Fe(II)-activated persulfate oxidation to degrade iopamidol in water: parameters optimization and degradation paths

Zijun Dong, Guanhan Chen, Mu Li, Feiyun Sun, Chengchun Jiang, Bandna BhartiScientific 2020 · DOI

Abstract: Iodinated contrast media (ICM), which was widely used in medical imaging and was difficult to remove by conventional wastewater treatment methods, attained much attention due to its potential environmental impacts. Herein, iopamidol (IPM), one typical compound of ICM, was found to be rapidly degraded by ferrous activated persulfate oxidation (Fe(II)/PS) as compared with PS or Fe(II) alone. With a persulfate concentration of 1 mmol L<sup>-1</sup>, n(Fe(II))/n(PS) of 1:10, and a pH of 3.0, 78% IPM was degraded within 60 min, with a degradation rate of 0.1266 min<sup>-1</sup>. It was demonstrated that IPM degradation and deiodination were favored by a high temperature, while affected positively by acidic and neutral conditions. Radical quenching experiments and Electron Paramagnetic Resonace (EPR) spectra showed that the combined effects of SO<sub>4</sub><sup>-</sup>· and ·OH contributed dominantly to degrade IPM, while the ·OH played an essential role during the degradation reaction. Through the Discrete Fourier Transform quantum chemical calculation, the possible reaction pathways for the oxidation of IPM by ·OH are as follows: IPM-TP651-TP667-TP541-TP557, IPM-TP651-TP525-TP557, IPM-TP705-TP631-TP661, and IPM-TP705-TP735. The obtained results showed that IPM could be degraded effectively by Fe(II)/PS system, giving a promising technique for IPM removal from water.

Introduction: The Challenge of Recalcitrant Contrast Media

Iodinated contrast media (ICM), such as iopamidol (IPM), are indispensable in modern medical diagnostics. However, their widespread use has led to their detection in aquatic environments, where they prove remarkably resistant to conventional wastewater treatment processes. While IPM itself possesses low direct toxicity, it serves as a precursor to highly genotoxic and cytotoxic iodinated disinfection by-products (I-DBPs) during water chlorination. Developing efficient Advanced Oxidation Processes (AOPs) to eliminate IPM at the source is therefore critical for protecting water quality.

Methodology: Harnessing Radical Power

This study investigates the efficacy of a ferrous iron-activated persulfate (Fe(II)/PS) system for IPM degradation. In this process, Fe(II) catalyzes the decomposition of persulfate (PS) to generate potent oxidizing species: sulfate radicals ($SO_4^{−}·$) and hydroxyl radicals ($·OH$).

The research team optimized the system by systematically varying PS concentration, Fe(II):PS molar ratios, pH, and temperature. To elucidate the underlying mechanisms, radical quenching experiments and Electron Paramagnetic Resonance (EPR) spectroscopy were employed. Furthermore, Density Functional Theory (DFT) calculations were used to predict transformation products (TPs) and map the degradation pathways.

Key Insights: Synergy and Mechanism

A primary finding of the study is the dramatic synergy between Fe(II) and persulfate. While neither reagent alone achieves significant IPM removal, their combination creates a highly reactive environment capable of rapid degradation.

Synergy of the Fe(II)/PS system and the corresponding formation of inorganic iodate over time.

Quenching experiments and EPR spectra identified that while both $SO_4^{−}·$ and $·OH$ contribute to the reaction, the hydroxyl radical ($·OH$) plays the dominant role in IPM degradation within this specific Fe(II)/PS setup. The system's performance is highly pH-dependent, showing optimal efficiency under acidic conditions (pH 3.0). At higher pH levels, the formation of iron-hydroxyl complexes inhibits the activation of persulfate, reducing the reaction rate.

Results: Optimization and Pathway Mapping

Under the optimized conditions of 1 mmol/L PS, a 1:10 Fe(II):PS ratio, and pH 3.0, the system achieved 78% IPM degradation within 60 minutes. The observed degradation rate constant ($k_{obs}$) reached 0.1266 $min^{−1}$, outperforming many existing treatment methods, including anaerobic processes and UV/chlorine systems.

Effect of varying persulfate (PS) concentrations on the degradation kinetics of IPM.

Crucially, the study monitored the fate of organic iodine, confirming its conversion into inorganic iodate ($IO_3^−$). This is a significant result, as iodate is a stable form that does not readily react to form toxic I-DBPs. Through DFT modeling, the researchers identified four primary degradation pathways involving deiodination, hydroxylation, deacetylation, and amine oxidation, leading to various transformation products.

Conclusion and Future Outlook

The Fe(II)/PS system offers a promising, kinetically superior approach for removing iopamidol from water. While the requirement for acidic conditions (pH 3.0) for peak efficiency presents a challenge for large-scale application in neutral water bodies, the system remains effective across a range of conditions. Future research should focus on evaluating the system's performance in complex real-world water matrices containing natural organic matter and competing ions, as well as assessing the toxicity of the identified intermediate transformation products.

Summary updated

Abstract

Iodinated contrast media (ICM), which was widely used in medical imaging and was difficult to remove by conventional wastewater treatment methods, attained much attention due to its potential environmental impacts. Herein, iopamidol (IPM), one typical compound of ICM, was found to be rapidly degraded by ferrous activated persulfate oxidation (Fe(II)/PS) as compared with PS or Fe(II) alone. With a persulfate concentration of 1 mmol L<sup>-1</sup>, n(Fe(II))/n(PS) of 1:10, and a pH of 3.0, 78% IPM was degraded within 60 min, with a degradation rate of 0.1266 min<sup>-1</sup>. It was demonstrated that IPM degradation and deiodination were favored by a high temperature, while affected positively by acidic and neutral conditions. Radical quenching experiments and Electron Paramagnetic Resonace (EPR) spectra showed that the combined effects of SO<sub>4</sub><sup>-</sup>· and ·OH contributed dominantly to degrade IPM, while the ·OH played an essential role during the degradation reaction. Through the Discrete Fourier Transform quantum chemical calculation, the possible reaction pathways for the oxidation of IPM by ·OH are as follows: IPM-TP651-TP667-TP541-TP557, IPM-TP651-TP525-TP557, IPM-TP705-TP631-TP661, and IPM-TP705-TP735. The obtained results showed that IPM could be degraded effectively by Fe(II)/PS system, giving a promising technique for IPM removal from water.
BibTeX
@inproceedings{dong2020fe,
  author = {Zijun Dong and Guanhan Chen and Mu Li and Feiyun Sun and Chengchun Jiang and Bandna Bharti},
  title = {{Fe(II)-activated persulfate oxidation to degrade iopamidol in water: parameters optimization and degradation paths}},
  booktitle = {Scientific},
  year = {2020},
  doi = {10.1038/s41598-020-78468-y},
}
Figure