Enhancement in the Sensing Efficacy of ZnO-based Ethanol Sensor: Fe-ZnO Film

Dhirendra K. Chaudhary, S. K. Joshi, Sunil Thapa, Yang Yue, Peixuan ZhuJournal of Nano- and Electronic Physics 2024 · DOI

TL;DR

This paper presents a cost-effective method for enhancing ethanol gas sensing performance using iron-doped zinc oxide (Fe-ZnO) thin films prepared via spin-coating. The Fe-ZnO films demonstrate significantly improved sensitivity and faster response/recovery times compared to pure ZnO films, making them promising for practical, economical gas sensor applications.

What Problem Does This Paper Address?

Ethanol, a widely used alcohol, poses significant health and safety risks, necessitating reliable detection methods. While metal oxide semiconductor (MOS) gas sensors, particularly those based on zinc oxide (ZnO), are promising due to their non-toxic nature and stability, they often suffer from low response at lower temperatures, leading to increased power consumption. Furthermore, achieving optimal sensing performance requires precise control over film morphology and properties, which can be challenging with complex synthesis methods. This paper addresses the need for a more efficient and cost-effective approach to enhance the ethanol sensing capabilities of ZnO, specifically by exploring the impact of iron doping and a simple fabrication technique.

Methods

The researchers employed a spin-coating technique to deposit both pure ZnO and 5% Fe-doped ZnO (Fe-ZnO) thin films onto glass substrates. This method was chosen for its simplicity, cost-effectiveness, and ability to provide good control over film uniformity and thickness.

Key characterization techniques included:

  • X-ray Diffraction (XRD): To analyze the crystalline structure, crystallite size, and phase purity of the films.
  • UV-Vis Spectroscopy (Tauc plot): To determine the optical band gap of the films.
  • Scanning Electron Microscopy (SEM): To visualize the surface morphology and grain sizes.
  • Energy-Dispersive X-ray Spectroscopy (EDX): To confirm the elemental composition and the successful incorporation of iron into the ZnO lattice.
  • Gas Sensing Setup: A custom-built airtight borosilicate glass chamber equipped with a hot plate, digital temperature controller, and a Ni-Cr micro-heater was used to test the gas sensing performance. The resistance of the films was measured using a multimeter.

The gas sensing performance was evaluated by measuring the gas response (R = Ra/Rg), where Ra is the resistance in air and Rg is the resistance in the presence of ethanol vapor. Response and recovery times were also meticulously recorded.

Datasets

Not discussed in the paper. The study relies on experimental measurements rather than pre-existing datasets.

Key Insights and Ideas

  • Fe-doping enhances sensitivity: The introduction of iron into the ZnO lattice significantly boosts the sensor's response to ethanol vapor. This is attributed to the combined effects of reduced grain size and increased oxygen vacancies.
  • Smaller grains, bigger response: The Fe-ZnO films exhibited smaller crystallite and grain sizes compared to pure ZnO. This increased surface area provides more active sites for gas adsorption and reaction, leading to a higher gas response.
  • Optimized operating temperature: Both ZnO and Fe-ZnO sensors showed a peak response at around 260 °C. This operating temperature is crucial for balancing reaction kinetics and oxygen ion adsorption/desorption.
  • Faster kinetics: Fe-doping not only increased sensitivity but also dramatically improved the response and recovery times, making the sensor more practical for real-time monitoring.
  • Cost-effective fabrication: The spin-coating method offers a simple, economical, and scalable approach to producing high-quality Fe-ZnO films, making advanced gas sensing technology more accessible.

Key Results

  • Crystallite Size: Decreased from 25.69 ± 0.95 nm for ZnO to 19.49 ± 0.72 nm for Fe-ZnO.
  • Band Gap: Increased slightly from 3.190 ± 0.105 eV for ZnO to 3.244 ± 0.147 eV for Fe-ZnO.
  • Maximum Gas Response: The Fe-ZnO film achieved a significantly higher response of 17.8 ± 0.4 at 260 °C for 400 ppm ethanol, compared to 12.5 ± 0.3 for pure ZnO. This represents an improvement of approximately 1.5 times.
  • Response and Recovery Times (for 40 ppm ethanol): Fe-ZnO showed faster times of 32 ± 2 s (response) and 162 ± 3 s (recovery), compared to ZnO's 61 ± 3 s (response) and 283 ± 3 s (recovery).
  • Stability: The sensors demonstrated good repeatability over multiple cycles and maintained consistent responses over a 10-day testing period.

Limitations and Future Work

Limitations: * The study focused on a specific doping concentration (5% Fe). Further optimization of doping levels could potentially yield even better results. * While the spin-coating method is cost-effective, achieving extremely precise thickness control across large areas might still present challenges. * The study primarily focused on ethanol. Testing with other interfering gases would be beneficial for a comprehensive understanding of selectivity.

Future Work: The authors suggest that Fe-doping into ZnO is a promising avenue for developing cost-effective and efficient gas sensors for low-concentration ethanol detection. Future research could explore different doping concentrations, co-doping strategies, and alternative deposition techniques to further refine sensor performance and expand their application range. Investigating the long-term stability and selectivity in complex environments would also be valuable.

Summary updated

Abstract

Journal of Nano- and Electronic Physics. Scientific journal. ISSN: 2077-6772. Journal abbreviation: J. Nano- Electron. Phys. No page charges. All articles are freely available on-line. Issued 4 times per year. Publisher: Sumy State University. (Sumy, Ukraine)
BibTeX
@article{chaudhary2024enhancement,
  author = {Dhirendra K. Chaudhary and S. K. Joshi and Sunil Thapa and Yang Yue and Peixuan Zhu},
  title = {{Enhancement in the Sensing Efficacy of ZnO-based Ethanol Sensor: Fe-ZnO Film}},
  journal = {Journal of Nano- and Electronic Physics},
  year = {2024},
  doi = {10.21272/jnep.16(2).02011},
}
Figure