Haze pollution under a high atmospheric oxidization capacity in summer in Beijing: insights into formation mechanism of atmospheric physicochemical processes

Dandan Zhao, Guangjing Liu, Xin Jin, Jiannong Quan, Yuesi Wang, Xin Wang, Lindong Dai, Wenkang Gao, Guiqian Tang, Bo Hu, Yongxiang Ma, Xiaoyan Wu, Lili Wang, Zirui Liu, Fangkun WuAtmospheric 2020 · DOI

Abstract

Under a high atmospheric oxidization capacity, the synergistic effect of the physicochemical processes in the atmospheric boundary layer (ABL) caused summer haze pollution in Beijing. The southern and southwestern areas, generally 60–300 km away from Beijing, were seriously polluted in contrast to Beijing, which remained clean. Southerly winds moving faster than 20–30 km h⁻¹ since the early morning primarily caused haze pollution initiation. The PM$_{2.5}$ level increased to 75 µg m⁻³ over several hours during the daytime, which was simultaneously affected by the ABL structure. Additionally, the O$_3$ concentration was quite high during the daytime (250 µg m⁻³), corresponding to a high atmospheric oxidation capacity. Much sulfate and nitrate were produced through active atmospheric chemical processes, with sulfur oxidation ratios (SORs) up to ∼0.76 and nitrogen oxidation ratios (NORs) increasing from 0.09 to 0.26, which further facilitated particulate matter (PM) level enhancement. However, the increase in sulfate was mainly linked to southerly transport. At midnight, the PM$_{2.5}$ concentration sharply increased from 75 to 150 µg m⁻³ over 4 h and remained at its highest level until the next morning. Under an extremely stable ABL structure, secondary aerosol formation dominated by nitrate was quite intense, driving the haze pollution outbreak. The PM levels in the southern and southeastern areas of Beijing were significantly lower than those in Beijing at this time, even below air quality standards; thus, the contribution of pollution transport had almost disappeared. With the formation of a nocturnal stable boundary layer (NSBL) at an altitude ranging from 0–0.3 km, the extremely low turbulence kinetic energy (TKE) ranging from 0 to 0.05 m² s⁻² inhibited the spread of particles and moisture, ultimately resulting in elevated near-surface PM$_{2.5}$ and relative humidity (∼90 %) levels. Due to the very high humidity and ambient oxidization capacity, NOR rapidly increased from 0.26 to 0.60, and heterogeneous hydrolysis reactions at the moist particle surface were very notable. The nitrate concentration steeply increased from 11.6 to 57.8 µg m⁻³, while the sulfate and organics concentrations slightly increased by 6.1 and 3.1 µg m⁻³, respectively. With clean and strong winds passing through Beijing, the stable ABL dissipated with the potential temperature gradient becoming negative and the ABL height (ABLH) increasing to ∼2.5 km. The high turbulence activity with a TKE ranging from 3 to 5 m² s⁻² notably promoted pollution diffusion. The self-cleaning capacity of the atmosphere is commonly responsible for air pollution dispersion. However, reducing the atmospheric oxidization capacity, through strengthening collaborative control of nitrogen oxide (NO$_x$) and volatile organic compounds (VOCs), as well as continuously deepening regional joint air pollution control, is urgent.

Introduction

Despite stringent emission controls that have successfully lowered annual PM$_{2.5}$ levels in China, Beijing still experiences severe summer haze episodes. These episodes often coincide with high concentrations of ground-level ozone (O$_3$). This paper investigates the "perfect storm" of physical and chemical conditions that lead to these events, demonstrating that while regional transport initiates pollution, the "explosive" growth of fine particulate matter is driven by intense local nitrate chemistry occurring within a stable, shallow nighttime atmosphere.

Methodology and Data

The study utilized a comprehensive suite of ground-based and remote sensing instruments at the Institute of Atmospheric Physics (IAP) in Beijing during July 2019.

Map of the study region in Beijing (BJ) and the suite of observational instruments used, including lidar, radiometers, and chemical monitors.

Key measurement techniques included:

  • Chemical Speciation: An Aerosol Chemical Speciation Monitor (ACSM) and a Multiangle Absorption Photometer (MAAP) measured real-time PM$_{2.5}$ components (organics, sulfate, nitrate, ammonium, and black carbon).
  • Vertical Profiling: A 3D Doppler wind lidar, a microwave radiometer, and a ceilometer provided data on wind vectors, temperature/humidity profiles, and the atmospheric boundary layer height (ABLH).
  • Regional Monitoring: Hourly data from over 1,000 stations across China provided regional context for PM$_{2.5}$, O$_3$, NO$_2$, and SO$_2$ levels.

Key Insights: The Two-Stage Mechanism

Haze formation in Beijing follows a distinct two-stage process:

  1. Occurrence Stage: Dominated by southerly transport, bringing sulfate and moisture from regions 60–300 km away. During this stage, PM$_{2.5}$ levels typically rise to approximately 75 µg m⁻³.
  2. Outbreak Stage: A local chemical "explosion" where nitrate levels skyrocket. High daytime O$_3$ (peaking at 250 µg m⁻³) acts as a chemical primer, creating an environment rich in radicals that convert NO$_x$ from vehicle exhaust into nitrate aerosols.

