This research, presented at AMAM 2017, introduces a novel mechanism for robotic feet that can rapidly switch between a soft, compliant state and a rigid, high-traction state using granular jamming. By leveraging mechanical intelligence, the design allows robots to adapt to uneven terrain without complex computational overhead.
The Challenge of Legged Locomotion
Legged robots face a fundamental trade-off in foot design. To handle uneven terrain effectively, a foot should ideally be soft during touchdown to dampen impact forces and conform to obstacles like rocks or debris. However, to move efficiently and push off the ground, the foot needs to be hard to transmit locomotive forces without energy loss through deformation.
While "granular jamming"—a process where vacuum pressure causes loose grains inside a membrane to lock together—has been used for robotic grippers, applying it to mobile robot feet has been difficult. Traditional vacuum pumps are often too slow or bulky for the rapid-fire requirements of a running robot's gait. This paper addresses the challenge of achieving high-speed state-switching in a compact, untethered format.
Experimental Methods and Hardware
The researchers developed a "simplified leg" setup to test a high-speed evacuation mechanism. The foot consists of a 2 cm diameter spherical latex membrane filled with compliant cubic granules.
Instead of a traditional pump, the system uses a 50ml glass syringe connected to the foot. A high-force magnetic solenoid (ITS-LZ 2560) pulls the syringe piston to a fixed end position almost instantaneously. This rapid mechanical displacement creates a vacuum of -180 mbar. An Arduino Nano monitors an internal pressure sensor; when the foot hits the ground, the resulting overpressure spike triggers the solenoid to "lock" the foot into its hardened state.
Testing was conducted by dropping the foot onto a treadmill with structured terrain (4mm grooves) mounted on a force plate. The researchers compared three configurations:
- OF: A standard rigid sensor.
- GMA: A foot that remains in a soft, non-jammed state.
- GMSS: The new state-switching foot.
Key Results and Performance
The experimental data demonstrated that the system could achieve the target vacuum in just 62.2 ± 3.6 ms. For a robot walking at a typical pace, this switch occupies only about 12% of the stance phase, making it viable for real-world locomotion.
As shown in the force profiles, the state-switching foot (GMSS) successfully combines the benefits of both soft and hard states:
- Impact Damping: Like the soft foot (GMA), the GMSS foot eliminated the "chatter" and rebound seen in rigid feet (OF), which often lose ground contact multiple times after the initial impact.
- Superior Traction: The GMSS foot produced a drag force nearly an order of magnitude higher than the rigid or soft feet immediately after touchdown. Because it hardens after conforming to the terrain, it effectively "hooks" into the surface features.
Discussion and Future Work
The use of a solenoid-driven syringe represents a clever mechanical solution for speed, offloading complex terrain adaptation from software to hardware. However, the current prototype has limitations. The solenoid only pulls the vacuum and does not push the piston back to reset the foot to a soft state; a manual valve was used for resets in this study.
Future work will focus on integrating this mechanism into a full quadruped robot, such as the "Oncilla" platform, to evaluate its impact on overall stability and speed in autonomous environments. Additionally, the long-term durability of the latex membrane and glass syringe under high-cycle stresses remains to be investigated.
Summary updated