Abstract
Topological insulators and semimetals have been shown to possess intriguing thermoelectric properties promising for energy harvesting and cooling applications. However, thermoelectric transport associated with the Fermi arc topological surface states on topological Dirac semimetals remains less explored. In this work, we systematically examine thermoelectric transport in a series of topological Dirac semimetal $Cd_3As_2$ thin films grown by molecular beam epitaxy. Surprisingly, we find significantly enhanced Seebeck effect and anomalous Nernst effect at cryogenic temperatures when the $Cd_3As_2$ layer is thin. Combining angle-dependent quantum oscillation analysis, magnetothermoelectric measurement, transport modelling and first-principles simulation, we isolate the contributions from bulk and surface conducting channels and attribute the unusual thermoeletric properties to the topological surface states. Our analysis showcases the rich thermoelectric transport physics in quantum-confined topological Dirac semimetal thin films and suggests new routes to achieving high thermoelectric performance at cryogenic temperatures.
Introduction
Thermoelectric materials, which convert temperature gradients directly into electrical voltage, are essential for solid-state cooling and waste-heat recovery. Traditionally, high-performance thermoelectrics require a finite bandgap to optimize the Seebeck coefficient ($S$), a measure of the induced voltage per unit of temperature. Topological Dirac semimetals (TDSMs) like $Cd_3As_2$ have emerged as candidates for next-generation electronics due to their ultra-high carrier mobility. However, their gapless bulk electronic structure typically results in mediocre thermoelectric performance, as the contributions from electrons and holes often cancel each other out.
Beyond their bulk properties, TDSMs host unique "Fermi arc" surface states. Theory suggests these states could possess exotic transport properties, but experimentally isolating their contribution is difficult because the bulk signal usually overwhelms the surface signal. This study demonstrates that by thinning $Cd_3As_2$ films to the quantum-confinement regime, the bulk states can be suppressed, allowing the topological surface states to dominate and reveal extraordinary thermoelectric capabilities.
Experimental Methodology
To investigate the transition from bulk-dominated to surface-dominated transport, the researchers synthesized high-quality (112)-oriented $Cd_3As_2$ thin films on GaAs substrates using Molecular Beam Epitaxy (MBE). Three specific thicknesses were targeted to represent different transport regimes:
- 950 nm: Representing the bulk limit.
- 95 nm: A transitional regime.
- 25 nm: The quantum-confined regime where bulk states are expected to be "gapped out."
The team utilized angle-dependent Shubnikov-de Haas (SdH) quantum oscillations in magnetic fields up to 9 T at 2 K to map the Fermi surface. This technique is critical for distinguishing between 3D bulk states and 2D surface states. Additionally, magnetothermoelectric transport measurements (Seebeck and Nernst coefficients) were conducted from 2 K to 300 K. These experimental results were supported by first-principles Density Functional Theory (DFT) calculations using VASP and BoltzTraP2 to model the electronic structure and transport properties.
Results and Discussion
Quantum Confinement and Surface State Isolation
The study's most significant finding is the successful isolation of topological surface states in the 25 nm film. In the 950 nm sample, quantum oscillations revealed a 3D "peanut-shaped" Fermi surface characteristic of bulk $Cd_3As_2$. However, the 25 nm sample exhibited a high-frequency oscillation (55 T) that vanished when the magnetic field was rotated parallel to the film (90°). This angular dependence is a definitive signature of 2D surface transport.
Quantum confinement effectively acts as a filter. In the thinnest films, the confinement opens a gap in the bulk states, silencing the n-type bulk carriers. This allows the p-type topological surface states (Fermi arcs) to become the primary conduction channel.
Enhanced Thermoelectric Response
The isolation of these surface states led to a dramatic boost in thermoelectric performance at cryogenic temperatures:
- Seebeck Coefficient: The 25 nm sample showed a positive Seebeck coefficient across the entire temperature range, confirming p-type dominance. It reached a peak of nearly 500 $\mu$V/K at 5 K, a massive increase compared to the 50–150 $\mu$V/K typically seen in bulk $Cd_3As_2$.
- Anomalous Nernst Effect: The Nernst coefficient ($S_{xy}$) in the 25 nm film was an order of magnitude larger than in bulk samples. Below 40 K, the experimental Nernst values deviated sharply from semiclassical models. This divergence suggests a significant contribution from Berry curvature, a topological property of the electron wavefunctions associated with the Fermi arcs.
Despite being surface-confined, the carriers in the 25 nm film maintained high mobility, which is a prerequisite for efficient thermoelectric applications.
Conclusion
This research demonstrates that quantum confinement is a powerful tool for unlocking the hidden potential of topological materials. By suppressing bulk interference in $Cd_3As_2$, the authors revealed that topological surface states can drive thermoelectric performance far beyond bulk limits, particularly in the cryogenic regime.
While these effects are currently most pronounced below 50 K, the study provides a roadmap for future optimization. Potential directions include using electrostatic gating or chemical doping to tune the Fermi level of the surface states, potentially extending these high-performance characteristics to higher temperatures and paving the way for new topological thermoelectric devices.
Summary updated