At night, a Nocturnal Stable Boundary Layer (NSBL) forms, trapping moisture and pollutants in a shallow (~300m) layer with low Turbulence Kinetic Energy (TKE). Under high humidity (~90%), nitrogen pentoxide (N$_2$O$_5$) reacts on moist particle surfaces—a process known as heterogeneous hydrolysis—driving the midnight PM$_{2.5}$ spikes.

Results

  • Explosive Growth: PM$_{2.5}$ concentrations jumped from 75 to 150 µg m⁻³ in only 4 hours during the outbreak stage.
  • Nitrate Dominance: Nitrate was the primary driver of the outbreak, with concentrations increasing from 11.6 to 57.8 µg m⁻³. The Nitrogen Oxidation Ratio (NOR) more than doubled, from 0.26 to 0.60.
  • Dispersion: Haze dissipated when the ABL became unstable. Strong winds (6–9 m s⁻¹) and high turbulence (TKE of 3–5 m² s⁻²) pushed the ABLH up to 2.5 km, diluting pollutants.

Conclusion and Policy Implications

The study highlights that reducing primary particle emissions alone is insufficient. To prevent these toxic episodes, regional, collaborative control of NO$_x$ and VOCs is urgent to lower the atmosphere's overall oxidation capacity. Future work should address the data gap regarding Volatile Organic Compounds (VOCs) to better understand Secondary Organic Aerosol (SOA) formation.

Summary updated

Abstract

Under a high atmospheric oxidization capacity, the synergistic effect of the physicochemical processes in the atmospheric boundary layer (ABL) caused summer haze pollution in Beijing. The southern and southwestern areas, generally 60–300 km away from Beijing, were seriously polluted in contrast to Beijing, which remained clean. Southerly winds moving faster than 20–30 km h−1 since the early morning primarily caused haze pollution initiation. The PM2.5 (particulate matter with a dynamic equivalent diameter smaller than 2.5 µm) level increased to 75 µg m−3 over several hours during the daytime, which was simultaneously affected by the ABL structure. Additionally, the O3 concentration was quite high during the daytime (250 µg m−3), corresponding to a high atmospheric oxidation capacity. Much sulfate and nitrate were produced through active atmospheric chemical processes, with sulfur oxidation ratios (SORs) up to ∼0.76 and nitrogen oxidation ratios (NORs) increasing from 0.09 to 0.26, which further facilitated particulate matter (PM) level enhancement. However, the increase in sulfate was mainly linked to southerly transport. At midnight, the PM2.5 concentration sharply increased from 75 to 150 µg m−3 over 4 h and remained at its highest level until the next morning. Under an extremely stable ABL structure, secondary aerosol formation dominated by nitrate was quite intense, driving the haze pollution outbreak. The PM levels in the southern and southeastern areas of Beijing were significantly lower than those in Beijing at this time, even below air quality standards; thus, the contribution of pollution transport had almost disappeared. With the formation of a nocturnal stable boundary layer (NSBL) at an altitude ranging from 0–0.3 km, the extremely low turbulence kinetic energy (TKE) ranging from 0 to 0.05 m2 s−2 inhibited the spread of particles and moisture, ultimately resulting in elevated near-surface PM2.5 and relative humidity (∼90 %) levels. Due to the very high humidity and ambient oxidization capacity, NOR rapidly increased from 0.26 to 0.60, and heterogeneous hydrolysis reactions at the moist particle surface were very notable. The nitrate concentration steeply increased from 11.6 to 57.8 µg m−3, while the sulfate and organics concentrations slightly increased by 6.1 and 3.1 µg m−3, respectively. With clean and strong winds passing through Beijing, the stable ABL dissipated with the potential temperature gradient becoming negative and the ABL height (ABLH) increasing to ∼2.5 km. The high turbulence activity with a TKE ranging from 3 to 5 m2 s−2 notably promoted pollution diffusion. The self-cleaning capacity of the atmosphere is commonly responsible for air pollution dispersion. However, reducing the atmospheric oxidization capacity, through strengthening collaborative control of nitrogen oxide (NOx) and volatile organic compounds (VOCs), as well as continuously deepening regional joint air pollution control, is urgent.
BibTeX
@inproceedings{zhao2020haze,
  author = {Dandan Zhao and Guangjing Liu and Xin Jin and Jiannong Quan and Yuesi Wang and Xin Wang and Lindong Dai and Wenkang Gao and Guiqian Tang and Bo Hu and Yongxiang Ma and Xiaoyan Wu and Lili Wang and Zirui Liu and Fangkun Wu},
  title = {{Haze pollution under a high atmospheric oxidization capacity in summer in Beijing: insights into formation mechanism of atmospheric physicochemical processes}},
  booktitle = {Atmospheric},
  year = {2020},
  doi = {10.5194/acp-20-4575-2020},
}
Figure