analyzed in terms of MSE and output SINR. It is shown with analytical and simulation results that the interference power in FBMC/QAM-IM is smaller compared to that of the conventional FBMC/QAM system as some of the subcarriers are inactive. The performance of FBMC/QAM with IM is investigated by comparing the SIR and output SINR with that of the conventional FBMC/QAM system along with the BER performance which shows that the FBMC/QAM-IM is a promising transmission technique for future wireless networks.
BibTeX
@misc{zafar2018interference,
  author = {Adnan Zafar and Aijun Cao and Mahmoud Abdullahi and Lei Zhang and Pei Xiao and Muhammad Ali Imran},
  title = {{Interference Analysis of QAM based Filter Bank Multicarrier System with Index Modulation}},
  year = {2018},
  eprint = {1804.04770},
  archivePrefix = {arXiv},
  url = {https://arxiv.org/abs/1804.04770},
}
Figure